Answered: Calculate the maximum temperature…

Calculate the maximum temperature allowed for the silicon if the intrinsic carrier concentration is 1×1012 electrons/m. 300 K 360 K 364 K 382 K

Understanding Motor Controls

4th Edition

ISBN:9781337798686

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter44: Semiconductors

Section: Chapter Questions

Problem 2RQ: The atoms of a material used as an insulator generally contain ___________ valence electrons.

See similar textbooks

Related questions

Q: Consider compensated n-type silicon at T = 300 K, with a conductivity of o = 16 (N-cm) and an…

Q: Define the following terms (1). Unit cell (2). Lattice parameters (3). Linear density (4). Planer…

A: We are suppose to solve only 3 subparts. Please post other parts as a separate question.

Q: -+y /3 1/3 1/2 1/2 113 2/3 2/13

Q: what is the delta H of 40 g of silver dropping from 300 K to 270 K? c = 0.25

A: The mass of silver is m=40 g=40 g×kg1000 g=0.04 kg. The initial temperature of silver is T1=300 K.…

Q: be 4.0E+20 m³. The electron and hole mobilities for this material are 0.38 and 0.18 m2/V-s,…

Q: The band gap in silicon is 1.12 eV. Calculate the maximum wavelength of electromagnetic radiation…

A: Given data: *The band gap of the silicon is E=1.12 eV. *The speed of the electromagnetic wave is…

Q: 8. An electron has a rest mass of 9.11×10^(-28) g. What is the energy contained in the electron…

A: Mass of electron = m= 9.11 X 10-28 g = 9.11 X 10-31 Kg Light speed = V = 3 X 108 m/s

Q: The following diagram (Attached) is band diagram of a CIS/CdS solar cell. Looking at the band…

Q: A piezoelectric material has a Young’s modulus of 72000 MPa. What stress is required to change its…

A: Given data: The young's modulus of the material is E=72000 MPa The initial polarization is x1=640…

Q: Obtain the Miller indices for the following directions A and B shown below: +z A +y 1 +x A)…

A: → For direction A : Head Point : 12,0,1 Tail Point : 1,12,0→ direction of A := Head…

Q: At room temperature (20°C) the electrical conductivity of Gallium phosphide (GaP) is 63 (Q.m)–1,…

A: Electrical conductivity σ=63 Ω.m-1μe=.24 m2V-sμh=.057 m2V-sq=1.6×10-19 CaCalculate intrinsic…

Q: . A. The term linear atomic density is derived for FCC [111]. [100] The vectors in terms of radius B…

A: In FCC cell 1/2 part atom is present at each face and 1/8 part atom is present at each corner.…

Q: Calcium (Ca) has the FCC crystal structure. The atomic radius is R = 0.197 nm and the %3D atomic…

Q: Calculate mass contained in red light of wavelength 7×10 'm which hits an electron at rest the…

A: Here, effective mass=hνλ Therefore, Effective mass of light=hνλ=6.626*10-343*108*7*10-7=3.14*10-38…

Q: - what is Crystalline? and why study the structure of crystalline solids? - metals are having good…

A: Metals are having good electrical conductivity because metal has excess electrons which are freely…

Q: Undoped PbS is an n-type semiconductor and crystallizes in the NaCl structure. The predominant…

A: Given data Material : Undoped PbS n-type semiconductor Predominant defect : Frenkel defect pairs on…

Q: Consider a system of nonrelativistic electrons in a white dwarf star at a temperature of 10^9 K.…

A: Write the formula for the density of a non-relativistic electron in a degenerate system.…

Q: 142) What property does a bonded material with an electron cloud not exhibit? a) Conductivity b)…

A: As per given question we have defind the solution above question

Q: The dependency between electron density and fermi energy (E) for a 2-D free electron gas is,

A: We know that, the expression of Fermi energy EF=h2KF22m here, EF is the Fermi energy m is the mass…

Q: 7. Calculate the linear density of atoms along the [111] direction and the planar density of atoms…

Q: In the aluminium-silicon binary diagram, value for degree of freedom at the eutectic point is 1 2 3…

A: Eutectic point in the phase diagram is the temperature at which liquid is transformed into the two…

Q: Silver (Ag) has the FCC crystal structure. The atomic radius is R = 0.144 nm and the atomic mass is…

A: Given: The atomic radius is r=0.144 nm. The atomic mass is M=107.87 g/mol. The value for Avogadro…

Q: 9. Figure shows the first five peaks of the x-ray diffraction pattern for tungsten, which has a BCC…

A: Solution a). Since tungsten (W) has a BCC crystal structure , only those peaks for which h + k + l…

Q: When some ionic compounds dissolve, like polyatomic sodium nitrate, not all of their bonds…

A: When some ionic compounds dissolve, like polyatomic sodium nitrate, not all of their bonds…

Q: Explain the following, related to physical insight to internal energy (iv) Internal energy (v) spin…

Q: The collision time of an electron with a phonon is 7^10 s and the probability of collision with a…

Q: An optical fiber for telecommunication is made of SiO2 glass with a density of 3.2 (g/cm³). Given a…

Q: A material science technique used in material science is X-ray diffraction analysis (XRD) to…

Q: Chromium (Cr) has the Body-Centered Cubic (BCC) crystal structure. The edge length is a = 0.288 nm.…

