D1 V1 1n4001 T1 SR1 5kQ 220 Vrms 60 Hz 0° +, D2 TS_POWER_10_TO_1

Q: A germanium diode draws 32 mA with the forward bias 0.27 V. If T=300 K, calculate the reverse * .sat...

A: Given, In germanium diode Diode current, ID=32 mA Forward bias voltage, VD=0.27 V Temperature, T=300...

Q: 0.1 Ohm SW TIP2955 with Heat Sink 10 Amp 50 PV Bridge Rectifier 0.1 Ohm SW LM7812 with Heat Sink FUS...

A: Full wave bridge rectifier- A circuit in which four diodes are interconnected in a bridge form in wh...

Q: Whas is the circuit diagram of linear voltage regulator for fixed output voltage using IC78xx and IC...

A: Voltage regulator- Voltage regulator is a device which provide a fixed voltage as an output for fluc...

Q: Sketch Vo for the following circuit. 120 V Ideal 20 V

A:

Q: 2- Explain the effect of increasing the filter capacitance on the output voltage.

A: 2. When the capacitor size is increased then the peak current in the diode and the dc voltage will a...

Q: a) Write down the characteristic equation of a semiconductor diode. b) What happens in a semiconduct...

A:

Q: The resistance of a coil of copper wire is 3.35 2 at 0°C. What is its resistance at 50°C. For copper...

A: GivenTemperature T1=0°CResistance at 0°C=3.35ΩT2=50°CTemperature coefficent α=4.3×10-3C-1

Q: A synchronous generator is feeding an infinite bus through a line. At the middle of the line a shunt...

A: Given A synchronous generator is feeding an infinite bus through a line. At the middle of the line ...

Q: Three part ( A, B, C) connected in a parallel. Part (A) contents (2 2, 6 Q) in series. Part (B) cont...

A:

Q: 7. A purely resistive lamp is rated at 200V (rms), 120 W (i.e., it dissipates 120 W power when conne...

A: Given, A purely resistive lamp, Vrms=200 VPrms=120 W

Q: An ac voltage of peak value 20v is connected in series with a silicon diode and load resistance of 5...

A: Diode- Diode is a device which is used as switch which allows the flow of current in one direction. ...

Q: Parallel and Series-Parallel Diode Configuration 8. 3. Vo, and IR 12V Si 12V Ge 2.2 k2

A: GIVEN:  a circuit diagram with                silicon diode                germanium diode          ...

Q: Two alternating voltages are represented by vị = 50 sin wt volts and v2 = 100 sin(wt - -). Draw the ...

A: The solution is given below

Q: Multiple Choice. Refers to a point in a circuit where three or more wires are connected. A. Conduc...

A:

Q: 4 kf? ww ww 2 k V1 1 kf 6 ki Fig. 3 4 kf 3 kl

A:

Q: Determine the output voltage vo of the given circuit as a function of vjand v2 by entering the numer...

A:

Q: 2) Determine (V,) for the two circuits below using superposition. 2A 42 12V 12A 19V

A:

Q: C1

A: Given circuit shown  V0=24 vC2=8.5 μFV1,end=19.5 v

Q: Series Diode Configuration 4. Ge Si 4. Vo and Ip +12 Vo- Love Ip 5.6KQ

A:

Q: A 120 MVA, 19.5 kV generator has Xs = 0.15 per unit and is connected to a transmission line by a t...

A: Given, Generator rating: 120 MVA, 19.5 kV and Xs=0.15 pu Transformer rating: 150 MVA, 230 Y/18 Δ kV ...

Q: ONE-STALE PILTER Vin Vout onalhsupe

A: We will apply virtual short principle to find transfer function of op-amp. We have: VinR1+1sC1=0-Vou...

Q: Explain State Space Representation of Nth order Linear Differential Equation.

A: Most physical systems can be modelled in terms of differential equations. So we need to devise a met...

Q: A negative charge q'is located as shown in the figure: What is the direction of the electric field c...

A: Answer is as follows-

Q: A negative charge q'is located as shown in the figure: a. I- What is the direction of the electric f...

