For the cirenit shown in Figure If Vec = 20V, Rc= 2.2k2 Vcc %3D RB= 390ks2, RE= 1.2K52 B- 100 , ro = 0052 RB 全Rc Vo RE

Q: Find ZT. R=5kohms, XC=10kohms, Xl=10kohms

A: the given circuit has two branches that are connected in parallel, in the first branch the capacitor…

Q: (R=167kohm, R2=240kohm, Rg-1kohm, Re100kohm, C-1mikroF) R2 R4 C R3 R1

A: The detailed solution is attached with.

Q: 5) RL in Series Frequency = 100HZ %3D ET = ER = EL = %3D %3D %3D IR = %3D

A: The complex power for the circuit is given by:

Q: A 206.0-2 resistor and a 2.80-µF capacitor are connected in series across the terminals of a…

A: From the question, it is given thatResistance (R)=206 ΩCapacitance (C)=2.80 μFInductance (L)=0…

Q: Given: a = 99; ICEO VCEQ = -7V. Find: a. RE b. Rc RE VEE E 0; VEE 4V; Vcc= 12V; IE = 1.0mA; B IB RC…

A:

Q: Vs(t)=12cos2500t V, Is(t)=0.5 cos(2500t-30) A. 50 4 mH 4 mH ll E80 uF ll 4) 10 2

A:

Q: a) RT b) Vaj V,Vz C) I & The direti on Determine 600 V 400V loov 32v 220V 400v し20

A: Node: The meeting point of more than two branches in a circuit is referred as a node. At that node…

Q: Draw the diagram for the two phasors as described. Please try to draw them to scale. Phasor A:…

A: diagram for the two phasors: Phasor A: magnitude 10, angle 45° Phasor B: magnitude 10, angle —45°

Q: Let R, tRz - (00 E5 besign te ircit cuch mat Ip= 0.5MA.

A: The required parameters can be calculated by using the DC analysis of MOSFET amplifier.

Q: esistance of 20 N and an unknown capacitance are conne -Vac, variable frequency source. When the…

A:

Q: In series RLC circuit, the voltage across capacitor and inductor are B. 180° out of phase with each…

A: Use phasor diagram to determine the angle between inductor voltage and capacitor voltage.

Q: in a series Ri circuit voltage across the resistor is 100 V and the voltage across inductor is 50 v.…

A: Given, VR = 100 V , VL = 50 V, To calculate the power factor of the circuit.

Q: If A = 4a, + 3aó – 5az; the component of A parallel to the surface o = 2n is; %3D Select one: O -4ap…

A: In this question,  Choose the correct options What is parallel component of A to the surface Ø= 2π

Q: An alternating current of frequency (60Hz) has a maximum value of (70A), the time taken to reach…

A:

Q: VCC R1

A:

Q: Vec Rc RB VE OE For the circuit shown above, assume Vcc- 12V, Ra 330KO, Rc- 1.5kO,B- 120. Determine…

A:

Q: Adding inductors in series to an RL circuit   Increases circuit current   Decreases inductive…

A:

Q: 3. Given Vec=100V, R,=2002, B=100, VBB-5V, flip the switch to close, and Ic=0.4A, 1) Determine Ig.…

A:

Q: Determine the Equivalent Resistance (Rab. Rac, Rad, Rbc, Rcd) of the circuit. d 30 20 b 50 40 a

A: In the given circuit,  Find the equivalent resistance across the given terminal.  We are solving…

Q: Change each complex no into polar form 3D351 1) 2) - 15 +i 5-3i

A:

Q: tell Ez-l2010 It Is caleulate Ii, Je, Is ,I42 Is

A:

Q: A resistor and a capacitor are connected in series across a supp 250V. When the supply frequency…

A: Given  The resistor and capacitor are connected in series Supply voltage V=250 v frequency  is 50 Hz…

Q: + 30 V Rc Rt るRE8.2Ke Find zi and zo and Av and Vo

A:

Q: 4)Listen If X 100 Q and R = 75 Q, the circuit phase angle is: a) 48.59° (degrees) O b) 36.87°…

A:

Q: Draw phasor (phase) diagram. Find O or A values. f: IkHz R, C, lon lon (FLOYD) 1,06709 ='ñ O, = 30L…