A: The linear density is given as : LD=no. of atoms centered on 1 1 1 direction vector length of 1 1 1…

Q: Calculate the linear density of an FCC along (1 1 0) and the theoretical density. 1. Aluminum…

Q: Calcium (Ca) has the FCC crystal structure. The atomic radius is R = 0.197 nm and the atomic mass is…

A: R=0.197 nm M=40.08 g/mol

Q: How many nanostructured dimensions does a C nanotube have? Does a C nanotube with its…

A: Carbon nanotubes (CNT) consists of a single sheet of graphite rolled into a shape of tube. It has…

Q: Consider an fcc lattice with cube side length 1.2 Å. What are the planar densities of the (110) and…

Q: A typical energy of electrons in a modern transition electron microscope is 300 keV. Calculate the…

A: Electron microscopes use electrons to illuminate a sample. In Transmission Electron Microscopy…

Q: Diffsuion process is faster for____ A) Covalently bonded materials B) High density materials

A: Solution: Note: Dear Student! As per our guidelines, we are only allowed to answer a single…

Q: 2. What is the principle of RAMAN spectroscopy. Why is RAMAN spectroscopy considered a complement to…

A: Raman Spectroscopy is one of the non-destructive chemical analysis technique to know a detailed…

Q: 5. For the adsorption of monoatomic species X, provide the surface unit cell dimensions on the FCC…

A: Given For the adsorption of monoatomic species X, provide the surface unit cell dimensions on the…

Q: The photon wavelength nečessary to promote an electron to the conduction band in intrinsic silicon…

Q: 10.) What kind of conductivity occurs when a bismuth (Bi) atom is added as a substitutional impurity…

A: Bismuth belongs to 15group element which has p type impurity so the substitutional impurity to…

Q: 45 Nm |15 N 300 m 300 mm 15 N A 200 mm В 300 mm B.

A: Write the coordinates of the point, B≡300,600,0B≡200,300,0 Calculate the position vector,…

Concept explainers

Crystalline Imperfections

The crystalline imperfections are described as the geometrical defects in the crystal due to incorrect arrangement of atoms, impurity, vacancy, and many more. It is not possible to achieve a perfect or ideal crystal, practically.

Question

Calculate the maximum temperature allowed for the silicon if the intrinsic
carrier concentration is 1×1012 electrons/m.
О з00 к
360 K
O 364 K
O 382 K

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

At room temperature (20°C) the electrical conductivity of Gallium phosphide (GaP) is 63 (2.m)–1, whereas the electron and hole mobility are 0.24 and 0.057 m²/V-s, respectively. a) Compute the intrinsic carrier concentration for GaP at room temperature, (q=1.6 x 10 -19 c). b) If the energy gap of GaP is 0.92 eV, calculate its conductivity at 70°C (k= 8.62 x 10 eV/K). -5
The atoms of a material used as an insulator generally contain ___________ valence electrons.
3. Suppose that these atomic configurations belong to Al at 30 °C, Select the correct answer about electrical resistivity? (1) (2) (3) Perfect Crystal terst impurity t Low defects No defects High defects
(a) how much time is needed to measure the kinetic energy of an electron whose speed is 10 metre per second with an uncertainty of and no more than 0.1 percent. How far will the electron have travel in this period of time. (b) make the same calculation for a one gram insect whose speed is the same what do the set of figure indicate?
A piezo electric crystal having a thickness of 2.45mm and a voltage sensitivity of 0.018Vm/N is subjected to pressure of 20 * 10^3 Pa. what is the output voltage?
A 4.0-nm-diameter protein is in a 0.050 M KCl solution at 25° C. The protein has 9 positive and 20 negative charges. Model the protein as a sphere with a uniform surface charge density. Part A What is the electric potential of the protein at the surface? Express your answer with the appropriate units. μA ? Vsurface = Value Units Submit Request Answer Part B What is the electric potential of the protein 2.0 nm from the surface? Express your answer with the appropriate units. με V2 nm = Value Units Submit Request Answer
How many nanostructured dimensions does a C nanotube have? Does a C nanotube with its nanostructured dimensions always have the same properties? If not, explain what the electrical conductivity properties in a nanotube depend on?
Q6: Determine the Miller Indices for directions (Three only) and plane following: Nijm N/m B -fre 47 of the
b/ Calculate the kinetics of the copper electron and the kinetics of the silver electron, given that their specific resistance is 1.8×10-³ ohm m and 1.6×10-³ ohm m respectively, and their mass densities 8.93×10³ kg/m³ and 10.49 kg/m³ The atomic weight of copper is 63.54 and silver is 107.9.
The accepted resistivity value at room temperature for copper wire is 1.7421 x 10-8 ohm meter. please explain why or why not the measurements recorded are within some percent error of thius value. calculate resistivity and show the percent error. Use R=p L/A Using the formula calculate p
4. Square lattice. Consider a square lattice in two dimensions with the crystal potential U(x, y) = -4U cos(27x/a) cos(2ny/a). Apply the central equation to find approximately the energy gap at the corner point (π/а,л/a) of the Brillouin zone. It will suffice to solve a 2x2 determinantal equation.
Solve the following problem * Convert the [100] and [111] directions into the four-index Miller-Bravais scheme for hexag- onal unit cells.