Consider the cycle shown below.Deteremine the work of the turbines in kW given that the turbines operate at 80% efficiency. CondenserTurbine(78)saturated liquid18 kg/sSteam 800 kPa, Saturated vaporPump6500 kPa (9Water resupply 2 kg /s 500 kPa 100°C(210Steam 800 kPa, Saturated vapor6Steam 800 kPa, Saturated vaporHeater11Turbinesaturated liquid (3500 kPa(52 MPaHeaterPump4700°C20 kg/s

Given details: P5=2 MPaT5=700°CP6=800 kPam1=20 kg/secm2=18kg/sec 5-6: Isentropic expansion 6-7:…

Answered: Consider the cycle shown…

Consider the cycle shown below.Deteremine the work of the turbines in kW given that the turbines operate at 80% efficiency.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

All the nearby buildings' heating is provided by saturated steam generated at a nearby steam plant using natural gas boilers. On March 13th, 2019 (cycle weather bomb), the area experienced a cold front with outdoor air temperature equal to 39°F at 9 am. After heating all buildings in the area, water returns to the boiler as saturated liquid at 222°F. Water is then preheated and pressurized to 222°F and 180 psig (state before entering the boiler). Water leaves the boiler as saturated vapor at 322°F. For this date/time steam mass flow rate was 21,900 lbm/hr.Boiler combustion produces combustion gases at 3,000°F at 20psia, which leaves the boiler at 400°F 19.5psia. Determine: The pressure of the steam leaving the boiler and the oiler heat capacity (heat needed to produce steam at the given flowrate and temperature, MMBtu/h) Mass air flow rate (lbm/h) and he exergy destroyed (MMBtu/h) in the boiler Second law efficiency in the boiler Assumptions: Steady operating conditions exist and…
The air conditions at the intake of an air compressor are 33 C, 50 percent relativehumidity, and 101 kPa. The air is compressed to 400 kPa, then sent to anintercooler. If condensation of water vapor from the compressed air is to beprevented, what is the minimum temperature (tdp) to which the air can be cooled inthe intercooler?Use theoretical calculation for this problem.
The air handling unit of an air-conditioning plant supplies a total of 4500 cmm of dry air which comprsse by weight 20% fresh air at 40°C DBT and 27 C WBT and 80% recirculated air at 25°C DBT and 50% RH. The air leaves the cooling coil at 13°C saturated state. Calculate the total cooling load and room heat gain. Take Sp. volume of air entcring the cooling coil as 0.869 m/kg d.a. Given: Condition DBT WBT RH Sp. Humidity Enthalpy °C g.w.v.kg d.a. kJ/kg d.a. outside 40 27 17.2 85 AYC inside 25 50 10.0 50.8 100 9.4 37 ADP 13 JADP-Apparatus Dewpoint]
Draw the T-S diagramNotes: Assume the steam is reheated to the inlet temperature of the high-pressure turbine. The moisture content of the steam at the exit of the low-pressure turbine is not to exceed 9.5%
1. A refrigeration system using R-22 has a capacity of 320 kW of refrigeration. The evaporating temperature is -10°C and the condensing temperature is 40°C. Calculate the fraction of vapor in the mixture before the evaporator. Properties of R-22: At -10°C; hg = 401.60 kJ/kg, hf = 188.43 kJ/kg At 40°C; hf 249.69 kJ/kg
Question 1)Water vapor enters with a continuous flow adiabatic turbine, 3MPa press, 400 oC temperature and 90 m3 / min volumetric flow rate. Some of the steam comes out of the turbine at a pressure of 0.5 MPa and a temperature of 200 oC. The remainder is abandoned in the 5 kPa pressure and 90% composition registration system. Calculate the mass flow rate at the outlet no. 2 by neglecting the kinetic and potential energies according to the total power generated in the turbine 5 MW. Question 2)Bir evin çatısına yerleştirilmiş güneş panelinin üzerine 2.5 kW’lık güneş enerjisi gelmektedir. Gelen bu enerjinin %25’i çevreye kaybedilmekte, kalan enerji ise güneş paneli içerisinden geçen suyun sıcaklığını 30 oC’den 60 oC’ye çıkarmak için kullanılmaktadır. Sürekli çalışma koşulları altında, su sıcaklığındaki istenen artışın sağlanabilmesi için güneş paneli içerisinden saatte kaç litre su geçmesi gerektiğini belirleyiniz. Suyun yoğunluğunu 1000 kg/m3 olarak alabilirsiniz. Ayrıca, güneş paneli…
Question 1)Water vapor enters with a continuous flow adiabatic turbine, 3MPa press, 400 oC temperature and 90 m3 / min volumetric flow rate. Some of the steam comes out of the turbine at a pressure of 0.5 MPa and a temperature of 200 oC. The remainder is abandoned in the 5 kPa pressure and 90% composition registration system. Calculate the mass flow rate at the outlet no. 2 by neglecting the kinetic and potential energies according to the total power generated in the turbine 5 MW. Question 2)2.5 kW of solar energy comes upon renovation of a house. 25% of this incoming energy is lost to the environment, and the remaining energy is used to increase the temperature of the water passing through the solar panel from 30 oC to 60 oC. Determine how many liters of water pass through the solar panel in order to ensure the increase in water temperature under continuous operating conditions. Use the density of the water as 1000 kg / m3. Also, neglect the pressure loss, kinetic and potential energy…
3.) An ammonia compressor operates at evaporator pressure of 316.02 kPa and a condenser pressure of 1557 kPa. A twin-cylinder compressor with bore to stroke ratio of 0.85 is to used at 1200 rpm. The actual volumetric efficiency is 92% and compression and mechanical efficiency is 78% and 80% respectively. For a cooling capacity of 25 TR, (a) the sketch the p-h diagram labeling the evaporating and condensing temperature and pressures (b) define the all properties of ammonia taken from saturation table. Determine (c) the quantity of cooling water in the condenser in kg/min if the increase in temperature is 8°C, (d) the bore and stroke expressed in cm and (e) the size of the driving motor in hp. Given: h2 = h at 1557 kPa and s2 = s1 1695 kJ/kg
Steam is delivered to turbine at 5.4 MPa and 600 degree C. Before condensation at 31 degree C, steam is extracted for feed water heating at 0.6 MPa. The turbine exhaust is 60 degree C. the required values of some state point properties are tabulated below. 7. Determine the quality of steam at the condenser inlet.
(4) all öf th (b) dry saturated liquid refrigerant The refrigerant supplied to a compressor must be (a) superheated vapour refrigerant (c) a mixture of liquid and vapour refrigerant (d) none of these ant compressor is called
A refrigeration system using R22 is to have a refrigerating capacity of 60 kW. The evaporating temperature is -50C and condensing temperature of 350C. Determine the fraction of vapor in the mixture at the entrance to the evaporator. Ans: 0.234
What are chilled liquid treatment process and condenser water treatment process in refrigeration and air conditioning?