Answered: Ex : What is the value of the force (F)…

Ex : What is the value of the force (F) required to balance the system in the figure? M = 5 kg and F makes and angle (O =37°") below 3 m 2 m OM Answer: ET about center = 0 ITMl + |T = 0 %3D

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 82A

See similar textbooks

Related questions

Q: A1 450-kg automobile has a wheel base (the distance between the axles) of 2.80 m. The automobile's…

Q: What is the value of the force F (N) required to balance the system in the figure? M=5 kg and F…

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

Q: Which of the following is always true of a lever system in equilibrium? A The force of gravity on…

A: In a lever system , with respect to the fulcrum the fulcrum the total torque about any point is…

Q: The arm in Figure P8.17 weighs 41.5 N. The force of gravity acting on the arm acts through point A.…

A: Draw the free body diagram of the arm and show the components of the forces Ft and Fs as well.

Q: In an isometric exercise a person places a hand on a scale and pushes vertically downward, keeping…

Q: When tightening a bolt, you push perpendicularly on a wrench with a force of 156 N at a distance of…

A: Given, F = 156 N d = 0.12 m Torque = F*d*sin A Since the force is applied perpendicular to the…

Q: In the figure below, if my 3m2. What is the ratio x2/ xt which keeps the system in equilibrium? m, X…

A: Relation between the masses :m1 = 3m2

Q: > Bing Inbox (19) - mwboutin@gma x Uh-oh! There's a problem wit × A steel wheel is mounted on OSu…

A: a) The expression for the mass of the disk is, The expression for the moment of inertia is,

Q: What is the value of the force F (N) required to balance the system in the figure? M=12 kg and F…

Q: Q1. A 750-pound boat sits on a ramp inclined at 60 degree, what force is required to keep the boat…

Q: The mass center Gof the 1200-kg rear-engine car is located as shown in the figure. Determine the…

Q: 1) To loosen a pipe fitting, a plumber slips a piece of scrap pipe (a “cheater") over his wrench…

Q: A 20.0-m-long uniform beam weighing 880 N rests on walls A and B, as shown in the figure (Figure 1).…

A: a) Consider that point B is in the midway of the beam. Apply the equilibrium condition of the moment…

Q: A device for exercising the upper leg muscle is shown in Figure shown, together with a schematic…

A: Here according to the first condition of equilibrium, the net force on system is zero and according…

Q: 3. Auniform beam of length L and mass Mhas its lower end pivoted at P on the floor, making an angle…

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

A: Mass of object = 9 kg Theta = 37 degree Value of g = 10m/s2

Q: ACTIVITY 2B: Three Torques (Make sure to indicate the direction of all forces in the diagram.) Fen…

Q: A pencil rests against a corner, as shown below. The sharpened end of the pencil touches a smooth…

A: Given Data: The coefficient of static friction is, µs=0.80 The center of mass of the pencil is…

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

A: C. 375

Q: 8. Two masses are attached to a uniform meter stick as shown in the figure below. The masses of m1…

Q: What is the value of the force F (N) required to balance the system in the figure? M-2 kg and F…

A: Given, M=2 kg The angle of force=37 degree we have to find force F

Q: Time lef What is the value of the force (F) in the unit of N required to balance the system in the…

A: The force in the unit of N required to balance the system. given,

Q: f the net

Q: E10. A weight of 8.0 N is located 12.0cm from the fulcrum on the beam of a simple balance. What…

A: Torque = F×r

Q: Given: The four forces and F = 200 N geometry shown. 6 m F2 = 600 N Find: The force F5 required to…

A: Given are the magnitudes of the following forces : F1= 300 N ; F2= 600 N ; F3 = 900 N ; F4 =…

Q: What is the value of the force F (N) required balance the system in the figure? M=13 kg and F makes…

Q: 4. Determine the product of inertia of the area shown with respect to the x and y aXEs. (Ans. Pxy =…

Q: I have three forces acting on some arbitrary object as given in the table below: F Fy Force 1 10 [N]…

A: Given Force Fx Fy F1 10 15 F2 -5…

Q: What is the value of the force F (N) required to balance the system in the figure? M=19 kg and F…

A: Option B is the right answer 450 N force required to balance the system

Q: A 3.0-m-long rigid beam with a mass of 100 kg is supported at each end, as shown. An 80 kg student…

Q: What is the value of the force F (N) required to balance the system in the figure? M=19 kg and F…

Q: Two masses are attached to a uniform meter stick as shown in the figure below. The masses of m1 and…

A: For the balance of the given system we must have i)Total force on the system along the horizontal…

Q: using this tool from…

A: The masses to be balanced net torque about any point in the space must be zero. Write the formula…

Q: A1 530-kg automobile has a wheel base (the distance between the axles) of 2.70 m. The automobile's…

Q: E 30 cm - 40 cm 30 cm - 3) In the figure shown, M2 has a mass of 2 kg, M3 has a mass of 8 kg.…