A: Given the parameters:

Q: In a series LR circuit, the reactance of the inductance is 520 ohm. What will be the value of the…

A: If an inductor of inductance L H is present in a series circuit and if the frequency of the ac…

Q: Is IR IL Ic Vs = 50V 100HZ R = 500 L = 20mH C = 5µF Determine for the value of lR, I lc and Is and…

A:

Q: What will be magnitude of the total circuit impedance of a series LR circuit excited by a 100 Hz ac…

A: If a circuit consists of series combination of a resistor of resistance R and an inductor of…

Q: Sketch PenftH and Ppmlt> fer the given eignale Ginen: k się mit).& m ct) - f - 4ベ X1o5 ノ Kp> 20ñ, fc…

A: Given: Frequency deviation constants kf=2π×105, kp=10π. Modulating signal frequency…

Q: C= ax + 2ay - 3az and D= 4ax + 5ay-6az

A:

Q: %3D (a) The voltage across a 10uF is ve = 100sin(@t-40°)V and f= 1000HZ. (i) Calculate ic, (ii)…

A:

Q: + VR + Vz 0.234 sin(3000t - 10°)A 6 µF

A:

Q: Determine S sketch the output voltaye wareform 1MF- 200K Viown -4

A: Here it us asked to find out the output voltage when the input voltage waveform is given. Here the…

Q: AN RLC series ckt consist Vesistance l00or, Irductauce luo mH & capacitauce 10uf. H 10u ús opplied…

A: In RLC circuit at resonance the inductive reactance  is equal and capacitive reactance. At resonance…

Q: fransmitter A has a power level of 1 mW, and transmitter B is 200 mw. Compare transmitter B to A…

A:

Q: An impedance draws a current i 18cos (wt-35°) from a voltage %3D 230sin(wt+25°)|- e What is the…

A: In this question Voltage and current in the impedance is given.  Find the Maximum power  We know…

Q: Saturation region occurs when .17 (äbäi 1) Vgs Vth O Vgs = 0 O

A: Saturation region occurs when Vds > Vgs- Vth , This occurs only when Vgs > Vth.

Q: 200Vp 1MHz L5 ㅏㅏ L6 C5 R5 100

A:

Q: - 30wb の Re ー18 Rf Ri -3=-12 V Ri RE -12* (+ (中)=Y8 RI

A:

Q: in a series Ri circuit voltage across the resistor is 100 V and the voltage across inductor is 50 v.…

A: Given data, Voltage across resistor VR=100 V Voltage across inductor VL=50 V

Q: For the circuit shown in Figure IF IB. 40 MA , VBB= 6v, RE = | Kr, P-80 Rc Re w VBB RE The value of…

A:

Q: Determine the Vo voltage in the circuit of figure. HH -j1 2 ban ro A' ww. A 1Ω 3Ω 2Ω Vo -2 V + 3V V…

A: By applying KCL on node A'…

Q: LThe thermooloctric effect is the diroct conversion of temporature differences to electric voitage…

A:

Q: Determine the magnitude and phase angle of the circuit current shown in Figure l- 14.50a

A:

Q: rcuit has the phase relation with reference to supply voltage as Select one: a. 45° lag. b. 45°…

A:

Q: Determine Ves, Vos, Io, Vo, Vs +15V Ipss = (2mA %3D 21M2. 1-2KN p= -4V Vi lomnZ TKSL HI

A: In this question,   We need to determine the drain current, voltage VGS  , VD  and VDS  ?

Q: Solve this question with the follwing requiremeats / 1- C, = 0-IKF and 2, 2 30 < 90° 2- L1² 25mH ond…

A: KCL: According to Kirchhoff's current law, the sum of current entering at a particular node=Sum of…

Q: Firring angle=40Degree phasel-120Sinwt

A: The above diagram represents a 3 phase Half-wave Rectifier. Given values are: V1=Phase 1…

Q: which circuit current lags the voltage by an angle less than 90 degree

A: The explanation is as follows.

Q: 16ke Rc For the circuit shown 18V in Figure. If VeE=-14v -14v RB Vec=18 V, VeE = 8 V, %3D IB= 8 MA ,…

A: Given: VEE= -14 V Vcc= 18 V VCE=8 V IB=8 micro amp BETA=100

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.