For the circuit shown below, find the phasor current I, the real power, reactive power and apparent power delivered by the source. Find the power factor and draw a power triangle labelling all branches. 1000 V2/0° 100 N 10 μF W = 377 C

Q: (c) A 230 V, 50 Hz power source is connected to the some loads, the source is supply current with…

A:

Q: 1. In the following figure: %3D R = 3 kN X; = 2 kM Xc = 1 kN + VR VL VC i e = 6 sin(314t + 60°) %3D…

A:

Q: For the circuit shown: a) Find Zr & YT. b) Find I1, I2, and I3. c) Find the power factor, the real…

A: Parallel Connection of Impedances: When n no. of impedances are connected in parallel, their…

Q: A residential four-wire system supplies power at220 V rms to the following single-phase…

A: (b) For first phase total load are – Since loads are bulb so that total power is real and reactive…

Q: Q3) By using the circuit given below; Find the total value of active power, reactive power, apparent…

A: Given parameters are: Load1:  S1=5kVA  pf=cosΦ1=0.65(lagging) Load 2: Q2=2000VAR…

Q: Q1b. Write the phasor form of v(t)= 12 sin (200t+30°) V Q1c. You have a load that has an impedance…

A: For this problem we can easily solve .

Q: Consider the circuit shown in (Figure 1). Suppose that RRR = 160 ΩΩ and CCC = 12 μF. a) Find the…

A:

Q: For the circuit show below, solve for the following: a. The complex power delivered to each passive…

A:

Q: Q 1) Given that Z1 = 302(-40°) N and Z2 = 50215° N, find the (a) apparent power, (b) real po (c)…

A:

Q: Problem 6: For the circuit shown below, find the phasor current I, the real power, reactive power…

A:

Q: (b) Three loads are connected in parallel to a 240Z0° V rms of 50 Hz source. Load 1 absorbs 90 kW…

A: The detailed solution is provided below.

Q: 3. Suppose a voltage v(t) = v2 × 120 sin(377t + 30°) is applied to a single phase oad, and the…

A:

Q: For the diagram below calculate the Total Real Power (PT),; The Total Reactive Power (QT); the Total…

A:

Q: A resistor of 10ohm and an inductor of 0.2 henry are connected in series and given a supply of 230…

A: Solution:- Resistor R=10, henry L=0.2 H, connected in series.  supply voltage V=230 V, Frequency…

Q: (d) Figure Q1(d) shows an AC circuit. Given Vị = 24 - 15° V (i) Determine the value of impedance Zr.…

A: The solution is given below

Q: isible power of Z1 =  |S1| = 16 kVA and at 0.8 back power factor; Visible power of Z2 = |S2| = 25…

A: Given data: S1=16 kVApf1=0.8S2=25 kVApf2=1ZW=5+j26 ΩVL=3.8 kV

Q: 4) Determine the real power, reactive power, apparent power, and complex power absorbed by each…

A:

Q: A 230 V, 50 Hz power source is connected to the some loads, the source is supply current with power…

A:

Q: For the circuit shown: a) Find Z1 & Yı. b) Find I1, I2, and I3. c) Find the power factor, the real…

A: Disclaimer:  Since you have asked multipart questions, we will solve the first three subpart for…

Q: The Thevenin impedance of a source is ZTh = 120+ j 590, while the Thevenin voltage is VTh=327 + j265…

A: Maximum power: It states that maximum power transfer only possible when the load resistance is equal…

Q: Question 2: Based on figure below: a. Find the total impedance Z, in polar form b. Draw the…

A:

Q: If the voltage and current given below are suppliedby a source to a circuit or load, determinea. The…

A: Let the angle given be in radians. Find the complex power supplied by the source.

