Discuss the method of balance detection for locating partial discharge in electrical equipment. High voltage engineering

Q: 7) how to decease the ripple voltage of cockroft-walton voltage multiplier circuit

A: . In the diagram a multistage single-phase cascaded circuit of the Cockroft - Walton type. No-load…

Q: example open loop system

A: In this question we discuss about open loop system

Q: Why isn’t a short circuit necessarily a shock hazard? Support your answer with an example.

A: A short-circuit occurs when a faulty insulation wire carrying a current touches the neutral wire.…

Q: Identify and explain the different notational methods for describing the behavior of gases and…

A: Gates: It is an electronic circuit and has logical decisions based on applied input.

Q: Developments that could happen in power flushing in the future

A: to developments that could happen in power flushing in the future

Q: What is meant by FACTS in power systems? Discuss about UPFC type FACTS device.

A: FACTS stands for Flexible Alternating Current Transmission System. It is a system composed of static…

Q: Q1.Write the construction and working principle of DC Machines.

A: Electrical machines can be either generator or motors. They can be either Ac machines or DC…

Q: What impressions and assumptions can be made about the environmental technology on waste management

A:

Q: How does one determine the coordinating time between a protective device and a downstream device?…

A: The protective devices should be subjected to minimum overcurrent in minimum time to accomplish…

Q: What relation exists between the primary and secondary currents and turns? Subject Electrical…

A:

Q: What is metastability? How to avoid this.

A: Flip flop is a latch with additional control input (clock or enable ). A flip flop is used to store…

Q: What is meant by FACTS in power systems? Discuss about UPFC type FACTS device

A: Power system- Power system is basically the interconnection of several components right from the…

Q: What is Ohms law? Explain with examples

A: Define Ohm's Law

Q: 2. Standing Waves describe governed by this principle 1. states that 3. Beats define 4.

A: 1) Beats and standing wave are made by superposition of wave, (principle - superposition of waves)…

Q: Explain in brief the skin effect in power system.

A: In the conductor, the availability of the alternating current at the surface is greater and this…

Q: In 1958, the nuclear energy was conceptualized and later in in 1979 Bataan, Philippines nuclear…

A: Nuclear Power plant : nuclear power plant is thermal power plant which have nuclear reactor as a…

Q: State the condition for the stability of a linear system.

A: Linear system:- If a system satisfies the superposition theorem or additivity and homogeneity both…

Q: Q) give 5 to 10 reasons when the steady state error happened Subject name control system engineering

A: Given; Steady state error

Q: After the determination of the currents references, can we connect the ammeter terminals in any way…

A: Because Current is a vector, it will also have a direction. Positive and negative terminals will be…

Q: State and explain Paschen’s law. How do you account for the minimum voltage for breakdown under a…

A: Paschen's Law: Paschen's law is an equation ,that gives the breakdown voltage ,that is the voltage…

Q: What do you call the power angle made by the current produced at the core of a transformer?

A: The tranformer basic problem can be solved easily as shown below.

Q: write the COMPONENTS AND ITS FUNCTION of stair climbing trolley

A: The different components with their respective functions of a stair climbing trolley are given…

Q: Discuss the operating principle of the hydroelectric power plant

A: Hydroelectric power plant is an electricity generating power plant which uses potential energy of…

Q: Explain the concept of absolute stability in non-linear system. Also state and explain the Popov…

A: Stability means that the system outputs and its internal signals are bounded within admissible…

Q: 6. Discuss the present practice in neutral grounding.

A: The neutral of the system or rotating system or transformer is linked to the ground in a neutral…

Q: Explain how: Ohm's law relates to our Core Concept of flow-down gradients.

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Discuss / Explain the operational process and show flow diagram including major equipment of a…

A:

Q: What is the application and rating for extra super tension

A: Extra super voltage cables: These are used for applications with voltage requirement above 132 kV

Q: Discuss the method of reducing to an economically and operationally acceptable level the cost and…

A:

Q: (a) Briefly explain what is the per-unit system. (b) A resistance of 600 is selected as the base…

A: Disclaimer:  Since you have asked multipart questions, we will solve the first three subpart for…

Q: Explain the DC power internal structure.

A: DC or Direct current Direct Current (DC) Power is the unidirectional flow of electrons and is the…

Q: What is Skin Effect? Why does it happen in Power Systems.

A: Distribution of current is uniform in a DC system. Skin effect is a phenomenon that takes place in…

Q: Describe the ultimate cycle method, including the satisfactory perfor- mance. Also briefly discuss…

A: For system the maximum slope line starts at its origin , the delay is identified as the time at…

Q: What voltage will be required to produce a flow of 15A, through a resistance of 12 ohms?

A: Ohm's Law :    Ohm's law states that the voltage or potential difference between two points is…

Q: 7. What system characteristics are being considered in the final form of the design that must…

A: While designing of any equipment few standard parameters needs to be taken care such as Flexibility…

Q: block reduction method,

A: for block reduction, here 3 block rules r used:

Q: Please discuss the potential risks of the electrical machines to the environment and the important…

A: Please discuss the potential risks of the electrical machines to the environment and the important…

Q: Discuss typical structure of the modern electrical grid. Include all elements and provide short…

A: An electrical grid is an interconnected network for electricity delivery from producers to…

Q: (a)Using the current sheet concept derive the peak value of mmf of a machine in terms of uniform…

A: Current sheet concept: It was seen over that a distributed winding brings about an MMF wave in…

Q: Identify and describe the step-by-step process used to pull cable and the step-by-step process used…

A: Installing cables in buildings is very essential. It helps in proper access of the electrical…

Q: comment on the stability of systems Comment on the response to a step

A: Stability of Linear Time-Invariant System may be defined as 'When the system is subjected o Bounded…

Q: please write introduction about AC Circuits and Parallel Circuits

A: Ac circuits Generally, series A.C circuits are of 3 types-      R-L series A.C circuit  R-C series…

Q: As an electrical engineer how can you help preven the destruction of habitat of animals?

A: There are many ways in which we can prevent the destruction of habitat animal but in taking the view…

Q: Briefly explain the Vertical integration in electricity regulation

A: The traditional definition of a "vertically integrated" in electricity regulation is that which owns…

Q: Briefly explain the application of thermodynamics in electrical engineering.

A: The detailed answer is solved below according to the given parameters and instructions in the given…

Q: Q2]] write swing equation (P. U.) for Power system stability. Q-LAB Site cop, v Define stability and…

A: when disturbance happens in the power system, The accelerating power changes Accelerating power is…

Q: What are the differences between wrinkle method vs DO meter (advantages vs disadvantages)?

A: Different energy sources are required in day to day life. These energy sources can be renewable or…

Q: The positioning block diagram of the welding tip is given in the following figure. Of the system…

A: