Consider a fourth-order system with the characteristic equation 5² +85³ + 18s² + 16s + 5 = 0

Q: (b) Figure Q.2(b) shows the power derating curve for a power transistor. It is rated for a maximum…

A: Given : Power dissipation PD is 115 W Case temperature TC is 25°C Derating factor is 0.657 W/°C…

Q: 2. You should measure DC power dissipated in a resistive load indirectly using a DC voltmeter and…

A: Given- Voltage reading= 10V Current reading= 1 A Voltage error=±0.4 V Current error= ±0.08 A To…

Q: The first column of the Routh table of a system is made by the following 2K-3 values: -4, 3, and…

A:

Q: A power station has a maximum demand of 40 MW. The total load connected to the station is 100 MW. If…

A: We have been given an power station with, Maximum Demand = 40 MW Average Demand = 25 MW Connected…

Q: 26) An open loop transfer function is given by G(s) = K (s+1)/(s + 4)(s^2 + 3s + 2). It has: a. One…

A: Given data, Transfer function is given as, TF=s+1s+4s2+3s+2

Q: Using sum-by-column method, solve the following problem: a) An finite impulse response (FIR) filter…

A:

Q: Do the following conversion problem: Calculate the binary equivalent of 2/3 out to eight places.…

A: It is given that: 2310

Q: What will be the radiation resistance of a hertzian dipole antenna of quarter wavelength?

A: The Hertzian dipole antenna is a special type of dipole antenna which is used as a reference antenna…

Q: 1 0 8 (t) t

A:

Q: 7. What is the word length of an 8-bit microprocessor?

A: The solution is provided in the following section.

Q: Find y(t) = X(+) *b (t) for the Signals shown below h(t) X(X) 3

A:

Q: 2) Use superposition to find i for the circuit shown in Fig. 14-21 if the voltage of the voltage…

A: Superposition theorem:- It applies to the linear system. It is not applicable for non-linear…

Q: 1. A single phase circuit with a given load  5 ohm resistance and capacitive  reactance of 2 ohms as…

A:

Q: Consider an aperiodic continuous-time signa x(t) having the corresponding Fourier transform X(jw).…

A: In this question we will find Fourier transform of given signal....

Q: wo generating stations A and B have the capacities 500MW and 800MW respectively are interconnected…

A: It is given that: 1. Two generating stations A and B have the capacities 500MW and 800MW…

Q: The voltage across the terminals of the 5μF capacitor is 30 cos (4000t + 25°) V. Calculate (a) the…

A: Given, Capacitor=C=5μF=5×10-6F Voltage across Capacitor Terminal=V(t)=30cos4000t+25°V

Q: The voltage across the terminals of the 5µF capacitor is 30 cos (4000t + 25°) V. Calculate (a) the…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Determine the transfer functions for the multiple inputs and multiple outputs system given as: 1…

A: The transfer function can be obtained from the given state space model by using the given A,B,C and…

Q: A sequential circuit has two JK flip-flops A and B and one input x. The circuit is described by the…

A: The state equation can be obtained by using the state transition table and k-map for the given…

Q: 23. Use series to evaluate : Limit 210 1-cost

A: By expanding the expression of cos(t) in the above expression we get a finite value for the above…

Q: 1. In Superposition theorem, while considering a source, all other voltage sources are? A. open…

A: Superposition theorem : According to superposition theorem when a circuit consist of multiple number…

Q: QUESTION 16 KVL (CLO 3): The value of Vx, in the following electric circuit equals: ww 72 15V -3 V…

A: Given data, Circuit diagram is given,

Q: Four resistors are connected as shown in the figure. 17 N 65 N ww a 83 2 91 V d S1 Find the…

A: The resistance between the terminal can be calculated by reducing the parallel and series connected…

Q: The D latch of Fig. 5.6 is constructed with four NAND gates and an inverter. Consider the following…

A: D-Latch:- An electronic latch could be used to hold a single piece of data.  When the clock input…

