Assessment 2Directions: Write ULTRA if the statement is correct, and VIOLET if not. If the statement isincorrect, state reason or appropriately correct the statement.1. Too much exposure to UV rays may increase the risk for skin cancer and cataracts.2. Sunscreens protect our skin so we can stay under the sun all day.3. The higher the Sun Protection Factor (SPF) in a sunscreen, the higher the protection.4. Sunglasses have UV coating that help block harmful rays from the sun.5. It is good to avoid the sun entirely.

Directions: Write ULTRA if the statement is correct, and VIOLET if not. If the s incorrect, state reason or appropriately correct the statement. 1. Too much exposure to UV rays may increase the risk for skin ca 2. Sunscreens protect our skin so we can stay under the sun all da 3. The higher the Sun Protection Factor (SPF) in a sunscreen, the H

Directions: Write ULTRA if the statement is correct, and VIOLET if not. If the s incorrect, state reason or appropriately correct the statement. 1. Too much exposure to UV rays may increase the risk for skin ca 2. Sunscreens protect our skin so we can stay under the sun all da 3. The higher the Sun Protection Factor (SPF) in a sunscreen, the H

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter9: Optics

Section: Chapter Questions

Problem 7Q

See similar textbooks

Similar questions

Would the critical angle for a glass—water interface be less than, equal to, or greater than the critical angle for a glass—air interface? Siw?
points) Object Image: Height: Magnification: 2f SS34L draws L. of focal length 5 cm. (12 ALVIN 2f ope 2. An EM wave has a wavelength of 150 nanometers. ( a. (a) What is the frequency of this wave? b. (b) What type of EM wave is this? C. If a photon from this wave has the same frequency as (a); find its energy. Princ axis
Experimental process: 1. Take a piece of chromatography paper (or filter paper/ paper towel). Draw a pencil line across it about 1 cm from one end. Using colored markers (pentel pen), place small spots of color on the center of the line. 2. Put water in the glass container to a depth of about 0.5 cm. 3. Tape the chromatography paper in a pencil and hang it in the glass container so that it dips into the water but with spots of color above the water level. Pencil -Paper clip -Strip of filter раper -Jar -Srip of filter раper -Spot of ink -Line drawn by pencil -Water Spot of ink (a) (b) https://www.topperieaming.com/answer/how-will-you-separate-dyes-in-black-ink-using-chromatography-explain-t-with-the-help-of-a- diagram/spxgq7155 2 2. Allow the water to rise up the paper until it is almost to the top. 3. Remove the paper, mark where the water reached (solvent front), and hang it up to dry. 4. When dry, measure the distances moved by the spots and the solvent front.
Monica was using different colored pieces of clear plastic for an art project Her little brother came and scattered the plastic all over the photograph of Name Name Class Date Name 20 the the image she was using as a guide. As she was cleaning up, she noticed that the image appeared differently behind certain colors of plastic. Why was this A. Certain colors of light pass through, leaving everything else blank or invisible. B. Only the color matching the plastic can pass through, leaving everything else shades of black. C. Only the color matching the plastic can pass through, leaving everything else blank or invisible. D. All colors except the one that matches the plastic can pass through, leavng. that color black
What is the minimum data set that can be interpreted to yield two depths for a 1-interface model?a. One shot into one end of a line of geophones.b. Two shots; one at each end of the line.c. One shot at each end of the line and one at it’s centre.d. As many shots as it takes to get a refraction arrival at every geophone from both directions.
No Spacing Heading Normal Paragraph Styles 3. You're in a room (with no windo it up by "white" light coming from a light bulb. a. What colors of light are being produced by the light bulb? (Hint: the possible colors are red, green, and blue) b. A toy fire truck in the room appears red. What colors of light is the truck reflecting? What colors of light is the truck absorbing? Explain. c. The walls of the room appear blue. What colors of light are the walls reflecting? What colors of light are the walls absorbing? Explain.
1) Listen Base your answer to the question on the diagram below, which represents a ray of monochromatic light (f = 5.09 x1014 hertz) in air incident on flint glass. Normal 35° Air Flint glass What happens to the light from the incident ray that is not refracted or absorbed? 1 It is reflected and converted to mechanical energy. 2. It is reflected, absorbed and some energy is lost. 3. It is all destroyed. 4. It is slowed down, dissolved and reflected.
Which of the ff. is true about measuring light scattering inturbidimetry? a.) The amount of scattered light is measured at different angles from the sample holder.b.) The amount of scattered light is measured at 90-degree angle from the sample holder only.c.) The amount of scattered light is measured at 135-degree angle from the sample holder only.d.) The amount of scattered light is measured at 180-degree angle from the sample holder only.
Two lamps of 25 and 50 candelas are 100 cm apart. How far from the 25 cd lamp will a screen be equally illuminated on both sides? a. 43.7 cm b. 41.4 cm c. 58.6 cm d. 56.3 cm
7. What happens when the incident angle is greater than the critical angle? Please describe least two complete sentences. 8. This phenomenon is called Total Internal Reflection (TIR). What do you think would be some practical purposes of TIR in modern technology? Please name at least one example and explain your answer in at least two complete sentences.
A prism spectrograph uses a triangular piece of glass to spread light out into its component colors. Which of the following explains how the visible wavelengths of light are affected by a prism spectrograph? a. The angle of bending is the same for all colors (wavelengths). b. Red light is bent the most and violet light is bent the least. c. The angle of bending depends on the color (wavelength) of the light. d. The order of the colors, red through violet, depends on the type of glass used for the prism. e. None of the above are correct.
The color of an opaque object is the color of the light it ________________. a. absorbs b. reflects c. scatters d. transmits