e pressure

Q: Norepinephrine can be metabolized to the following metabolite in two steps as shown below. What…

A:

Q: Which of the following protons (marked as Ha, Hb, Hc, and Hd) will most readily be abstracted by the…

A:

Q: According to the following figure, an adequate end-point for the titration of calcium with EDTA…

A: End point is the point where the indicator changes colour and we know that this point Comes after…

Q: about heat conduction Task 1: . What happens to the temperature of a well-insulated room, if a…

A:

Q: Use bond dissociation energies to calculate the A to produce ethyl acetate and water. (Hint: you ne

A: Use bond dissociation energies to calculate the ∆Erxn in kJ for the reaction of acetic acid with…

Q: Calculate the molality of a solution that contains 70g naphthalene C10H8 in 100 g of water. The…

A: Given :-  Mass of naphthalene = 70 g  Mass of water = 100 g  To calculate :-  Molality of solution

Q: If the value of the blank solution is equal to 7.0 g/cm3 while the salt concentration is 9.7 g/cm3.…

A: Solutions- The Seta Salt in Crude Analyser is a reliable and portable instrument for evaluating the…

Q: What is the potential after the addition of 60.00 mL of 0.05000 M Sn to 50.00 mL of 0.1000 M V^.…

A: Nernst equation is an equation that can be used to determine the reduction potential of an…

Q: a) Draw the product(s) of the reactions below. Show the movement of electrons using curved arrows…

A:

Q: (a) Discuss the assumption of Langmuir adsorption isotherm. Obtain an expression for the amount of…

A: Langmuir proposed Adsorption isotherm which explains the variation of Adsorption with respect to…

Q: Draw the structural formula for 5-ethyl-3,4-dimethyloctane.

A: In this question we have to tell the structure of 5-ethyl-3,4-dimethyloctane.

Q: at pressure (unit atm) will

A:

Q: A galvanic cell is constructed as follows. One half-cell consists of a platinum wire immersed in a…

A: A galvanic cell is constructed as follows. One half-cell consists of a platinum wire immersed in a…

Q: 8) NH2 ether, 10 % NaOH Step 1 ether NH 6 M HCI Na,SO.. gravity filtration vacuum filtration aq…

A:

Q: Suppose 60.0 mL of 0.100 M Pb(NO3)2 is added to 30.0 mL of 0.150M KI. How many grams of Pbl2 will be…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: A chemical engineer is studying the two reactions shown in the table below. In each case, he fills a…

A: A reaction is spontaneous when ∆G is negative. A reverse reaction is spontaneous when ∆G is…

Q: When 634. mg of a certain molecular compound X are dissolved in 60. g of cyclohexane (C,H,2), the…

A:

Q: A classmate asked you to look at a direct synthesis of curcumin using vanillin and 2,4-pentanedione.…

A: Given that, the synthesis of Curcumin from vanillin and 2,4-pentandione. We have to tell whether the…

Q: Record and calculate the missing data. Use the Level 0 and 1.0 M concentrations of the simulation.…

A: The chemical species having higher reduction potential undergoes reduction and acts as cathode The…

Q: Silver(1) iodide is more soluble in 0.1 M KNO3(ag) than in pure water. Select one: O True O False

A: Silver Iodide (AgI) is practically insoluble in water. This is because of the presence of more…

Q: Draw three resonance structures for carbonate ion, CO32-, and assign formal charges  on all the…

A:

Q: Assuming that the concentration of NaOH is 0.1M Analysis of acetic acid   Trial   1 2 Volume…

A: Given: Concentration of NaOH = 0.1 M

Q: Physical Properties                                              Odor                     Physical…

A:

Q: What is the structure of the main product produced by the following reaction? Br NaOMe Меон Br…

A:

Q: 1. Give the chemical structure of Diethyl ether 2. What happens to the body if you ingest/are…

A:

Q: concentration

A:

Q: Which of the following is most likely to increase the pH of an aqueous solution of CH3COOH? O Adding…

A: The question can be answered by observing the dissociation pattern of acid as well as additive.

Q: At 298 K, what is the Ko of the reaction shown below given that its Kp is 6.26 x 10-6? CH4(9) + 2…

A: Given :: Kp = 6.26×10-6  @25℃ = 298 K Kc= ?

