MULTIPLE CHOICE. Choose the one alternative that best completes the statement or answers the question.Vcc=+12 VV₂100 mV1.0 kHzPPA) 10 kQC₁2.2 µFA) 23 HzB) 5.7 kR₁{56 ΚΩFigure 1 (Assume re-1502)15) Refer to Figure 1. Rin is approximatelyB) 13 HzR₂*10 ΚΩwwDC) 3.2 kΩRe4.7 ΚΩC) 40 Hzl₁B <-150ac16) Refer to Figure 1. The cutoff frequency due to C1 isREI100 £2RE2560 ΩD) 1.8kQD) 7.2 HzC, Von0.47μFC₂• 100 μεR₁15)16)17) Refer to Figure 1. Assume that Cbc-6 pF and RL-27 kQ. The Miller input capacitance due to Che is 17)_A) 49 pFB) 7.0 pFC) 168 pFD) 216 p18

For the given circuit we have to calculate the input resistance, cutoff frequency due to capacitor…

Figure 1 (Assume re-1502) 15) Refer to Figure 1. Rin is approximately A) 10 kQ A) 23 Hz C) 3.2 k Β) 5.7 ΚΩ 16) Refer to Figure 1. The cutoff frequency due to C1 is B) 13 Hz 1 D) 1.8kQ C) 40 Hz D) 7.2 Hz 15) 16) 17) Refer to Figure 1. Assume that Cbc-6 pF and RL-27 kQ2. The Miller input capacitance due to Che is 17)_ A) 49 pF B) 7.0 pF C) 168 pF D) 216 pF

Figure 1 (Assume re-1502) 15) Refer to Figure 1. Rin is approximately A) 10 kQ A) 23 Hz C) 3.2 k Β) 5.7 ΚΩ 16) Refer to Figure 1. The cutoff frequency due to C1 is B) 13 Hz 1 D) 1.8kQ C) 40 Hz D) 7.2 Hz 15) 16) 17) Refer to Figure 1. Assume that Cbc-6 pF and RL-27 kQ2. The Miller input capacitance due to Che is 17)_ A) 49 pF B) 7.0 pF C) 168 pF D) 216 pF

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
With V1, voltage peak to peak is 10 volts, R1=200 Ohm, R2=1000 Ohm and C1= 300 nF. Find Vx, voltage across the the capacitor, C1 and R2 when the frequency is 1000 Hz and 10000 Hz
1. 1-5 K 30v a. what is tue T CTime constant) ? b. How long will it take for the capacutor TO rtach s0% op charge? C. What is tne voltage of capa citor apter 1 seconds? d. How many tíme constants will it take for the soltage to reach 23 v? C. Gweng that the capacitor is fully changed, how will it take por it to be 20% ? long 120v + BF what is the. T ? b. what is the voltage capacitor apter 10 sec? a. C. How many time constants will it take for Tue Vo Itage to reach 80 v.? d. Given that the capaator is Fully charged, how time constants will it be to reau many GOV!
PROBLEM: The diode (blue line) should be at -10V not -8V SOFTWARE USED: LTspice XVII---Figure 1 is my work, and figure 2 is the correct sample. Please tell me what I did wrong. Thank you :))---Below is the .asc filehttps://www.mediafire.com/file/zxauoh86zi79nfu/EXPERIMENT_01.asc/file
Q3/ a/ What is the function of the inductance L in a single phase halfwave thyristor? b/ A controlled full wave bridge rectifier has a source of 50 Sinwt with R = 10 and L = 20 mH find the d.c load current if a = 40° , then draw Vo and lo use %3D %3D 50 Hz freq. and ß = 1.1n
Moving to another question will save this response. Quèstion 3 In half wave rectifier with filter, if the capacitance is increased, the ripple factor increases. True False Moving to another question will save this response. to search 近
R1 Vi 1kO Di IN4148 D2–1N4148 5V Vo -5V -3V Figure 1 a)Draw a simplified circuit for positive and negative cycle then calculate the output voltage (Vo) for both cycles. b)Sketch the output waveform, Vo for the circuit.
Post-lab Questions If the diode D3 is damaged (as short) draw the output voltage waveform in this case. D1 D2 V1 F1 220Vrms n 50HZ T1 0° 220v:40v D3 D4 transformer
Explain the rectification alternating voltage into dc voltage with relevant waveforms
VI. Homework: 1. Sketch the output waveforms expected when a sine wave (100 Hz, 15V) is applied to cach of the circuits shown in the figure. Specify important voltage levels and time scales. The input is on the left and the output is on the right. 10 ka 立 IN4735 6.0 V IN4007 IN4007 10 ka V IN4007 10 kn IN4007 A IN4007 SOV 3.0V T 30
Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Thyristor Crout Probe Pulse Generator VC, pulses Probe Scope Thy Orso v Joad O R: 1 The output voltage across R is depicted in 0.5 0.0- b) 0.2 0.0 d)
REC United Peint 4OMO WODOA4 Outine- 000000- . PAnA Color color Edit Tooh Shapes Colors Calculate the temperature and static dynamic temperature of a p-n junction germanium diode if diode current is 2.72 mA and reverse saturation current is 1mA when a forward bias of 0.2V is applied.[K = 1.38 x 10-23JK-) %3D 1.6x1019