First law of Thermodynamics Conservation of Energy- Cycles Instruction: Completer the table and show solution step by step. 1. During process 1-2 of a closed system, 200 Btu of heat is added to the system and the stored energy of the system increases by 150 Btu. During the return process 2-1, which restores the system to its initial state, 80 Btu of work is done on the system. Determine the heat transfer of process 2-1. 2. During process 1-2, 4000 kJ of heat is added to a closed system and the system's stored energy increases by 3000 kJ. During the return process 2-1 that restores the system to state 1, 1000 kJ of work is done on the system. Determine the heat transfer of process 2-1.

First law of Thermodynamics Conservation of Energy- Cycles Instruction: Completer the table and show solution step by step. 1. During process 1-2 of a closed system, 200 Btu of heat is added to the system and the stored energy of the system increases by 150 Btu. During the return process 2-1, which restores the system to its initial state, 80 Btu of work is done on the system. Determine the heat transfer of process 2-1. 2. During process 1-2, 4000 kJ of heat is added to a closed system and the system's stored energy increases by 3000 kJ. During the return process 2-1 that restores the system to state 1, 1000 kJ of work is done on the system. Determine the heat transfer of process 2-1.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.82P: Discuss the modes of heat transfer that determine the equilibrium temperature of the space shuttle...

See similar textbooks

Similar questions

An open system is often referred to as control volume, which is a properly selected region in space in which mass and energy can flow across the boundaries as figure 1.2. The boundary of a open thermodynamic system is called the control surface Across the Boundaries E = Yes F 0 = Yes w =Yes Control surface ass YES W CONTROL VOLUME energy YES Figure 1.2. A cooling/heating radiator is an example of such a system – give two more examples of such a system.
Q A horizontal piston-cylinder assembly contains 2.00 kg of a fluid. The assembly is fitted with both a heater and a paddle wheel. It is found that the fluid undergoes an expansion from state 1 to state 2. During the process, the paddle wheel transmits 16.4 kJ of mechanical energy (Wp.w.) to the fluid via mixing, and the heater supplies 83 kJ of thermal energy (Q) to the fluid. The specific internal energy changes from U1 = 2386.6 kJ/kg to U2 = 2409.1 kJ/kg during the process. Determine the work done by the steam on the piston during the process (Wpiston) (kJ). Your Answer: 45°F hp Insert * 24 % 8. 4 R H J K D F CV B N M
Thermodynamics: How do you solve this certain problem? Please show the step by step solution please
Please Show solution Step by Step with Units. FIRST LAW OF THERMODYNAMICS CONSERVATION OF ENERGY – OPEN SYSTEM Answer it in 1hr.
An electric storage battery which can exchange heat only with a constant temperature atmosphere goes through a complete cycle of two processes. In process 1-2, 2.8 kWh of electrical work flow into the battery while 732 kJ of heat flow out to the atmosphere. During process 2-1, 2.4 kWh of work flow out of the battery. (a) Find the heat transfer in process 2-1. (b) If the process 1-2 has occurred as above, does the first law or the second law limit the maximum possible work of process 2-1? What is the maximum possible work? (c) If the maximum possible work were obtained in process 2-1, what will be the heat transfer in the process?
Q1. (Reading: Çengel and Boles, Thermodynamics: An Engineering Approach, 8th Ed., Pages 307-311) The amount of energy waste by a refrigerator increases by a number of malpractices. For example; opening the refrigerator door frequently will increase energy waste as the warmer air outside replaces the cool air inside. It is also not recommended to place the hot foods into the refrigerator before cooling them to the room temperature. Imagine a typical household refrigerator with an internal temperature of 4 °C. The refrigerator has a coefficient of performance of 1.4. The internal dimensions of this refrigerator are 186 cm (height) x 84 cm (width) x 75 cm (depth). The half of the refrigerator volume is used for storing food items. The air filling the other half of the refrigator volume contains 0.004 kg moisture/kg air on average. While the moisture content of the air in the kitchen is 0.01 kg/kg air, the temperature and pressure in the kitchen are 23°C and 97 kPa, respectively. Assuming…
Why do dna replication and rna transcription are always non equilibrium steady state?
2. I just need the graph of this. A certain ideal gas (unknown) inside a close piston-cylinder assembly undergoes a set of processes that composed of Isothermal expansion from State point 1 to state point 2, Isometric heat rejection from state point 2 to state point 3, and Isentropic compression from state point 3 back to the initial condition. If the maximum pressure is 3000kPa and maximum and minimum volume is 200cm3 and 50cm3
A gas contained within a piston-cylinder assembly undergoes three processes in series: Process 1-2: Constant volume from p₁ = 1 bar, V₁ = 4 m³ to state 2, where p2 = 2 bar. Process 2-3: Compression to V3 = 2 m³, during which the pressure-volume relationship is pV = constant. Process 3-4: Constant pressure to state 4, where V4 = 1 m³. Sketch the processes in series p-V coordinates and evaluate the work for each process, in kJ. Hint: Draw all the processes neatly on P-V diagram. Denote the states 1-4. Do not forget to add arrows.
A food product containing 80% moisture content is being frozen. Estimate the specific heat of the product at -6 ° C when 80% of the water is frozen. The specific heat of the dry product is 2 kJ / (kg ° C). It is assumed that the specific heat of water at -10 ° C is the same as the specific heat of water at 0 ° C, and that the specific heat of ice follows the function Cp es = 0.0062 Tbeku + 2.0649. Cp frozen product = Answer kJ / kg ° C.
A food product containing 80% moisture content is being frozen. Estimate the specific heat of the product at -8 ° C when 80% of the water is frozen. The specific heat of the dry product is 2 kJ / (kg ° C). It is assumed that the specific heat of water at -10 ° C is the same as the specific heat of water at 0 ° C, and that the specific heat of ice follows the function Cp es = 0.0062 Tbeku + 2.0649.
Thermodynamics Answer the following problem with complete solutions. Write legibly A gas goes through the following thermodynamic processes: A to B: constant-temperature compression; B to C: constant-volume cooling; C to A: constant-pressure expansion. The pressure and volume at state C are 1.4 bars and 0.028 m^3, respectively. The net work during the C-to-A process is 10.5 kJ. What net work is derived from one complete A-B-C cycle?