Design a meter with voltage range of 0-30V, and current range of 0-20mA from an ammeter whose full scale current is 1mA with an internal resistance of 100Ω. Upload your circuit and solution

Q: .. Find current I and the power absorbed by the 8-ohm resistor

A:

Q: 1 KHZ 1,0 vrms. in 3100ml 100ml F=1KH₂ 2₁:100.h 22=100mt P=11_f V=Turms Vm? V₁? I? X₁?

A:

Q: What can you say/perspective about National Electrical Code?

A: The National Electrical Code (NEC) was created to protect people and property from the risks posed…

Q: What are the two primary categories of output circuits in TTL?

A:

Q: B: Drive the radiation intensity equation of an isotropic antenna.

A: Isotropic antenna radiates equally in all directions. So avg power density Pavg= prad/(4πr2).

Q: For the following parts, identify the name of each circuit, plot the output waveform, and find the…

A: Given, Input AC voltage, V∘=Vmsinωt and Circuit 1, Circuit 2, Circuit 3, Average output voltage…

Q: A 3-phase, 60 Hz induction motor has two poles. If the slip is 2% at a certain load, determine the…

A:

Q: 24V R₂ = R₁ = R3 R4 R5 R6 R₂ = Resistance values R₁ = 100 R₂ = 200 R3 = 300 R4 = 400 R5 = 500 R6 =…

A:

Q: The zeros of the transfer function s²+2s+2 s4+6s3 +4s²+7s+12 -1 and -2 -2-2j and -2 +2j O-1+jand-1-j…

A: We need to find out the zeros of transfer function .

Q: A float switch is used to operate a pump motor. The pump is used to fill a tank with water. When the…

A: Pump motor operation with float switch float switch used for different operations here, Float switch…

Q: 5. An impedance draws a current i(t) = 10sin(wt-30°) ampere from a voltage v(t) = 220cos(wt-65°)…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: What are the main parameters necessary for ordering a commercial IC?

A: IC ( integrated circuits) are the compact form of electronic circuits which is made using silicon…

Q: How am I getting the wrong answer?

A: It is given that: Vs=4.5 VR1=3 kΩR2=2.7 kΩR3=3.6 kΩR4=3.1 kΩ

Q: What is the number of turns of wire needed to provide a potentiometer with a resolution of 0.05…

A: We need to find out number of turns for given resolution

Q: Figure Q1 shows a signal conditioning circuit. Determine voltage at node x (V₂), voltage at node y…

A:

Q: In Photovoltaic system, Explain the function of power electronics to harness electrical energy?

A: Photovoltaic system A photovoltaic (PV) system is made up of one or more solar panels, an inverter,…

Q: Q.3 When a line-to-ground fault occurs, the current in faulted phase 'a' is 100A. The zero-sequence…

A: Given- Line to ground fault- Current in the faulted phase=100 A, To Find- The zero-sequence current.

Q: Given the circuit below with the following parameters: Vs = 16 V R₁ = 16.6 K R2 = 18,6 ΚΩ R3 = 1,8…

A: Given circuit, Where, Vs=16 V.R1=16.6 KΩ.R2=18.6 KΩ.R3=1.8 KΩ.R4=11.8 KΩ.

Q: 24. Find the equivalent resistance of the circuit shown in the figure below. 7.02 www 12.0V www 150…

A: Given circuit:

Q: The CMRR of a differential amplifier is 60 dB. If the differential mode gain is 1400, what is the…

A: Given, In a differential amplifier, CMRRdB=60 dB. Differential mode gain, Ad=1400.

