Define fluid mechanics and Rheology? Why Rheometers are Prefer than viscometer in analyzing the flow properties of pharmaceutical liquid preparations ? Write the significance of rheology in Pharmaceutical field?

Define fluid mechanics and Rheology? Why Rheometers are Prefer than viscometer in analyzing the flow properties of pharmaceutical liquid preparations ? Write the significance of rheology in Pharmaceutical field?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 118AP: Angioplasty is a technique in which arteries partially blocked with plaque are dilated to increase...

See similar textbooks

Related questions

Q: Which statements for Bernoulli's equation are true? a. Bernoulli's equation holds for viscous flow.…

A: Bernoulli's equation states that the total of all forms of energy of a fluid flowing along a closed…

Q: Describe about Fluid flow also tells what ideal fluid is?

A: To describe Fluid Flow

Q: Q1\ A ball made of INOX AISI 365 steel with density of 8.52 gr/cm3 was used to determine the…

A: Here the density of steel is 8.52 g/cm³.The ball is travelled 19 cm in 2.2 sec.The diameter of the…

Q: Give a concrete example/situation that demonstrates Bernoulli’s principle. Make sure to discuss the…

A: According to Bernoulli's principle The energy of a flowing fluid in a closed pipe. There are three…

Q: 1. Bernoulli's equation is applicable only for a. Irrotational flow b. Viscous flow c. Inviscid,…

A: In inviscid flow, the viscosity of the fluid is zero, and therefore there will be no viscous acts on…

Q: As part of a development programme, scale model tests have been carried out on a new hydraulic…

A: Force depends on the velocity, viscosity and density and length

Q: of fluid is high The equation of continuity tells us that where the cross-sectional area is small,…

A: as per our guidelines we are supposed to answer only one question. Kindly repost other question as…

Q: Define incompressible flow and incompressible fluid. Must the flow of a compressible fluid…

Q: Explain why fluid velocity is greatest where streamlines are closest together. (Hint: Consider the…

A: Introduction: A Streamline flow of the fluid shows that the fluid particles are following the same…

Q: We learned that Reynolds number is given where ρρ, vavvav and ηη are the density, average speed and…

Q: Calculate Using the coordinate the density the fluid force on one side of the plate below. Assume…

A: The pressure exerted by a fluid at equilibrium at any point of time due to the force of gravity”.…

Q: Discuss in detail why we study Fluid Mechanics?And the scope of Fluid Mechanics?

Q: In liquid A, a body floats with 9/10th of its volume immersed, while in liquid B it floats with…

Q: Bernoulli's equation is applicable only for a. Irrotational flow b. Viscous flow c. Inviscid,…

A: Since there are multiple questions posted, we will answer the first question for you. If you want…

Q: What is the relevance of cohesion and adhesiion to the surface processes in the field of fluid…

A: Answer:- The tendency of two or more different molecules to bond with each other is known as…

Q: What principle or physical law is used in the determination of specific gravity/density of a liquid…

Q: a hydraulic lift raises a 2000kg automobile when a 500N force is applied to the smaller piston. If…

Q: Explain the capillary rise of liquid. Deduce an expression for the rise.

A: Capillarity is a physical phenomenon in which liquids flow without the help of gravity. Liquids also…

Q: Relate pressure to fluid density and depth.

A: The relation between the pressure, fluid density and depth is given as, P=ρ×g×h Here, ρ is the…

Q: The large piston of a hydraulic lift had a cross-sectional area 18 times more than the small…

A: F1 = 30 N A2 = 18 A1 To find = Force F2

Q: Who inspired and gave Daniel Bernoulli an idea on how fluids in motion behave?

Q: 0/1The Bernoulli's equation in fluid dynamics * is valid for Transient flowsO Continuous flows O…

A: Bernoulli's Principle: For the steady-state flow of a fluid, the total energy of fluid remains…

Q: HYDRAULIC LIFT. In the figure below (not to scale), a hydraulic lift has one piston of diameter 8.0…

A: Given: The diameter of the small piston is 8 cm. The diameter of the large piston is 40 cm. The…

Q: What is hydraulic diameter? How is it defined? What is it equal to for a circular pipe of diameter…

Q: Q4 / Calculate the surface tension of a liquid if its height in the tube is 0.2 meters, its density…

A: Let the radius of the capillary tube is denoted by r, height of the tube is denoted by h and the…

Q: ia) Write the flow rate relation mass, density and volume. ib) Advantage of SI system of units over…

A: a. Mass flow rate can be calculated by multiplying the volume flow rate by the mass density of the…

Q: Is it possible for a fluid to flow in a direction from low pressure to high pressure? If so, give an…

Q: Give a practical life example (other than the examples given in reference book) for each of the…

A: 1. Laminar Flow : When the water is coming slowly out of a tap, it exhibits a laminar flow, the…

Q: What is Fluid pressure? Give its conditons in which it can considered.

A: a fluid isa substance that can flow through any medium or over the surface. example air, water etc.…

Q: What is capillarity? Describe capillary rise method for finding the surface tension of a liquid.

A: Capillarity:Tendency of a liquid to rise or fall in a tube due to surface tension is known as…

Q: Describe body forces and surface forces, and explain how the net force acting on a control volume is…

Q: (a) Define coefficient of viscosity, , and show that its dimensions in M, L and T are ML-T-. What is…

Q: Define Capillary Action And Give Some Examples Of It

A: Capillary action, also known as capillary motion, capillary effect, capillarity, and wicking, can be…

Q: As part of a development programme, scale model tests have been carried out on a new hydraulic…

A: dimensional analysis

Q: Explain pressure in the fluid ? And what is pascal is principle?

A: The layer of fluid has always exerted the force on each other due to their viscous nature. The force…

Q: Where can we apply Bernoulli’s Principle? Give one example and explain why we can apply Bernoulli’s…

A: According to Bernaulli's theorem The total mechanical energy of the moving fluid comprising the…

Q: The volume of an iceberg is 672,000 ft3. (a) What is its weight (in lb), assuming it is pure ice?…

Q: ection: Read, analyze and solve the following word probiems. 1. A large piston of a hydraulic lift…

A: According to Pascal's law Pressure applied at one point of liquid equally transmitted throughout. We…

Q: Many figures in the text show streamlines. Explain why fluid velocity is greatest where streamlines…

A: When a liquid flow is in such a way that each liquid particle passing through a certain point…

Q: Ca) Explain the terms lines of flow and stream- lines when applied to fluid flow and deduce the…

A: a) Lines of flow: Lines that show the geometric representation of the velocity vector of fluid flow.…

Q: Q3/ what is the difference between 1. Ideal fluid and real fluid. 2. Laminar flow and turbulent…

A: Here we are going to difference between (i) Ideal and real fluid (ii) Laminar and turbulent flow

Q: Q1\ A ball made of INOX AISI 365 steel with density of 8.52 gr/cm3 was used to determine the…

A: Here it is given that a steel ball with density 8.52 g/cm³ is travelled in a viscometer. That…

Q: HYDRAULIC LIFT. In the figure below (not to scale), a hydraulic lift has on piston of diameter 8.0…

Q: Explain what is meant by the pressure in a fluid, and how it is measured?

A: The pressure in a fluid increases with increasing depths in a fluid, it is the force that the fluid…