Q: An electric load consists of a resistor, a capacitór and an inductor connected in series. The total…

A: Introduction:  R-L-C circuit: RLC circuit consists of passive parameters like resistance (R),…

Q: Find the power delivered by the source. B)Find the reactive power delivered by the source. C)Find…

A:

Q: Power Factor (PF) = Cos where o is the angle between Vs and Is Real Power (P) = Vs.Is.CosO where Vs…

A:

Q: Q4) By using the circuit given below; a) of the system. b) c) d) Find the total value of active…

A: Active Power(P): The power which is deployed and absorbed by the electric circuit to do some useful…

Q: A balanced positive-sequence wye-connected 60-Hz three-phase source has line-to-line voltages of…

A: Given Data: line to line voltage = 440 V Inductance = 0.3 H resistance = 50 ohm frequency = 60 Hz

Q: The apparent power of the load Z1 in the circuit given in the figure | S1 | = 16 kVA and at 0.8 back…

A:

Q: In the circuit shown in Figure 4, the load voltage is Vrms 156020°. Notice that Vrms = | Vrms | =…

A:

Q: = The Thevenin impedance of a source is ZTh 89+ j 68, while the Thevenin voltage is VTh = 346 + j373…

A:

Q: Find: The real, reactive and apparent power at the load Power factor at the source and load side Z,…

A: impedance, Z = ZR + ZC Z = 400 - j300 magnitude of (Z) = 4002+3002 = 500…

Q: Q3: For the circuit shown below, If I 4435° Ams, determine the average power being supplied: (a) by…

A: Disclaimer:  Since you have asked multipart questions, we will solve the first three subpart for…

Q: A 25 ohm resistor connected in series with a coil of 50 ohm resistance and 150 mH inductance.

A:

Q: By using the circuit given below; a) of the system. b) c) d) Find the total value of active power,…

A:

Q: Three loads are connected in parallel to a 240Z0° V rms of 50 Hz source. Load 1 absorbs 90 kW and 50…

A:

Q: For the following voltage and current phasors, calculate the complex power, apparent power, real…

A:

Q: Q2: For the circuit in the figure, find: R = 40 16mH 265LF + UR - - la + Da 70.7 sin 377 a) Find the…

A: This is RLC series circuit.  Find the current in the circuit and total impedance?  Overall power…

Q: Rjine jXiine + + VL |L, L2 - L1: Absorbs an average power of 20kW at a leading power factor of 0.9.…

A:

Q: Calculate the apparent power, real power, andreactive power for the circuit shown in Figure.Draw the…

A: (a) From the given circuit, Capacitive inductance is given by,

Q: Calculate the real power P, reactive power Q and apparent power S, include units and show…

A:

Q: Two impedances are fed by a source with V = 100 V rms /160° , as shown below. The total current is I…

A: Circuit is given as, Given data,   P1=23.2WQ1=50 Var

Q: ?The Thevenin impedance of a source is 96+j34 Ohms, and the Thevenin voltage 209 + j97 V. What is…

A:

Q: T2 Vs R Vo AA chopper circuit in the figure, 400 V (rms) Control the power of an ohmic load from a…

A: Explanation: “Since you have posted a question with multiple sub-parts, we will solve the first…

Q: Question 1: Based on figure below: a. Find the total impedance Z, in polar form b. Draw the…

A: (h) If XC=2 Ω The total impedance in polar form is given by Z=R+XC+XL=4-j2+j6=4+j4 Ω=42∠45° Ω The…

Q: (b) Figure Q1(b) shows an AC circuit. Given the voltage, Va across the impedance Za is 111.803 L-…

A:

Q: Calculate the apparent power, real power, andreactive power for the circuit shown in Figure.Draw the…

A: From the given circuit,

Q: Question 1: Based on figure below: a. Find the total impedance Z, in polar form b. Draw the…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: Q8. The ac steady state inputs to the load in the figure are v(t) = 300 cos(2000t + 65°) V and i(t)…

A: Given data  V(t) = 300 cos(2000t+65) v i(t) = 0.66cos(2000t) A

Q: A sinusoidal voltage source V = 46 /115° Vms feeds an impedance with a current I = 2 /52° Ams- The…

A: Given  Vrms=46∠115 Volt Irms=2 ∠52 Amp θv=115  θi=52

Q: Q2. For the circuit of Figure 2: a. Find the current I and the total impedance ZT. b. Find the…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…