A: Given figure,  

Q: Find the phase inductance of the three-phase circuit shown in the figure, if the separation between ...

A:

Q: A long wire carrying a certain current produces a magnetic field of 0.8 Tesla at a distance 0.5 cm. ...

A: Given: Magnetic field, B1=0.8 T At distance, d1=0.5 cm Magnetic field, B2=? At distance, d2=1 cm

Q: 4.- Express the following terms in their rectangular form. a) 32ej125.3° b) 21.7ej34.3° c) 37.9ei124...

A:

Q: An ac voltage of peak value 20v is connected in series with a silicon diode and load resistance of 5...

A: This question belongs to analog electronics .  It is based on the concept of analysis of silicon dio...

Q: KHZ 2. 4) How to determene Cutoff froy. ond whih Crlut has Hhis characterestics ond why Vout Vaut

A:

Q: Compare the result of using a VIRTUAL DIODE vs 1N4001. Please explain.

A: The characteristics of a virtual diode and a 1N4001 diode is shown in the question. The values of re...

Q: calculate the magnitude of the current through the j3.3k ohm inductor. jl k2 1.2 k2 -j4.7 k2 j2.2 k2...

A:

Q: The current loads of four circuits are as follows: Circuit No. 1 = 56 A Circuit No. 2 = 59 A Circuit...

A:

Q: 1) a) Design a depletion-mode load inverter shown in the below figure with VDD = 3.3V, P = 0.25mW, V...

A:

Q: SV D9 D8 D7 20 26 28 32 19 25 27 31 35 DO D3 D5 D6 GND 30 8's cohumn L 'KH CND OPIO 26 IZ OlaD : 2 o...

A: The solution is given below

Q: 12. Find the missing values in Fig-32. = ? I, = 3 A V = ? 4 0 12 0 Fig. 5-32

A:

Q: Two positive charges Ql and Q2 are separated by a distance r. The charges repel each other with a fo...

A:

Q: 3) Determine (V,) for the circuits below using superpositic ww SIx ww Vx 10 V 2 A

A: Given circuit shown       

Q: Consider two charge Q =9 x 10- (C) and Q2 = 5 x 10-0 [C] separated by a distance r = 0. 05 (m]. a. W...

A: When two charges Q1 and Q2 are kept at distance d then charges experience a force on each other. If ...

Q: VcC 10V R1 10kn 10% RC {3.6kN 10% C2 B = 150. 01 2N3904 RS C1 1kn 10% RL vs 1.5kn 10% CE 470uF R2 RE...

A: We need to find out the voltage gain for given circuit

Q: Using 3 capacitors with capacitance value of 3 farad, 6 farad, and 8 farad arrange them in: a. seri...

A:

Q: 3. Category 5 cable, commonly referred to as CAT-5, is a twisted pair cable for computer networks. T...

A:

Q: Which of the following characteristics belongs to an analog quantity? a. Its values follow a mathem...

A: The solution is given below 

Q: A 75 MHz carrier having an amplitude of 50 V is modulated by a 3 kHz audio signal that has an amplit...

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you a...

Q: What is the circuit time constant? 1 kQ i(1) I mH all

A: Circuit is given as,

Q: Calculate vo in the op amp circuit. Given that vs = 6.2 V. 12 k2 +, + Vs (+ 20 k2 Vo The output volt...

A: The solution is given below 

Q: 30. Assuming an operating frequency of 50 Hz, compute the instantaneous voltage at t= 10 ms and t= 2...

A: The solution is given below 

Q: Compare the results of static or dc resistance of the diodes obtained from different values of forwa...

A: The characteristics of a virtual diode and a 1N4001 diode is shown in the question. The values of re...

Q: 8- If we were to build a truth table for a 16-input AND gate, how many different combinations of inp...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Three point charges are located as shown in the figure. 9=-5 x 10-12 (C) and di =6 (cm] 92=-4 x 10-2...

A:

Q: Which component in an IoT device can take electrical input and transform it to physical action? a. ...

A: Which component in an IoT device can take electrical input and transform it to physical action? a. A...