Q: A solution that contains 3.52 x 10° M of Pb" and 5.18 x 10* M of l'is unsaturated and will not lead…

A: Given: Concentration of Pb2+ = 3.52 × 10-5 M  And concentration of I- = 5.18 × 10-4 M

Q: d. Which average molecular weight determination did the fraction 3 most significantly affect and…

A: We have to give the answer of the given questions. D. We have to tell which molecular weight…

Q: Lili's experiment involves complete combustion of 0.100 mole of 2-heptanol, C7H160. A. How much…

A: Given:: Moles of 2-heptanol = 0.100 moles Mass of CO2 = ?, MM= 44g mol-1 Mass of O2 = ?, MM= 32 g…

Q: Ozonolysis-reduction of an unknown alkene gives an equimolar mixture of cyclohexanecarbaldehyde and…

A: In ozonolysis the double bond is broken in corresponding aldehyde or ketone by using O3 and Zn/H2O.

Q: The delat H for the solution process when solid sodium hydroxide dissolves in water is -44.4 kJ/mol.…

A: Given: Mass of water = 250.0 g. Mass of NaOH dissolved = 10.1 g. Initial temperature of the solution…

Q: For the reaction shown below at 25 °C, which of the following will shift the equilibrium position in…

A: Le Chatelier's principle: This principle is used to predict the effect of a change in conditions on…

Q: What is the pH of the solution when 20.0 mL of 0.155 M of NH3(aq) is titrated with 15.0 mL of 0.225…

A:

Q: Solid aluminum hydroxide (Ksp = 1.3 x 10-33) is added to 3.50 mM Al(NO3)3 solution until there are…

A:

Q: Q4. Identify the acids and bases in the following equations and explain your reasoning: a) HCl(®) +…

A: Since you have posted a question with multiple parts,we can solve only first three parts for you. If…

Q: It required 20.1 ml of an aqueous HCl solution to react completely with 0.1060 g N22CO3 (105.99…

A: Molarity (M) :-  The number of moles of solute dissolved in one litre of solution is known as…

Q: The normal boiling point of a certain liquid X is 115.90 °C, but when 47. g of zinc chloride (ZnCl,)…

A: Given: The normal boiling point of liquid X = 115.90 ∘C The mass of ZnCl2 dissolved in 550 g of X =…

Q: If you start with 135 mg of acetone, what mass of NaBH4 in mg do you need? To account for some of…

A:

Q: 5-3. a. Draw out an empty generic (lollipop shaped) homonuclear diatomic MO diagram like the one…

A:

Q: Express the equilibrium constant (Koverall) for the dissolution of Ag2CO3 in acidic solution (as…

A:

Q: CN HO, но, KAL KEL KOL KUL 19. the most reactive toward EAS 20. an ortho-disubstituted benzene…

A:

Q: chemical formula of the following complex ions.

A:

Q: A 335 −mL−mL can of soda pop contains 44 gg of sucrose (C12H22O11C12H22O11). Part A What is the…

A:

Q: 3) Balance the following redox reaction if it occurs in acidic solution. MnO4 (aq) + Fe(s) Mn2+(aq)…

A: You follow a series of steps in order: 1. Identify the oxidation number of every atom. 2. Determine…

Q: What is the concentration of CrO42- required (molarity) in a solution that is 0.002 M in Ba2* in…

A: Given: The Ksp of BaCrO4 = 8.16×10-11 The concentration of Ba2+ = 0.002 M We have to calculate the…

Q: The Kap expression for the dissolution of TI;Cr0, in water is K= [TI**]?{Cro²j*. Select one: O True…

A: The solubility product constant is the equilibrium constant for the dissolution of a solid substance…

Q: 2. AG° is -32.7 kJ/mol of N2 for the reaction at 100°C Na(g)+3H2(9)=2NH3(g) Calculate AG for the…

A: The reaction given is, => N2 (g) + 3 H2 (g) ↔ 2 NH3 (g)  Given: ΔGo at 100 oC = -32.7 KJ/mol =…

Q: Name the alkane, CH3CH2CH(CH3)CH(CH3)2 Express your answer as the IUPAC name

A: Rule of IUPAC- 1) Longest chain as parent chain. 2) Numbering start from those side where more prior…

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.