Derive the linear, constant-coefficient differential equation that describes the output of this circuit (the voltage across the capacitor = y(t)) in terms of the input voltage x(t)(shown with an AC power supply here) and the circuit element values R, L, C. Assume that there is no stored energy in this circuit prior to the application of a new input x(t).RVin(t) = x(t)LVout(t) = y(t)Enter the numeric values of the coefficients for the differential equation for this circuit, assuming:R = 10 KohmsL = 0.3 henriesC = 10 microfarads(Enter only whole number values; no fractions or decimal points)y"(t) + type your answer...y'(t)+ type your answer...y(t) type your answer...x(t)+ type your answer...x'(t)

Answered: Derive the linear, constant-coefficient…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Consider the RLC circuit shown where the initial current flowing through the circuit at time t = 0 is I_0 = 5 and the initial charge on the capacitor at time t = 0 is Q_0 = 2. The components have values of R = 100 ohms, L = 5 H, and C = 1/450,500 F. Write the differential equation for Q(t), the charge across the capacitor, assuming the voltage source V(t) = 0
Assume that the circuit in the image has been connected for a very long time. (a) As time approaches infinity, what wtll happen to the capacitor and inductor? (b) From your answer in (a), draw the equivalent circuit (label appropriately).(c) From your circuit in (b), determine the "steady-state" or "final" values of Vc, lc, IL and VL
The circuit elements in the circuit L=50 mH, and C=0.2 μF. The initial inductor current is−45 mA and the initial capacitor voltage is 15 V.4. The resistance is increased to 312.5 Ω. Find the expression for v(t) for t≥0.
A system has a damping ratio of 0.5, a natural frequency of 100 rad/s, and a dc gain of 1. Find the response of the systems to a unit step input.( from the canonical form solve for the response of the system) G(s)=Blank 1
Find the roots of the characteristic equation that governs the transientbehavior of the voltage if R=200Ω, L=50 mH, andC=0.2 μF. 2. Will the response be overdamped, underdamped, or critically damped?3. Repeat (a) and (b) for R=312.5 Ω.4. What value of R causes the response to be critically damped?
*The resistance, inductance, and capacitance in a parallel RLC circuit are 1900 Ω , 250 mH , and 9 nF , respectively. * Pt A. Calculate the minimum root of the characteristic equation that describes the voltage response of the circuit. Pt B. Calculate the maximum root of the characteristic equation that describes the voltage response of the circuit. Pt C.Will the response be over-, under-, or critically damped? Pt D. What value of R will yield a damped frequency of 12 krad/s? Pt E. What are the roots of the characteristic equation for the value of R found in Part D? Pt F. What value of R will result in a critically damped response?
The switch in the circuit has been closed for along time before it is opened at t=0. Assume that the circuit parametersare such that the response is underdamped.1. Derive the expression for vo(t) as a function of Vg, α, ωd, C, and Rfor t≥0.2. Derive the expression for the value of t when the magnitude of vois maximum
Given the ff. second-order differential equation: y[n] + 1.4y[n-1] + 0.45y[n-2] = x[n] - x[n-1] with an input of x[n] = 0.1nu[n] and initial conditions y[-1] = 0 and y[-2] = 1. Find the following: 1. Characteristic equation and its roots. 2. Form of the homogeneous solution 3. Particular solution
For the circuit below with the switch closed and then opening at t=0, and R1= 3Ω, R2= 7Ω, C = 0.2H, ig = 8A, vs = 2v, calculate the initial condition. Develop the differential equation for the solution for t > 0. Calculate the current ia(t) for all times.
For the circuit below determine: a) vc(0+), iL(0+) b) dvc(0+)/dt , vc(∞) c) Is the circuit Underdamped, Critically Damped or Overdamped?d) Determine the expression for the voltage across the capacitor for t > 0.
Make the equation s(s+1)(s+2)+K=0 in the form of 1+KF(s) and explain the drawing of root-locus curves. (Note: Indicate the splitting points, centers and angles of the asymptotes)
control systems In the electromechanical system given below, it can be seen that the coil can be represented by the series R-L circuit and also the coil It is known that the electromagnetic pulling force (F) is also proportional to the coil current, that is, F = βi. The input of the system is the voltage v applied to the coil and the output is the x path taken by the core. Accordingly, the system find the differential equations and transfer function

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS