For a Hartley oscillator, the value of the two inductors present in the tank circuit are 5 mH, and 12 mH. If the capacitor is 3.5 uF and there is no mutual inductsnce present, then what will be the resonant frequency of the circuit?

For a Hartley oscillator, the value of the two inductors present in the tank circuit are 5 mH, and 12 mH. If the capacitor is 3.5 uF and there is no mutual inductsnce present, then what will be the resonant frequency of the circuit?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter23: Resistive-inductive-capacitive Series Circuits

Section: Chapter Questions

Problem 1PA: You are an electrician working in a plant. A series resonant circuit is to be used to produce a high...

See similar textbooks

Related questions

Q: a) For the Circuit shown calculate the value of C if the resonant frequency. is 5000 vad /sec

Q: Given w(f)=2e−1/10||−f||. (a) plot W(f) (b) find the 6dB bandwidth of the signal

Q: 1) À narrowband FM signal is defined as follows: s(t) - A. cos(2nft) – BA, sin(2nf et) sin(2nfmt)

A: consider the given question;

Q: 21 Let Vs = 20 cos(wt) V. The magnitude of the capacitor voltage [Vc at resonance is...V 12 k2 45 k2…

A: This is the case of parallel resonance circuit. At resonance the parallel combination of inductor…

Q: A certain electronic test circuit produced a resonant curve with half-power points at 432 Hz and 454…

A: Given values are - fL=432HzfH=454HzQ=20

Q: Calculate the Gaussian noise potential difference of a component with a noise temperature of 260…

A: We need to calculate the Gaussian noise potential difference of a component with a noise temperature…

Q: 0.1 For the circuit shown, calculate the A, and the C, that required to obtain 1.77KHZ lower…

Q: Plot the Bode magnitude response of the filter.

Q: If the Q factor of a coil at resonant frequency of 1.5 MHz is 150 for a series resonant circuit,…

A: Given: Resonant frequency, fo=1.5 MHz Q factor = 150

Q: After helping your friend, you decided to take a walk. You found a device dis- carded by the side of…

A: Given : In the given question they have mentioned an angle modulated signal. For the given angle…

Q: (a) Find the H(s) with the following hand-sketched Bode Magnitude plot.

A: (a) We have to find the H(s) for the following Bode magnitude plot: Figure-(1) (b) We have to find…

Q: If the bandwidth of the double side band (DSB) modulation is (20) MHz, then The bandwidth of the…

A: Given Bandwidth of DSB modulated signal is 20 MHz

Q: For a Hartley oscillator, the value of the two inductors present in the tank circuit are 5 mH, and…

A: Given: Inductors L1=5 mHL2=12 mH Capacitor C=3.5 μF And no mutual inductance present.

Q: A series RLC has a quality factor of 5.1 at its resonance frequency of 100kHz. Assuming the power…

Q: Problem 7: a) The bandwidth of a series resonant circuit is 200 Hz. If the resonant frequency is…

Q: Q1: Find the frequency response of the system shown in figure below and sketch its characteristics…

A: CLTF=h(n)=y(n)x(n)

Q: If the resonant frequency in a series RLC circuit is 50kHz along with a bandwidth of 1kHz, find the…

A: Given: Series RLC circuit having Resonant frequency, fr=50 kHz Bandwidth, BW=1 kHz

Q: Calculate the pole location in the complex plane of the lead portion for a lead-lag compensator…

A: calculate the pole location in the complex plane of the lead portion for a lag lead compensator…

Q: 1. Consider an air-filled rectangular cavity resonator with dimensions of a = 2.286 cm, b = 1.016 cm…

A: Resonators- Resonators are used to generate specific wavelengths or to select specific waves in a…

Q: In a series RLC circuit that is operating above the resonant frequency, the current leads the…

A: For a series RLC circuit, the impedance diagram is as below.

Q: 3. A series circuit consists of a 30-ohm resistor, a 0.104-henry inductor, and a 40-microFarad…

A: In this series RLC circuit is given...We have to find out current , resonant frequency , colgate…

Q: An RLC series resonant circuit has the following parameter: fr=5000/2Hz, impedance at resonance =5k…

A: An RLC series resonant circuit has the following parameter : fr=50002πHzImpedance at resonance:…

Q: For the network transfer function, draw the Bode magnitude plot: 25000 (jw + 31.42) H(jw) (jw +…

Q: A communications channel with a bandwidth of 4 kHz has a signal power to noise ratio of 7. The…

Q: Which of the following is true about image frequency when it is allowed to enter at the receiver?…

A: Choose the correct option Which of the following is true about image frequency when it is allowed to…

Q: An acoustical engineer measures the quality of the resonance peaks for the pick- † up RLC circuits…

Q: 1. A plot of the magnitude of the transfer function, G(jo), as a function of the frequency is given…

Q: For the attached circuit, specify the frequency of Y. * in o o oO0 10000. 20ms

Q: he amplitude plot rises as the frequency increases from 100 Hz until he is reached O input frequency…

Q: A filter circuit consisting of a series L-C in parallel with an inductor is to be designed to pass a…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Q1. From the UJT data sheet: +20V n = 0.63, Vs = 2.5V, Ip = 7.4µA, Is = 1.75mA, RBB = 5kN & V, gmin…

A: Unijunction Transistor (UJT): The Unijunction Transistor (UJT) is a semiconductor switching device…

Q: a) Find the input impedance, Z1, of the circuit below, in terms of L, C, R, and o. b) Determine its…

Q: A filter circuit consisting of a capacitor C, in series with a parallel combination of Cp-L is to be…

A: It is given that: Passing frequency=fp=50 KHz=50×103 HzBlocking frequency=fb=20 KHz=20×103…

Q: An RLC circuit of 20 ohms resistor, 10 µF capacitor and 5 mH inductor connected to a sinusoidal AC…

Q: 684. See Fig 684. C=13 uFd, L=17 Hen, R=102 Ohms, Vm=15 Volts, w=67.3673 rad/sec. Determine the…

A: Here, first circuit is given in time domain and second Circuit in jw domain.

