draw the orthographic projection includes the views from the front, top, and left of the object. The arrows indicate the direction of the front view. The unit of dimension is in millimeters. The drawing should be drawn on A4 paper ( scale 1:1) using a pencil Figure 2 30 15 20 L15 15 15 20 D15 10 70 100 50

draw the orthographic projection includes the views from the front, top, and left of the object. The arrows indicate the direction of the front view. The unit of dimension is in millimeters. The drawing should be drawn on A4 paper ( scale 1:1) using a pencil Figure 2 30 15 20 L15 15 15 20 D15 10 70 100 50

Architectural Drafting and Design (MindTap Course List)

7th Edition

ISBN:9781285165738

Author:Alan Jefferis, David A. Madsen, David P. Madsen

Publisher:Alan Jefferis, David A. Madsen, David P. Madsen

Chapter2: Architectural Drafting Setup

Section: Chapter Questions

Problem 2.31Q

See similar textbooks

Similar questions

8 mm mm DETAİL B a=300 mm b=120 mm c=90 mm 0=55°
Subject: Engineering Drawing or AutoCAD Instruction: Draw the 2D Orthographic Projection (Front, Top, and Right or Left Side Views) of the indicated 3D Drawing (Isometric View). You can frechand draw or use AutoCAD. Note: Indicate the Dimensions. TOP 50 930 915 2holes RIS 59 26 63, **units in mm FRONT
Use Scale ( 1:1 ), for the front and side views shown draw the isometric projection 22 19 38 18 45 22 66 102 1.57 t
4. An object in isometric view is given as in Figure 3. Draw the object in Third Angle Projection at a scale of 1:1 on an A3 size drawing paper. Draw the border, title block and dimensions. 10 10 30 10 30 20 20 30 10 20 10 20 30 50 30 20 30 08, Front View Figure 3: Object in Isometric View (All dimensions in millimeter)
Detail drawing is a multiview representation of a single part with dimensions and notes. Select one: O True O False
Draw the full sectional front view, as well as draw the top view and side view of the object as shown in Figure. TOP R35 Ø20 le30 SIDE 50 20 65 20 170 FRONT
Draw half sectional Front View and Top View of the following component
Clear selection 10. Which of the following is correct in dimensioning a drawing? a. Dimensions should be placed between views b. Dimension lines can cross extension lines c. Dimension should cross other views. d. Can be repeated anywhere in the drawing. 11. This is a drawing that shows more than one view of an object. a. Auxiliary b. Multiview C. isometric d. perspective O O O
Draw the figure to an enlarged scale in Isohyetal method
Using the miter line provide the Front View, Top Side View and Side View of the given object. Provide also the given dimension on each view
Additional Problem #2 30 mm Locate the centroid of the cross-sectional area at right. Sketch the cross-sectional area to scale and show the location of the centroid on your sketch. Show the scale on the drawing. 40 mm 50 mm For problems 6.2 and addl. #2 use Table 6.1 in OK (Section 6.1 posted on Canvas) 60 mm 100 mm
Given this orthographic projection of the object, draw the isometric view. Units are in millimeter. Draw must be details. Include the dimensions in drawing.