Determine the SWR of a 300-ohm line whose load is 400 + j150 Ω

Q: A single phase bridge inverter has an RLC load with R= 20 ohms, L= 32 mH and C = 0.115 mF. The…

A: In this question we need to find the power absorbed by the load Po and the fundamental power Po1 .

Q: Compute the Fourier transform of the following signal - Σk=0 ak 8(t – kT), |a| < 1

A:

Q: 3. The error in a unity feedback system is the error e(t) = x(t) − y(t) where x is the input and y…

A:

Q: What will be the value of the Unknown inductance Lx (in mH) and the effective resistance Rx (in 2)…

A: Given a Maxwell inductance capacitance bridge circuit, R2=20 ΩR3=40 ΩR4=30 ΩC4=40 μF.

Q: What is the current thru R1? (Answer in Amps) Answer in Amps R1, 8 Ohms 71 V4, 56 Volts + 0 0 0 R2,…

A: We need to determine the current, I1 i.e through resistor R1 using Nodal analysis.

Q: Draw a schematic from a PCB obtained from the instructor or use the above picture of the PCB. The…

A: The given PCB layout needs to be converted into schematic diagram based on the component…

Q: Find the magnetic flux density at point P if a stable current I in the figure is directed towards…

A: The current flow is given as We need to calculate the Magnetic flux density at point P.

Q: 6 a) Determine the system function for the causal LTI system by using Z-transform: y[n] -1 y [n-1] +…

A:

Q: The movement of electrons under the effect of electric field is directed from: Select one: O a…

A: Electrons are the negative charges.  The movement of electrons under the effect of electric field.

Q: Calculate the percentage voltage drop for a transformer with a percentage resistance of 2.5% and a…

A: p.u. resistance=2.5%, p.u. reactance=5% Rating=500 KVA, 400 KVA @ 0.8 p.f. lagging, To Find- The…

Q: 11. A three-phase 420-kV, 60-HZ transmission line is 463 km long and may be assumed lossless. The…

A: Sending end voltage (VS) = 420 kV (line) Receiving end voltage (VR) = 700 kV (line) no load So, at…

Q: Draw a passive high pass filter, with an inductor L, resistor R, input voltage Vin and output…

A:

Q: Compute the Fourier transform of following signal 1 + cos πt, t ≤ 1 { |t| > 1 x(t) = 0,

A:

Q: 1. Consider the unity feedback system given by the block diagram below. X 2(s+1)/s H a. Find…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: Describe the working principle of loop/sense antenna in ADF. Then, draw the resulting radiation…

A: It is asked to describe the working principle of loop/sense antenna in ADF. Also we need to draw the…

Q: In Figure 16-8, the button on Floor A will operate the buzzer on Floor B. The button on Floor B will…

A: Two buzzers at two different floors operated by two buttons with three wire connection

Q: VOLO Amps 4.2 +j652 2.52 ig (t) = 10 cosine 377 t 2g Amps.

A:

Q: 4) a) A GaAs diode with V₁ = 4V C = 30 μF is given as the configuration on figure Vi 10 V a) Obtain…

A:

Q: k=70, ZL=j1000, and Zc-j402 in the circuit shown. Find the circuit's Thé venin equivalent circuit…

A: Consider the given circuit with the elements as below. To Find: A. VTH B. ZTH

Q: E₁ R2 = |R3 = VR1 VR2 = VR3 = www 12 Ω = 10 V R₂ 6Ω R3 units units units 5 V Find the voltage across…

A: Superposition theorem states that whenever circuit has multiple voltage source/current source we can…

Q: For the negative-feedback system the open-loop transfer function G(s) and feedback gain H(s) are X +…

A:

Q: 5. A three-phase rectification system has a voltage ripple of 14%. If the output kVp is 150, what is…

A: In this question we need to find the minimum voltage

Q: Problem 2 Rea R₁ www ww R₁ R₁ www ww R₁ Figure P2 Given the circuit in Figure P2 and that the…

A:

Q: d²y dy dt² dt - 6y= 1, y(0) = 1, d dt y (0) = 2

A:

Q: 2.20. By means of the signal-flow graph and Mason's theorem, find the transfer function of the…

A:

Q: Consider a wattmeter that is rated at 20 A, 50 V is having the following characteristics: Parameter…

A: A wattmeter rated at 20 A, 50 V- To find- The error in reading at the rated condition.

Q: 2=R÷jX 1. What is the definition of impedance? How to calculate impedance for resistor, inductor and…

A: given that voltage applied  V = 10 cos2t+30° V frequency  ω = 2 radians

Q: Q1) For the circuit shown below, the Op-Amps are ideal. a) Find V₁, Vo1, V₂, and Vo, 5V 5 ΚΩ 5 ΚΩ V₁…

A:

Q: A synchronous generator connected to infinite bus is supplying half of the maximum power which is 1…

A: A synchronous generator connected to infinite bus is supplying half of the maximum power which is 1…

Q: A three phase inverter has a Y-connected load. The inverter frequency is fo= 60 Hz and the DC input…

A:

Q: What is the node voltage, v4? (In Volts) Note that v0 is grounded. Answer in Volts v1 v1 v1 R1, 16…

A:

Q: A three phase inverter has a Y- load. The inverter connected frequency is fo= 60 Hz and the DC input…

A: In power electronics, the distortion factor (g) is the ratio of the RMS fundamental value to the…

Q: The symbol Oground Olighting panel power panel time switch represents

A: Symbols of  Ground  Lighting panel Power panel Time switch

Q: Dran Bode Plot Grejs = 5 (jw+i) (jow) ³ (0.1 jw²+1)

A:

Q: The low voltage side of a particular transformer has 747 turns while its high voltage side has 69471…

A: Transformer primary turns (N1)=747   Transformer secondary turns (N2)=69471   secondary impedance is…

Q: 30) Given circuit below: e = 7.07 sin ut E = 5V 20° ZT Ⓒ I + VR R www 1 ΚΩ L 20 mH VL a) Find…

A:

Q: An RLC electrical circuit consists of a resistor (resistance R), an inductor (inductance L) and a…

A: The ODE is given as LdIdt+RI+QC=0      ...1I=dQdt     ...2Now, we need to solve the above ODE to get…

Q: A current of 5 amp flows for 10 minutes through a resistance of 100 ohms. Find the heat dissipated.

A: Step-1-&gt; We have , I=5 amp R=100 ohm t=10 minutes t=10×60 t=600 sec

Q: The circuit parameters in the circuit in (Figure 1) are R = 500 M, L = 250 mH, C = 250 nF, and Idc =…

A: In this question we need to find the current io(t) for t&gt;0

Q: a) The circuit below has three resistors with values R₁-10 S2, R₂-20 S2, R3-30 S2, one initially…

A:

Q: Problem 5 Vs Vac a R₁ + www R2 www Vab wwwwww R3 Rx b Vb Figure P5 = In the Wheatstone bridge…

A: Wheatstone bridge , R1 = 10k  R2 = 2k R3 = 15k To find Rx

Q: V1 10V VR1 = VR2 = R1 5ΚΩ Hill V2 5V Find the voltage across and the current through each resistor…

A:

Q: 6.. The phase voltage of a 3-phase voltage source is 120 V. It is supplied to a star connected load…

A: Phase voltage VP=120 V. Load impedance connected Z=36+j48 Ω.

Q: List the visual checks that should be made on a piece of portable electrical equipment before using…

A: We need to write list of visual checks that should be made on a piece of portable electrical…

Q: Solve for the current in this circuit. Give its phase angle and write it as a phasor. V1 20 V 1 kHz…

A: In this question we need to find the phase angle and the current I in phasor domain

Q: For an unloaded generator the line-to-line voltage at terminals of b with respect to c is 13.8<-80°…

A: Let us assume that a balanced three-phase system, the voltage between any two phases is related to…

Q: For the circuit below, find: 1) i0 2) i1 3) i2 4) vΔ.( Need handwritten solution only please…

A:

Q: A 13320 / 370 volts, 62 hz, 160.95 KVA step-up transformer is connected to a source having a line…

A: Transformer specification 13320/370 volts  62 Hz 160.95 KVA

Q: 2k Vout

A:

Q: Q.19 Determine the optical power received in dBm and Watts for a 24 km optical fibre link with…

A: Length of the fibre L=24 km,LED output power Pt=20 mW,PtdBm=10log1020×10-31×10-3=13.01 dBm,α=0.6…