Q: 10 μΗ Consider Zeg Calculate the resonant frequency wq. 50 Ω a. b. Plot |Ze by first evaluating it…

A: The circuit diagram is: a). It is a series RLC circuit.

Q: A coil of resistance 25 Ω and inductance 100 mH is connected in series with a capacitance of 0.12 μF…

Q: The resonant frequency of a cavity resonator depends or O The capacitor which tunes it O The mode of…

A: A cavity resonator is a special case of the resonator device or system, which has a pronounced…

Q: a) The input and output voltages of a filter network are 8mV and 16mV, respectively. Calculate the…

Q: A 20,000-cycle source is connected to a series and a 0.266-uf capacitor. An impedance coil, whose…

A: Resonance:-At resonance condition, XL& XC cancel the effect of each other and circuit become…

Q: In an RLC series circuit shown in Fig.1 determine (i) the necessary value of capacitor (ii) the…

Q: 10) Eight different students tuned in the circuit for resonance and the values ofresonant frequency…

Q: 2. Frequency response 2.1 A series resonant circuit has an inductor of 2 mH and a capacitor of 12…

A: It is given that: L=2mHC=12 μFQ=4

Q: In an RLC series circuit shown in Fig.1 determine (i) the necessary value of capacitor (ii) the…

Q: A TRF receiver is to be designed with a single tuned circuit using a 10 mH inductor. Calculate the…

A: Given, A TRF receiver is to be designed with a single tuned circuit using a, Inductor, L= 10 mH…

Q: If the power of the noise is 346, the power of the signal is 260 and the bandwidth is (10) MHz, then…

A: In this question we need to find a SNR of the given signal.

Q: 1 H 6Ω 0.4 F

A: For figure (a), series RLC circuit The resonant frequency is, ωr=1LC=11×0.4=1.58 rad/sec The quality…

Q: Given the desired transient response specifications below, find the Bode Plot parameters that will…

Q: 12.47 An air-filled cavity has dimensions 20 mm × 8 mm × 10 mm. If the walls are silver-plated, find…

Q: In an RLC series circuit shown in Fig.1 determine (i) the necessary value of capacitor (ii) the…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in a plant. A series resonant circuit is to be used to produce a high voltage at a frequency of 400 Hz. The inductor has an inductance of 15 mH and a wire resistance of 2 . How much capacitance should be connected in series with the inductor to produce a resonant circuit? The voltage supplied to the circuit is 240 V at 400 Hz. What is the minimum voltage rating of the capacitor?
Calculate the bandwidth in kHz Blank 1 and an inductor's Q Blank 2 at100MHz. It has an inductance of 6mH and a series resistance of 1.2k2.
Calculate the parallel resonant frequency of the crystal if a 2-pF capacitor is placed in parallel with the crystal. Repeat for a 20-pF capacitor.
What is the bandwidth of a signal that can be decomposed into five sine waves with frequencies at 0, 20, 50, 100, and 200 Hz? All peak amplitudes are the same. Draw the bandwidth.
5. For a 1Vpp sinusoidal input, at a frequency of 1KHz, draw the output for each circuit.
A resistor of resistance R=1000 2 is maintained at 17 °C and it shunted by 100 µH inductor. Determine the rms noise voltage across the inductor over a frequency bandwidth of: i) 15.9 kHz Ans: 182 x10-⁹ volt Ans: 9.22 x10-8 volt 11) 159 kHz iii) 1590 kHz Ans: 2.34 x10-6 volt
A reactor of resistance 50 ohms and inductance of 150 mH is connected in parallel with a capacitor, what must be the capacitance of the capacitor to produce resonance to 250 volt, 60Hz main? QUICKLY I NEED IT IN5 MINS
A full-wave rectified voltage of 18 V peak is connected to a 400micro F filter capacitor. What are the ripple and dc voltages across the capacitor at a load of 100 mA?
A series circuit consisting of a 302, resistor and a 4µF capacitor is connected in parallel with a variable inductor. For what value of inductance will the circuit be in resonance if the frequency of the source is 1,200cps?
In a series resonant circuit, the resonant frequency is to be reduced. If only capacitance can be changed, then how the capacitance should be altered? Increaased or decreased?
In a series resonant circuit, a resistor of resistance 500 ohm, an inductor of inductance 4.5 henry (H) and a capacitor of unknown capacitance are present. If the resonant frequency is 20 kHz, then what will be the value of the capacitance?
H.W: od vd babivoro R₁₂ = Ret dondbesit di duonds dondbest evitsyon. A Wien Bridge Oscillator circuit is required to generate a sinusoidal waveform of (5.2kHz). Calculate the values of the frequency determining resistors and the two capacitors to produce the required frequency. 2-926do 081 benistere not gniwolls fide-oesdg to IstoAct=3151891 golibros ow! Also, if the oscillator circuit is based around a non-inverting operational amplifier configuration, determine the minimum values for the gain resistors to produce the required oscillations. Finally draw the resulting oscillator circuit.