Q: Given x(1) with Fourier Transform X(w), then Y() for y(t) = x(21) is: Select one: O None of the…

A:

Q: | ΜΑ For the op-amp circuit of Fig. 6.21, find Vo 10 ΚΩ wwwwww + V₁ V₂ ΜΜΜ 99 ΚΩ wwww 1 ΚΩ Hli RL Vo

A:

Q: The quantity of charge Q in coulombs (C) that has passed through a point in a wire up to time t…

A: Given: The charge Qt=t3-4t2+6t+4

Q: the following circuit, find Vo

A: Given- Source voltage= 20 Volts Resistance, RA= 1kohm RB=2 kohm RL= 1 kohm To find- Output voltage,…

Q: +1,0V +36 slokn 5.6kn B = 50, assume VBE) = 0.8V fina VE, VC, VB 1E, ib, ic

A:

Q: Two bidirectionally infinite line charges exist in vacuum. One has a charge density of -7 nC/m at x…

A:

Q: 24. What value is to be considered for a "don't care condition"?

A: The correct option is provided in the following section.

Q: Assume that the switch in the image shown below has been in position A for a long time and is moved…

A:

Q: 2) A discrete-time signal is shown in the figure below. Sketch and label carefully each of the…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: Calculate the capacitance of a parallel plate capacitor that has a fiberglass dielectric with &=…

A: Given data: Separation. d=0.254 mm εr=4.4 A= 1.3 cm2=1.3×10-4 m2d= 0.254 mm=0.254×10-3 m

Q: Given X(w) Then X(0) = Select one: O 0.00 ο ο ο Ο 2 O j Ο 2/15 1 sin(2ω) J

A:

Q: The state-equations of the control system shown in Fig.1 is: U(s) a. O b. 0 с. c. A = 0 -L d. A 0 0…

A:

Q: Construct a JK flip-flop using a D flip-flop, a two-to-one-line multiplexer, and an inverter.

A: Flip flop:- Basic flip-flops can construct by four NAND or four NOR gates. It maintains its state…

Q: What is the z-transform of: x(n) = n7nu(-n-1)

A:

Q: Consider the analog signal x(t) = 3 cos2000πt+5 sin 6000rt+10cos12,000ft What is the Nyquist rate…

A: Given:- Analog signal xat=3cos 2000πt+5sin 6000πt+10cos 12000πt In this que. we have to find the…

Q: Determine the velocity of electromagnetic wave in free space. I need detail calculation.

A: The solution is provided in the following section.

Q: Taking the derivative of a second-order system response to find the peak time Tp always gives us a…

A:

Q: (a) U Let x[n] = {1, 2, 0, 0,4). What is the energy in x[n]?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Find out the Laplace transform of the shifted unit step function ult-a). Use the properties of…

A: In the following section, the Laplace transform of the shited unit step function has been obtained.

Q: What will be the radiation resistance of a hertzian dipole antenna of quarter wavelength?

A: In this case, the radiation resistance of a Hertzian dipole antenna is to be determined.

Q: Ti Given r(t) with Fourier Transform X(w), then Y(w) for y(t) = 3t²r(t) is: Select one: OY(w) = -3²…

A:

Q: 5. Which of the following technology was used by Intel to design its first 8-bit microprocessor?

A: The correct option along with the explanation is provided in the following section.

Q: The circuit to the right consists of a battery (Vo = 3.00 V) and five resistors (R₁ = 711 S2, R₂ =…

A: Given values:- V0=3.00 VR1=711 Ω,  R2=282 ΩR3=463 Ω,  R4=434 ΩR5=465 Ω

Q: 1. A three-phase induction motor delivers 100 hp while operating at an 80 percent efficiency and a…

A:

Q: Establish the shifting property of Z transform.

A: In this case, the shifting property of Z transform is to be established.

Q: Find LT

A: In this case, the Laplace transform of the given function is to be determined.

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.