Determine the quantity (volume) of saline water in a steam generator. The heat energy of 1624 kJ is supplied to saline water in the steam generator to heat from 24°C to 101°C for the generation of water vapor, Take the density & specific heat of the solution as 1015 kg/m³ & 4.6 J/kg°K respectively. Solution: Change in Temperature (in K) Mass of the saltwater (in kg) Quantity (Volume) of saltwater (in m3)

Determine the quantity (volume) of saline water in a steam generator. The heat energy of 1624 kJ is supplied to saline water in the steam generator to heat from 24°C to 101°C for the generation of water vapor, Take the density & specific heat of the solution as 1015 kg/m³ & 4.6 J/kg°K respectively. Solution: Change in Temperature (in K) Mass of the saltwater (in kg) Quantity (Volume) of saltwater (in m3)

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter50: Commercial, Packaged Rooftop, Variable Refrigerant Flow, And Variable Air Volume Systems

Section: Chapter Questions

Problem 22RQ: Variable refrigerant flow systems sense the ______and _____of the refrigerant to determine the...

See similar textbooks

Similar questions

Discuss the process of selection of refrigerants in R&AC system based on physical and thermalproperties and environmental aspects. Show the relation between gas properties P-V-T and Heatand work.
4. A water tube boiler has a heating surface area of 500 m². For a developed boiler hp of 825. Determine the percent rating of the boiler. The percent rating of water tube boiler is 200%, factor of evaporation of 1.08 and heating surface area is 256 m?. Find the rate of evaporation. 5.
Q1: Steum at a pressure of 28kpa is passed into a condenser and it leawes as condensate at a temperature of sac Cooling water circulates through the condenser at the rate of 45 kg/min - It enters at 152 and Veaves at 3oc If the Steam flow rate is 1.25 eg/min, determinė the drynes fraction of Steam as it enters the condenser.
Determine the heat transfer to cooling water passing through the condenser in KJ/Kg of steam condensed
Determine the heat added in the system and its final pressure.Nitrogen with a mass of 2.5 kg expands at a constant pressure. Theinitial pressure and temperature in the piston cylinder system is 170kPa and 27 oC, respectively. Because of the heat transfer, the systemreached a final temperature of 200 oC. Note R= 0.2968 kJ/kgK Determine:a. The heat requiredb. The workc. The change of enthalpyd. The change of internal energy
2. The actual specific evaporation of a certain boiler is 10. Factor of evaporation is 1.05. If the heating value of fuel is 30,000 kJ/kg, find the boiler efficiency. 3. Two boilers are operating steadily on 91000 kg of coal contained in a bunker. One boiler is producing 1591 kg of steam per hour at 1.2 factor of evaporation and an efficiency of 65% and another boiler produces 1364 kg of steam per hour at 1.15 factor for evaporation and efficiency of 60%. How many hours will coal in the bunker run the boilers if the heating value of coal is 7590 kcal/kg?
1. A cylindrical tank, 3 m long and 2 m in diameter is used for oil storage. How many days can the tank supply the engine having 27°API with fuel consumption of 60 kg/hr if the average tank temperature is 24°C?
Q.1. A refrigeration process with interstage cooling uses refrigerant HFC-134a, and the outlet of the condenser is to be saturated liquid at 40°C. Refer to the following figure for stream numbers in your solution. The pressure of the flash chamber and the intermediate pressure between compressors is to be 290 kPa. The evaporator is to operate at -20°C and the outlet is to be saturated vapor. The flowrate of stream 1 is 23 kg/h. The flash chamber may be considered adiabatic. The compressors may be considered to be 80% efficient. a) What is the power input required to the first compressor? b) What are the flowrates of streams 6 and 7? What is the enthalpy of stream 4? Hot Side 6 5 Condenser 2nd Stage Compressor Throttle Valve 7 Flash Chamber Vapor Phase Only 1st Stage Compressor 8 Throttle Valve Evaporator 1 2 Cold Side
With diagram .In a steam jet refrigeration system, the evaporator is maintained at 6°C. The chilled water leaves at the same temperature and warms to 11°C as it absorbs the load. Make-up water in available at 25°C. For a capacity of 50 tons, determine the volume of a vapor removed. Ans. (a) 8.381 kg/s, (b) 10.07 m3 /s
Refrigerant-134a is in an insulated canister with temperature 25 C. There is a partition in the canister so the refrigerant is a saturated liquid and takes up 1/100 of the volume of the canister. The rest of the volume is evacuated. When the canister is activated by squeezing (no work done activating) the partition breaks and the refrigerant fills the total volume. Final pressure is 100 kPa. a.) What are two assumptions needed for the problem? What properties are needed to solve part b.) and c.) b.) What is the change in specific enthalpy within the canister? c.) What is the final quality of the refrigerant within the canister?
When a hot coffee is poured into a cup, how much heat is lost from the coffee to the 200-gram cup (specific heat 0.20 cal/g-°C) in raising its temperature from 70 to 180°F? COMPLETE FBD SOLUTION AND REQUIREMENTS PS. THIS IS A HEAT TRANSFER PROBLEM
8. Air is compressed in a frictionless steady-flow process from 70 kN/m2, -29°C and a specific volume of 1 m³/kg to 100 kN/m² in such a manner that p(u+0.5)=constant, where v is in m³/kg. Inlet velocity is negligibly small and discharge velocity is 100 m/s. The flow rate is %3D 0.2 kg/s. Calculate the work required in kW. [ans: -5.49 kW]