Q: 5. A gymnast rises onto her toes, as shown in the picture on the right. The floor pushes up on the…

A: Analyze the free body diagram. Consider the clockwise direction to be positive and the…

Q: Quèstion 1 In the figure below, which of the following equations is correct according to the first…

Q: 6. A yoyo is dropped as shown in the figure below. Neglect air friction. The mass of the yoyo is…

Q: The weights W1 and W2 in the figure are in rotational equilibrium. Which of the following statements…

A: The two given weights are w1 and w2The distance of w1 from the pivot point = L1The distance of w2…

Q: 2. Use the equilibrium conditions to find the weights w1, w2, and w3 required to balance the mobile.…

A: different weights are hung on the arrangement as shown . To find : the values for w1 , w2, w3

Q: if the weight of the meter stick is 10 N, what must be the weight W₂ approximately? If W₂ is placed…

A: Given Data:- Weight of the meter stick is Ws=10 N is placed at d1=15 cm of the stick. The system is…

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

A: Mass= 6 Kg

Q: A father lifts his child as shown in Figure shown. What force should the upper leg muscle exert to…

A: Suppose the father lifts the child and according to the figure we have certain values as written…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

Fg 120000 N
FA+FB 165000
%3D
FA+120000= 165000
FA=45000 N
Ex : What is the value of the force (F) required to balance the system in
the figure? M = 5 kg and F makes and angle (0 =37°) below
3 m
2 m
OM
Answer:
ET about center 0
ITMl+ITpl 0
%3D
71Page

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 80-kg block is suspended as shown. The beam is weightless and is hinged to the wall at A. The tension force of the cable T has magnitude: (Use g = 9.8 m/s2) %3D T. 3m A 4m block O a 980 N Ob. 817 N Oc. 1143 N Od. 620N O e. 1307 N
atics 0.4 m. B 15 m L0.4 m 0.8 m 1.5 m 15m Three vertical wires are used to support a rectangular plate which weighs 500 N. Determine the tension in the wires.
Figure P8.27. Find the tension in each rope when a 700.-N worker stands 1.00 m from one end? e2cm lon ropes, as indicated by the blue vectors in 27. VA uniform plank of length 2.00 m and mass 30.0 ke by three ropes, as indicated by the blue vectors in supported Figure P8.27. Find the tension in each rope when a 700 N person is d = 0.500 m from the left end. er of gravig fo 12, modeling rethooran 8 B of model 10.26 T, T2 0.250 Theatthe le 40.0° lid or boln vibbud ns bano sdi svode m81 o + d » 3. 2.00 m di In bas rirob be ss gairda Figure P8.27 goil sdrto idgiod oh bail rel 2 00 bou d 28. A hungry bear weighing 700. N walks out on a heam in
A 50-kg block is suspended as shown. The beam is weightless and is hinged to the wall at A. The tension force of the cable T has magnitude: (Use g = 9.8 m/s²) 3m -4m block O a. 620 N O b. 980 N O c. 1143 N O d. 817 N e. 1607 N
What is the value of the force (F) in the unit of N required to balance the system in the figure? M=8 kg and F makes an angle (0 =37°) below horizontal. g 10m/s2. 3m 2 m IM A. 400 B. 100 C. 10-2 D. None OAO m OUOD OE
The forces are in static equilibrium. The 140 lb force is directed along the x-axis and the 300 lb force is directed along the negative z-axis. What is the angle between R and the z-axis? Provide your answer in degrees, but do not include units in your answer. Z X R ex лог 140lb A 1-50, 80, 160) lb By 300 lb Y
A. Problem Solving Instruction: Read each problem carefully and calculate all required. Show your complete, clean and correct solution and figures.
The see-saw is balance.d What is the magnitude of the weight of the person hanging off the edge? 4m- 2m. LIST = N 11 WT-500 N
A uniform horizontal beam with a length of 8 m and a weight of 200 N is attached to a wall by a pin connection. Its far end is supported by a cable that makes an angle of 53° with the beam. If a 600-N person stands 2 m from the wall. What is the tension in the cable? 53.0% 8.00 m OA. 410 N OB. None OC. 313 N D. 196 N E. 502 N
Physics for Engineer. 1. A 50.0-N body is supported by two ropes, one making 30.0o with the vertical and another making 45.0o with the horizontal as shown in the figure. What is the tension in the ropes?
What is the value of the force (F) in the unit of N required to balance the system in the figure? M=6 kg and F makes an angle (0 =37°) below horizontal. g = 10m/s² . 3 m 2 m F А. 150 B. None С. 75 D. 5. V6 E. 300
The forces are in static equilibrium. The 140 lb force is directed along the x-axis and the 300 lb force is directed along the negative z- axis. Determine the magnitude of the unknown force, R. Z X R Ox лог 140lb A (-50, 80, 160) lb By 300 lb у