Calculate the partial pressure in atm of each gas in a mixture of gases. In a tank containing 16.00 grams of carbon dioxide, 26.50 g of nitrogen gas, and 8.00 grams oxygen gas for a total pressure of 80.0 kPa. Conversion:   1 atm = 101.325 kPa; MW(CO2) = 44.01 g/mol;MW(N2) = 28.0 g/mol; and  MW(O2) = 32.0 g/mol.                    The pCO2, pN2, and pO2 in atm are .........., ............, and .............., respectively in 3 sig. figures.

Q: A mixture of ideal gases consists of 3 kg of nitrogen and 5 kg of carbon dioxide at a pressure of 3…

A: For the calculation of partial pressure, the mole fraction of both nitrogen and carbon dioxide…

Q: 1A4 The molar mas of a newly synthestred fluorucarbon was meanured in a gas microbalance. This…

A: According to Ideal gas Law: PV=nRT where, P= pressure of gas,  V= volume of gas R=universal gas…

Q: To evaluate the use of renewable resources, an experiment was carried out with rice hulls. After…

A: The volume of air were supplied per cubic foot of entering gas is to be calculated The volumes of…

Q: What is the Molecular weight of a certain volatile liquid which is placed in 225 g flask which has…

A:

Q: The chlorination of methane occurs in a number of steps that results in the formation of…

A: The volume of methane gas is 201 mL which is equivalent to 0.201 L and the volume of chlorine gas is…

Q: Q3-A stream of humid air enters a condenser in which 95% of the water vapor in the air is condensed…

A:

Q: Carbon dioxide in high levels can cause death. One method of removing carbon dioxide from the air of…

A: Since you have asked multiple question, we will solve the first question for you.If you want any…

Q: Most anesthetic 'gases' are volatile liquids and therefore must be vaporized in order to be…

A: 1. In physical chemistry,  volume percentage is used for the calculation of concentration of…

Q: A 0.645 g sample of cobalt, Co, is added to 239 mL of 0.100 M H,SO, to produce cobalt(II) sulfate…

A: Answer - Here I have explained the step by step solution . Hope this will really gonna help you…

Q: 20. A mixture consisting of 6 kg of O, and 9 kg of N, has a pressure of 3 bar and temperature of…

A: Since we only answer up to three sub parts, we'll answer the first three. Please resubmit the…

Q: 350 mL of At gas at 1.2 atm and 675 mL of Co2 gas at 850mm of Hg are mixed into a tank of capacity…

A: Applying Doltons rule of partial pressure PV= P1V1+P2V2+.......

Q: Prove that the Cv of an ideal gas does not depend upon specific volume by showing that: ( SCv/…

A:

Q: Gypsum (plaster of Paris : CaSO,. 2H,0) is produced by the reaction of calcium carbonate and…

A: Gypsum is prepared by the reaction between calcium carbonate and sulfuric acid. CaCO3 + H2SO4…

Q: • Two methanol-water mixtures are contained in separate flasks. The first mixture contains 40 wt%…

A:

Q: The label has come off a cylinder of gas in your laboratory. You know only that one species of gas…

A: Given: Volume of gas is 5 liter. Gauge pressure is 1.00 atm. Mass of gas is 13.0 g. Temperature is…

Q: Calculate the mole faction and partial pressure of each gas and the total pressure in the tank round…

A: First, the moles of carbon monoxide gas and carbon dioxide gas are determined by using given mass…

Q: The molar mass of a newly synthesized fluorocarbon was measured in a gas microbalance. This device…

A:

Q: What is the partial pressure of CO₂ at 468.2 K in a 25.0 L fuel combustion vessel if it contains…

A: According to ideal gas law, PV = nRT where P = pressure of gas in atm  V = volume of vessel in L n =…

Q: Judge each of the statements below as T (true) or F (false). The onë (S) that are false, justify the…

A: Since you've posted multiple sub-parts, we'll solve only the first three sub-parts for you. To get…

Q: The composition of Liquefied Petroleum Gas(LPG) is 0.5% ethane, 0.1 % acetylene, 16.4% propane, 2.1%…

A:

Q: • An Ideal gas with R=25.9 lb-ft/lb-R and k=1.1 is heated at constant volume. What is the a.) Cp and…

A:

Q: Urea (H2NCONH2) is used extensively as a nitrogen source in fertilizers. It is produced commercially…

