For a typical road construction which requires soil embankment prior subgrade, what is the proper sequence of activities to properly prepare that layer of soil embankment? Which earthwork equipment should we use in order, from first to last?

Q: Compute for the modulus of rupture of the concrete beam sample if the size of the sample is 6”x 6”, ...

A: To Determine Modulus of rupture of the concrete beam sample.

Q: soil sample with the following composition by weight 80% Gravel, around 5% roots and the rest Cl...

A: ASKED: To choose the correct description of given soil based on its composition by weight.   Given: ...

Q: A 150mm diameter cylindrical concrete specimen was tested for compressive strength. The stress at fa...

A:

Q: Q2: Draw shear force and bending moment diagrams by using equation method. 20 kip 4 kip 'ft Hinge MA...

A:

Q: Determine the total hydrostatic force (N) in an inclined, rectangular gate 0.14 m width with oil on ...

A:

Q: A bar having a cross-sectional area of 700 mm² is subjected to axial loads at the positions indicate...

A:

Q: Design for the circular section the maximum uniformly distributed load that can be loaded for the be...

A: Firstly Calculate Bending Moment and Shear force by drawing Bending Moment and shear force diagram A...

Q: Assume unit weight of concrete to be 23.5 kN/m3. Hydrostatic uplift varies from 10% of the hydrostat...

A: Given Data:  Unit weight of concrete = 23kN/m3 B = 6m H = 9m

Q: In the figure shown, Zp = 4 m, length of pipe from the reservoir to the pump is 120 m, from the pump...

A: Given,  f = 0.02 LAB = 120 m LCD = 1000 m   

Q: A 900 mm diameter pipe 1,800 m long carries 1.2 cu.m./sec from reservoir A, whose water surface is a...

A:

Q: Water flows in a rectangular channel 10 ft wide at a velocity of 10 f/s (V1) and a depth of 10 ft (y...

A: v1 = 10ft/s y1 = 10ft w1 = 10ft Q = 10*10*10 = 1000ft3/s q = Q/T = 1000/10 = 100ft2/s E1 = y1 + v12/...

Q: A 150mm diameter cylindrical concrete specimen was tested for splitting tensile strength. The splitt...

A:

Q: An orifice is placed at the side of 2 m diameter vertical tank. The center of the orifice is 10 m ab...

A: Find horizontal velocity :ux=2gHux=2(9.81)(3m)ux=10.95445ms

Q: 2. Given the Baseline and Principal Meridian, Identify Township T2S-R1E

A: Question 2 From the given figure, the blocks can be marked as follows.The Cells along the principal ...

Q: Draw the network diagram of the following information: a. At the start of the project, each of 3 sep...

A: From the given information, there is no activity following C, which indicates a dummy activity and f...

Q: A Design a tubewell to deliver 33,000 gallons per hour at a depression head of 5 m. The average wate...

A:

Q: Given The system shown in the figure has the following dimensions: h1 = 2.35 m h2 = 3.55 m d1 = 60 m...

A:

Q: The bottom of a river is 8m below the water surface. Underneath the bottom of the river is a layer o...

A:

Q: The coefficient of static friction between the 199.44-kg crate and the flat bed of the truck is u = ...

A:

Q: Two aluminum rods AB and BC, hinged to rigid supports are pinned together at B to carry a vertical l...

A: Given data load P = 20 KN Crossection area of rod = 400 mm2 modulus of elasticity E = 70,000 MPa = ...

Q: 171.8 19.0 177.8 177.7 117.1 117.1 119.1 11.6 11,9 179.1 11.7 178.0 By Ny G 2,041 1.43A 1.041 2.154 ...

A:

Q: A pair of overlap aerial photographs was taken with a camera from an altitude of 3000 m above datum ...

A:

Q: A rectangular beam has b=300mm and d=540mm. It is reinforced with tension only with 8-25mmø bars wit...

A: step 1-

Q: I. Compute the force of CD and DE of the truss given below: 2000 Ib 3000 lb D 60° 60° C 60° 60° A 10...

A:

Q: trapezoidal channel below must supply a discharge rate of 2 x SN (m3/s). The Manning’s  roughness of...

A: Given:- discharge rate= 2  X SN Manning's roughess=SN/10000 channel slope=SN/10000 SN=21 To find:- D...

Q: A plane frame shown in the figure has linear elastic springs at node H. The spring constants are ka ...

A:

Q: Length (m) No. of Paces Mean No. of Paces Pace Factor 18 10m 18 17.67 0.56 17 24 15m 24 23.67 0.63 2...

A:

Q: 8 kN 8 kN 8 kN 4 kN E 4 kN 2 m A D В 4 m 4 m

A:

Q: In the two-peg test of a dumpy level, the following observations are taken: Instrument near A Instru...

A:

Q: fc'= 35 Mpa and fy=414 Mpa. Proceeding on the basis that the concrete dimensions will be determined ...

A:

Q: A 150mm diameter cylindrical concrete specimen was tested for splitting tensile strength. The Sample...

A:

Q: Seepage is occurring through a porous media shown in the figure. The hydraulic conductivity values (...

A:

Q: 1.) The hull of seaQuest Deep Submergence Vehicle (DSV) can descend to a depth of 8.75km before reac...

A:

Q: 3. Using any method, (thru equations, or area method), draw the shear and moment diagram of the foll...

A:

Q: Which command convert discrete objects in polyline Union Join O Polyline Subtract

A: A multiple choice questions is asked, please refer step 2 for detailed explanation and solution.

Q: Compute for the Initial setting time of the cement given the following result: TIME (minutes) PENET...

A: Given:- The results of the test conducted are given:- Time (minute) Penetration 15 46 30 41 ...

Q: 3. Consider the drawing below. a. Find I, b. Find Ix 15 10

A: y = 3*x0.5 y= 3/5*x

Q: Which type of soil structure is this sample:

A: In soil mechanic, soil structure are mainly Granular: approximately spherical and irregular shapes P...

Q: H.W 1 A beam is subjected to equal bending moments of M, = 45 kip- ft, as shown in Figure 1 a. sions...

A:

Q: WALL A 50 FT ROOF PLAN Assuming the joists shown in the framing plan to the right are supported by t...

A:

Q: 3. What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.05 N/cm2 gre...

A:

Q: Seepage is occurring through a porous media shown in the figure. The hydraulic conductivity values (...

A:

Q: In a dilatancy test on site water slowly showed up on the surface of the sample, this sample possibl...

A: True

Q: Problem 1. A reinforced concrete beam 300mm wide has an effective depth of 460mm and reinforced in t...

A:

Q: If a rectangular gate of length 27 m and width of 7 m is vertical and submerged in oil wherein the l...

A:

Q: What is the usefulness of viewports Allows us to see the screen or on paper different views of the s...

A: Ans = A (allows us to see the screen or on paper different views of the same project). Viewports all...

Q: A separator accepts waste oil at 70% oil and 30% water by weight. The top product stream is pure oil...

A: Hi! Thank you for the question.  As per the honor code, we’ll answer the first question since the ex...

Q: A beam ISLB 350, 8 m span, carries a total uniformly distributed load of 280 kN. It is supported on ...

A:

Q: Calculate the nominal one-way shear stress in MPa.

A: The values given in the question are as follows: Side of square column(a)=375 mm Dead load on column...

Q: Problem 04: (5 minutes) The man in figure below pushes on the 50-kg crate with a force of F= 150 N. ...

A: Given data,  F = 150 N t = 4 s Uk = 0.2 Weight of crate = 50 kg Determine the power supply by man. 

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.