Q: A loss-less transmission line having characteristics impedance Zo is terminated in a load of Z₂. If…

A: Given, A lossless transmission line having, Characteristics impedance = ZO. Terminated to load…

Q: The voltage v = 153 sin(100t+50°) V is connected acroos a 3-H inductor. Determine the current (RMS)…

A: Given data, Voltage vt=153sin100t+50° V Inductance L=3 H

Q: 1) Op-amp limiting factors - Current Saturation U2 Vin ww1₁0 R1 OU] OPAMP R2 w RLoad The saturation…

A:

Q: The voltage v = 201 sin(100t+50°) V is connected acroos a 110-µF capacitor. Determine the current…

A:

Q: The supply frequency to the stator of an 8-pole induction motor is 70 Hz, and the rotor frequency is…

A:

Q: :One kilowatt-hour is the power consumed by a 1kW- load during one hour.a None of the answers is…

A:

Q: What is the number of turns of wire needed to provide a potentiometer with a resolution of 0.05…

A: Given  Resolution = 0.05%

Q: A series circuit consists of a resistor, a coil, and a capacitor connected across a 300 V, 60 Hz AC…

A:

Q: 7. Find the charge enclosed in the volume 1 ≤ r ≤3 m, 0≤ ≤n/3, 0≤z≤2 m Given the charge density px =…

A:

Q: The stator of a 3-phase, a 4-pole induction motor is connected to a 50 Hz supply. The rotor runs at…

A: This is a basic problem of induction motor. The detailed solution is given in the next step.

Q: In the circuit give below, find R Reg eq 10Ω 8Ω `eq. 8Ω 4

A: Given circuit,

Q: Determine alpha dc if I E  = 2.8 mA, I C = 2.75 mA and ICBO  = 0.1 mA

A:

Q: 4.17 The circuit shown in Fig. P4.17 is known as a noninverting integrator. For the ele- ment values…

A:

Q: For the transfer function shown below, find the locations of the pole and zeros, plot them on the s-…

A: Given: Transfer function, T(s)=20s2+6s+144 To find: i) location of poles and zeros ii) plot on…

Q: 4- The directivity of the Infinitesimal dipole equal to .......... dB. when all power injected to…

A:

Q: What is the numeric value of the voltage v (in Volts) marked on the schematic diagram?

A: The required parameters can be calculated by using the kirchhoff's voltage and current law in the…

Q: Solve for the equivalent capacitance at terminals a and b from the circuit. Given C1=50mF, C2 =…

A:

Q: 4.15 The asymptotic Bode plot shown in Fig. P4.15 represents a lowpass filter with gain enhancement…

A: Given, Consider the given figure for bode plot and the op-amp circuits.

Q: 4. What are the different types of resistances and their purpose?

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A communication channel has magnitude spectrum and phase spectrum defined as: H()=1 0h() = sin 2xƒT…

A: We need draw magnitude and phase response ,

Q: Use the circuit shown in the image. Compute only the current though the 20 ohm resistor. 40 A 0.50…

A:

Q: The supply frequency to the stator of an 8-pole induction motor is 70 Hz, and the rotor frequency is…

A: Number of poles p = 8 Frequency of stator fs = 70 Hz Frequency of rotor fr = 6 Hz

Q: Complete the table and provide solution in each.  R1 = 430 ohms R2 = 1.1k ohms R3 = 4.7k ohms R4 =…

A:

Q: Q3/ Consider the circuit in Figure (2), answer Three branch only. (a)-What type of circuit is this?…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: How can the noise level of a photomultiplier detector be reduced below the level of shot noise? a.…

A: Photomultipler detectors Used to measure intensity of visible and UV radiation  It can amplify the…

Q: discribe the key step in the design a Contral System

A: There are basically 4 step to design a desirable control system. The block diagram of the control…

Q: Q2/ An 8-poles, 50Hz, delta connection, induction motor having 96 slots with 60 conductors in each,…

A:

Q: Given the following nodes from A to G as shown in the diagram, determine the shortest path network…

A:

Q: 5.5 Straight Outta Compton In class, we looked at Compton Scattering of a photon and a free…

A: Solution of question (A): It is asked to discuss the relation between the change in wavelength and…

Q: For the circuit below if EI=5V, D1=0, D5=0 the state of L1 to L5 will be: D E D7 D2, D3 10 5 OO OO M…

A: Given data: The IC seen here, the 74LS148, is an encoder with an 8-line input and 3 outputs. The…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.