Question

Define fluid mechanics and Rheology? Why
Rheometers are Prefer than viscometer in
analyzing the flow properties of pharmaceutical
liquid preparations ? Write the significance of
rheology in Pharmaceutical field?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A rectangular gasoline tank bold 30.0 kg of gasoline when full. What is the depth of the tank if is 0.500-m wide by 0.900-m long? (b) Discuss whether gas tank has a reasonable volume for a passenger car.
What is the density of 18.0-karat gold that is a mixture of 18 parts gold, 5 parts silver, and 1 part copper? (These value are parts by mass, not volume.) Assume that this is a simple mixture having an average density equal to the weighted densities of its constituents.
Find the magnitude and line f actiom Of the forces exerted on the tank is filles half full with el liquid specific grauity 2. while the reminder is filles with a liqued specific gracuty 1. Side A a tank which s I'sm? and lm deep. The
Given: Pi constant to be used: 3.14159Capillary tube: radius = 0.02 cm; length = 9 cm; pressure = 0.7 mmHgLiquid sample: density = 4 ml; time of flow = 4.5 seconds 1. What is the pressure in MKS unit? Your answer here will be used for the next item(s). 2. What is the pressure in CGS unit? Your answer here will be used for the next item(s). 3. What is the viscosity of the liquid? Your answer here will be used for the next item(s). 4. If the weight was given as 8.5 grams, what will be the density of the liquid? Your answer here will be used for the next item(s). 5. What is the kinematic viscosity of the liquid? 6. What is the fluidity of the liquid?
(a) Describe and classify sheet Pile Wall. (b) State the uses of sheet pile wall? (c) List the advantage of sheet piling over other retaining structures. (d) An anchor sheet pile bulkhead is shown in figure. a) Calculate the actual depth of penetration (Use,Dactual = 1.3 Dtheory) b) Draw the pressure distribution diagram, and c) Determine the anchor force per unit length of wall. 4. Conclusion. Sand γ sat = 24 kN/m 3 , φ = 30 0 Sand γ = 20 kN/m 3 , φ = 30 0 Sand γ sat = 24 kN/m 3 , φ = 30 0 l 1 = 3 m L 1 = 10 m L 2 = 22 m
ANSWER CORRECTLY AND QUICKLY PLS HUHU A needle with a piston is used to extract blood from the arm of a patient. Solve for the ave. speed of the blood flow, in mm/s, in the needle if the radius of the piston is 2.5mm and the diameter of the needle is 0.5mm and length of 10mm. Take into account the blood withdrawing speed of 6mm/s and air leaks around the piston at 20mm3/s.
Explain salient features of the liquid Drop model. Also mention various assumptions made for t Model.
QI. Solve the following: (Compulsory question) a) Pressure on the quay Weight of the container. Length of the reachstacker: Length of the arm 32 tons 4 meters 14 meters. Pls calculate the pressure on the quay. What is the pressure on the quay 32 tons Discover your scO ?? Quay www.nhtv: What is the axle pressure on the front axle (which is standing on the quay)?
OAn alyminium cube 800Cm3 if totally I'mmmerred calculate hais volume of wter the upthnust acting on it. in 2. A body Loss O.6N weight in imneead in water water. Calculate its volume in Cubic 3. An and a rope do of mass 360g. Tron density Galcms Suspended: natf way) in that piece a parhally Submaged 01 denity O.da I cm3? Find the tersion of the spring. 4. kihen weight 3 air an Olject I totally imonersed in ecorded as '4ON#in weight B 3ON Calculate the upthmust okject. in acting s A body on an 7ON, of trewed in water dispaced liguid if its weight whie în water is 3.3N find weight in aira 6 Calculate the relative densi ty of abady when rts weight in water B 30N.
+ Report - Glassware, Téchniques, and Measurement Lewis, Tereka REPORT SUMMARY Part I Density of Unknown Liquid Report your measurements to the correct number of significant figures. Use the images provided below to collect data virtually. If you have technical issues with the virtual data, please contact support. From the procedure 1. Obtain a 100 mL beaker and put about 60 mL of unknown solution into it. 2. Mass a clean dry 10 mL graduated cylinder on an analytical balance. Record the mass using the appropriate number of significant figures and units. (Use the same balance for future weighing to ensure accuracy in mass recordings.) Mass of empty 10 mL graduated cylinder (g) 11.611
1) During your experiment, you will have air flowing at a constant flow rate through four different sized ports in a chamber as shown in the picture. Cross sectional area Calculate the cross sectional area for port #1 if its dimension are: Width = 7.2160 x 10-3 m Depth = 8.0260 x 103 m 2) The relationship between Flow Rate (R), Cross Sectional Area (A) and Velocity (v) is called the Continuity equation: R = Av Use the area from question 1 to calculate the velocity of the air at port #1 if the air is flowing at a rate of R = 0.0011366m Width Depth
lutorial problem For the following liguid level- Flow rate in a tank of outer penimeler of(28)xm amd thickness (0-5)cm The steady-s ralues are faken from Laborahory:- hcm) 100 150 27 200 38 250 52 Determine time constant of the haok (theorehical cnd exper.menlal then compare between them, also, determine response of Liguid level what do you expect the liguid-level be when the flow increased from 100 /h to 120 e/h?