Answered: Certain criteria must be satisfied if a…

Certain criteria must be satisfied if a measurement or observation is to be believed. Will the criteria necessarily be as strict for an expected result as for an unexpected result?

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter1: Introduction And Vectors

Section: Chapter Questions

Problem 25P: A sidewalk is to be constructed around a swimming pool that measures (10.0 0.1) m by (17.0 0.1) m....

See similar textbooks

Related questions

Q: The area of a round tabletop is computed from a measurement of its radius. If the fractional…

A: A= πr2

Q: Which of the following equations are dimensiona consistent?

A: Given:- A. v =at B. v = 12at2C. t = avD. v2= 2ax v is the speed, t is time, and a is acceleration.…

Q: average number and the variance number (A)²

Q: You measure a certain flow rate to be Q=12.9±1.6cm3/min. What would be the uncertainty in the…

A: The given value of flow rate is, For a logarithmic value (base 10), the absolute uncertainty can be…

Q: Determine the percent uncertainty in 0, and in sin 0, when (a) 0 = 15.0° ± 0.5°, (b) 0 = 75.0° ±…

A: (a) Percentage uncertainty in θ

Q: Suppose your speedometer has an uncertainty of 4.5 km/h at a speed of 92 km/h. what is the percent…

A: An uncertainty speed of speedometer, u'=4.5 km/h The original speed, u=92 km/h

Q: P (t) = PmaxCos (Bt) If t is measured in seconds, what value should the quantity B have? B = If t is…

A: The value of quantity B.given,P(t)=Pmaxcos(Bt)frequency(f)=349 Hz

Q: In a Measurement ,the Expected value is 56 V and the measured value is 52 V. Find (i) Absolute error…

A: Given Expected value. Is 56 Measured value is 52.

Q: It says that it's not the appropriate number of sig figs.

Q: our car speedometer has an uncertainty of 4.8 km/h at a speed of 95 km/h. What is the percent…

A: speed of car= 95 km/hr Uncertainity = 4.8 km/hr

Q: Rank these SI distance units from smallest to largest: μm, am, fm, nm, mm, cm, m, km, Gm, Tm, Mm,…

A: Rank these SI distance units from smallest to largest: μm, am, fm, nm, mm, cm, m, km, Gm, Tm, Mm,…

Q: A good-quality measuring tape can be off by 0.50 cm over a distance of 20 m. What is its percent…

Q: By measuring the acceleration due to gravity a student finds gA=(9.85+-0.08)m/s^2. A student B finds…

A: Note: You have posted a question with more than three subparts. As per our policy, if nothing is…

Q: The rate of U.S. per capita sales of bottled water for the period 2000-2010 can be approximated by…

A: s(t) = -0.18t2 + 3t + 15 gallons per yearf(t) = 0.2 + 0.04trate of consumption = s(t) * f(t)=-0.18t2…

Q: Our classroom was kept at 25.0°C during your experiment, so v is predicted to be 343 m/s. What is…

A: Given data : Speed of sound in air ; Expected…

Q: What are some basic staff to get into physics?

A: First of all you have to deep interest in science, technology, experiment etc 2) you have to…

Q: Determine the maximum absolute error in the density, ρ, with a calculated value of 988 kg/m3, given…

A: Density , ρ=mV Calculated value of density = 988 kg/m3 relative error in mass ,∆m/m=±0.005 relative…

Q: The reaction time of a student as determined by her teammates in the laboratory are as follows: a.…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: The error in two readings of A are 0.01 and -0.03, then mean absolute error is ?

A: The error in two readings of A are 0.01 and -0.03 First, the absolute value of the errors is taken…

Q: For the measurement of length: 1km 50m and expected value of 1100m, find the relative error.

Q: Imagine an experiment where you measure the width, length and height of a box, in centimeters.…

A: width of box (w) = 13 cm Length of box (L) = 29 cm Height of box (H) = 9 cm σw = 0.2 cm σL = 0.1…

Q: Calculate the following with the correct number of sig figs. 1.5.00 + 2.1

A: Significant figures are the number of digits that contribute to the accuracy of a measurement. While…

Q: Given that P = Find the maximum percentage error in calculating P if the percentage error in…

Q: If you are to measure the length, width and height of your bedroom, what measuring device will you…

A: A typical bedroom has dimension which fall in the meter range. Therefore to properly measure a…

Q: When a measuring scale is used properly to the limit of preci- sion, the last significant digit…

A: When the measuring scale is used to the limit of precision then the last significant digit is…

Q: why is the final answer positive and not negative instead

A: Final answer is representing only magnitude of the electric field (because it's not a vector…

Q: The "dimension" is the measurable quantity that the unit represents. O True False

A: The Dimension is the measurable quantity that the unit represents. Above statement is True because…

Q: In a Measurement ,the Expected value is 72 V and the measured value is 63 V. Find (i) Absolute error…

A: (i) The absolute error is given by : (ii) The relative error is given by :

Q: Function f is defined by = x/ where x = 4.35 + 0.05 and y = 1.25 +0.01 Calculate the absolute…

A: Given that value of x and y and also given the function f then we have to calculate the absolute…

Q: A person measures his or her heart rate by counting the number of beats in 30s. If 40+1 beats are…

A: Given the number of beats is 40. And the uncertainty with beats is 1. The time is defined as 30 s,…

Q: Given a set of length measurements: 62.1, 62.5, 61.7, 62.6, 62.7, 61.9 cm. Find the standard error…