A: The reaction for the above process is given below. 2NH3(g)     +    CO2(g)        →∆…

Q: Ethanol vapours were allowed to completely fill a jug with a volume of 18.9L. The ethanol was burned…

A:

Q: 3H2(g)+ Nz(g)t>2NH3/9) +Heat (十++ i. owhat is the Keqifthe coscentration atequilibr'm are (H2] =1.01…

A: By the help of stoichiometric coefficient we can find the amount of unknown substance by the help of…

Q: Q3/ The ideal gas equation of states is given by: PV=nRT Where: P is the pressure, V is the volume,…

A:

Q: Calculate u of 1 mole of helium gas at the top of a mountain (7000 m) under the assumption that the…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Nitric acid is a key industrial chemical, largely used to make fertilizers and explosives. The first…

A: Given that

Q: Treat CO2 as an ideal gas and compute q, w, DH, and DU for its inhalation at a constant 1 bar…

A: Solution -

Q: Which plot below best represents the relationship between volume (V) and number of mol (n) of an…

A: Pressure of gas depends on the number of mole of the gas

Q: What volume is occupied by 0.250 grams of O2 measured at 25.0oC and 100.66 kPa?

A: Given P=100.66 Kpa = 100.66 * 0.00987 atm 1 Kpa = 0.00987 atm n = mass of O2/molar mass of O2 T=…

Q: A rigid vessel contains 0.01 kmol of O2 and 0.01 kmol of CO at 0.1 MPa and 25°C. The mixture is…

A: When CO reacts with O2 , the following reacts occurs: 2CO + O2     →    2CO2Using gas law, PV=…

Q: Nitric acid is a key industrial chemical, largely used to make fertilizers and explosives. The first…

A: Given, Dioxygen consumption rate = 150 ltrs Temperature , T = 195°C =(195+273)K=468 K Pressure, P =…

Q: An ideal gas confined to a container with a massless piston at the top. A massless wire is attacted…

A: Isobaric process is the thermodynamic process which occur at the constant pressure.  The expression…

Q: In the combustion of butane at 105 kPa and 292 K  2C4H10(g) + 13O2(g) --> 10H2O(g) + 8CO2(g) What…

A: Given: Pressure of butane is 105 kPa Temperature is 292 K Mass of oxygen is 350 g Volume of butane…

Q: the volumetric flow ate 2. the mass flow rate 3. the partial pressure of each component/including…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: C6H1206(aq) 2C,H,OH(aq) + 2CO,(9) is not 100% efficient and produces many by products. The reaction…

A: Given dataMass of glucose=3.604KgMolar mass of…

Q: In the lungs, the respiratory membrane separates tiny sacs of air (absolute pressure=1.00x105 Pa)…

A: The effect of pressure and temperature is measured by Boyle’s law and Charles's law respectively.…

Q: A commercial 737 jet transporting 143 passengers and 5 crew members from Kansas city (MCI) to…

A:

Q: When zinc reacts with hydrochloric acid, zinc chloride and hydrogen gas are formed. After writing a…

A:

Q: One type of gas mixture used in anesthesiology is a 50%/50% mixture (by volume) of nitrous oxide…

A: Answer

Q: Peter takes out a cup of coke from a 4 °C refrigerator and puts it under 1 atm at 25°C in an open…

A: This can be understood roughly by Le Chareliars principles. The given system is at 4°C and put qt…

Q: Underwater, the pressure increases by 1 bar for every 10 m of depth. When a scuba diver breathes…

A: Given : Increase in pressure for every 10 m depth = 1 bar. Total depth = 85 m And the partial…

Q: Is it necessary to know [E]T to determine (a) KM, (b) Vmax, or (c) kcat?

A: Km is the substrate concentration at which half maximum velocity is obtained. Vmax is the maximum…

Q: For each of the following questions, refer to the following balanced equation and the Data Table…

A: Chemical equation, 2HgO(s) => 2 Hg(l) + O2 (g)

Q: Most anesthetic 'gases' are volatile liquids and therefore must be vaporized in order to be…

A: Given: Mass of halothane = 39.4 g. Moles of halothane = 0.200 mol. Volume of container = 224 L And…

Q: In your combustion of butane at 105 kPa and 292 K   2 C4H10 (g) + 13O2 (g) ---> 10 H2O (g) + 8CO2…

A:

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.