A: The formula for Standard Deviation: Standard Deviation, σ=∑i=1n(xi-x)2(n-1)where: xi = Value of…

Q: From the acquired measurements in Table A,plot Q as a function of V

A: Note:- We know that here you asked to plot the Q as a function of V. So We are only giving the…

Q: A quadrilateral shaped area given by the following measurements have these corresponding probable…

A: Perimeter is sum of all four sides. In summation , error is sum of numerical value of all errors.…

Q: A good-quality measuring tape can be off by 0.50 cm overa distance of 20 m. What is its percent…

Q: A good-quality measuring tape can be off by 0.58 cm over a distance of 23 m. What is its percent…

A: a measuring tape can be off by 0.58 cm = (0.58 / 100) m Here, 100 cm = 1m and 1 cm = (1/100) m Total…

Q: Explain how Physics-related problems are translated from one-dimensional to three-dimensional.

A: Given : How physics related problems are translated form 1D to 3D ?

Q: A student wants to calculate the value of Newton's constant G using the following relation: GM R…

A: Consider the given relation. Rearrange the equation for G.

Q: Use dimensional analysis to determine which of the following equation is certainly wrong: mv v=…

Q: Determine which of the numbers below is a possible order of magnitude estimate of the quantity…

Q: A parameter x is measured with a relative uncertainty of 4 percent. If x=19.0, what is the absolute…

A: Given data:

Q: 128. Compute the relative error and absolute error when measuring the area of a rectangle of length,…

A: As per guidelines, only first , Q.138 is solved her. L = (10±0.2)m W = 6±0.1m We know that area =…

Q: Estimating Errors for Multiple MeaSurements of a Physical Quantity Using variance Distance (M)…

A: Actual value of a physical quantity x = x1 + x2 + •••••+xn /n

Q: The table shows the set of five measurements recorded in a laboratory. The precision of 3rd…

A: Precision tells us to what resolution or limit, the quantity is measured by a measuring instrument…

Q: For the measurement of length: 1km ± 50m and expected value of 1100m, find the relative uncertainty.

A: Given, measurement of length, l=1km ±50 m expected value =1100km

Q: How do you estimate the error of a measurement performed with a meterstick? Why?

A: An error made by using the equation of a regression line to estimate the values of the dependent…

Q: How should the computed result be reported, to the proper number of significant figures, for the…

A: Solve the given set of mathematical operations.

Concept explainers

Half Life

The concept of Half Life has numerous practical applications some of them includes figuring out the effective drug dosage to finding out when a radioactive becomes safe to use. If you look for a career in Nuclear Physics you will need this concept.

Question

Certain criteria must be satisfied if a measurement or observation is to be believed. Will the criteria necessarily be as strict for an expected result as for an unexpected result?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Roughly how many heartbeats are there in a lifetime?
(a) If your speedometer has an uncertainty of 2.0 km/h at a speed of 90 km/h, what is the percent uncertainty? (b) If it has the same percent uncertainty when it reads 60 km/h, what is the range of speeds you could be going?
(a) A car speedometer has a 5% uncertainty. What is the range of possible speeds when it reads 90 km/h? (b) Convert this range to miles per hour. Note 1 km = 0.6214 mi.
What is the percent uncertainty in the area of a circle whose radius is 1.8 × 104 cm?
An object is released from rest and falls in free fall motion. The speed v of the object after it has fallen a distance y is given by v 2gy. In an experiment, v and y are measured and the measured values are used to calculate g. If the percent uncertainty in the measured value of v is 4.80% and the percent uncertainty in the measured value of y is 5.00%, what is the percent uncertainty in the calculated value of g? (Do not enter units for this answer.) X%
An object is released from rest and falls in free fall motion. The speed v of the object after it has fallen a distance y is given by v2 = 2gy. In an experiment, v and y are measured and the measured values are used to calculate g. If the percent uncertainty in the measured value of v is 7.41% and the percent uncertainty in the measured value of y is 5.00%, what is the percent uncertainty in the calculated value of g? (Do not enter units for this answer.)
An object is released from rest and falls in free fall motion. The speed v of the object after it has fallen a distance y is given by v2 = 2gy. In an experiment, v and y are measured and the measured values are used to calculate g. If the percent uncertainty in the measured value of v is 4.29% and the percent uncertainty in the measured value of y is 5.00%, what is the percent uncertainty in the calculated value of g? (Do not enter units for this answer.) 5.0 X %
What, roughly, is the percent uncertainty in the volume of a spherical beach ball of radius r = 0.84 ± 0.04 m?
The final answer should be expressed with 3 significant figures and proper SI units.
Consider the bivariate dataset for variable Minnesota, (X) and variable Rhode Island, (Y) given by the table. Rhode Group Minnesota Island А 2.24 2.98 B 2.73 2.42 C 3.80 2.97 D 3.29 2.32 E 3.90 2.25 F 3.92 3.97 a. Find the value of the slope of the regression line:
(a) How many significant figures are in the numbers 99.0 and 100.0? 99.0 100.0 (b) If the uncertainty in each number is 1, what is the percent uncertainty in each? (Give your answer to 3 significant figures.) 99.0 % 100.0 % (c) Which is a more meaningful way to express the accuracy of these two numbers, significant figures or percent uncertainties? significant figurespercent uncertainties
(a) A person’s blood pressure is measured to be 120+2 mm Hg. What is its percent uncertainty? (b) Assuming the same percent uncertainty, what is theuncertainty in a blood pressure measurement of 80mm Hg?