For the crude oil ship shown: if the empty ship weight =10000T and its length of 200m. Find the total oil volume of S=0.85 that can be transmitted by the ship in (barrel) and check the ship stability if SG. at 2 m above water surface. Fuel Tank Bridge Engine Room Pump Room Oil Tanks Double Hull Empty 110 50m 8m

For the crude oil ship shown: if the empty ship weight =10000T and its length of 200m. Find the total oil volume of S=0.85 that can be transmitted by the ship in (barrel) and check the ship stability if SG. at 2 m above water surface. Fuel Tank Bridge Engine Room Pump Room Oil Tanks Double Hull Empty 110 50m 8m

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Similar questions

All |Q1: the pressure at point A is 172 fluids are at 20°C. The air pressure in the ра. closed chamber B is..[w(water)=9790 * [N/m?,w(SAE oil 30)=8720 N/m³ Air B SAE 30 oil Liquid, SG = 1.45| 5 cm 3 'cm 4 cm 6 cm Water A 8 cm 3 cm
There is oil (dynamic viscosity = 1.6 Pa.s), oil film thickness (h = 0.7 mm) between a block with mass M (5 kg) and the bottom surface. Block base surface Its area is given as A = 28 cm2. Block m (1kg weight) with a wire rope It depends on the mass. At time t = 0, mass m is released. According to these data; a)Find the viscous forces when the block moves with V = 1 m / s velocity. b)Derive an equation for the block velocity as a function of time (t). c)Plot the velocity-time variation for t = 0 and t = t.
Please answer neatly For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two fluids—castor oil (0.96) and water. Considering a unit-width of the gate, apply the PRESSURE PRISM CONCEPT (Illustrate and label the pressure diagram/prism) to calculate the magnitude and direction of the following when z = 7m.a.The hydrostatic force due to linseed oil F1. b.The hydrostatic force due to castor oil F2. c.The hydrostatic force due to water. d.The net hydrostatic force acting on the gate Fnet
Fluid mechanics, I need solutions in 15 minutes please. MCQ/Determine the horizontal and vertical components of the liquid pressure acting on the semicylindrical gate ABC, as shown in the figure. The width into the paper is 1 m. A-Fx = 257.430 kN and Fy = 59.801 kN B-Fx = 164.018 KN and Fy = 37.229 KN C-Fx = 269.894 kN and Fy = 65.526 KN D-Fx = 98.182 kN and Fy = 20.002 KN E-Fx = 234.789 kN and Fy = 52.418 kN F-Fx = 187.005 kN and Fy = 42.182 KN G-Fx = 119.956 kN and Fy = 25.550 KN H-Fx = 141.327 kN and Fy = 31.171 KN I-Fx = 288.147 kN and Fy = 69.098 KN J-Fx = 213.112 kN and Fy = 47.903 KN
Q1/ A piston pushes down on a volume of hydraulic oil ISO 68, trapped in a cylinder, its bore is 10cm, and the height of the unstressed column of oil is 50cm. The oil has a bulk modulus B=2.2 *105 psi. When a force of 2500N is applied to the piston. How much does the piston displace? Note : (The ISO 68 has a density of 54.9 Ib/ft(880 kg/m³)
A square block has 320 mm bottom sides dimensions, weighing W is 1.4 kN on an edge slides down an incline angle 0 is 20° on a film of oil 6 mm thickness, as shown below. Assuming a linear velocity profile in the oil. The viscosity of the oil is 0.009 Pa.s. W y Determine the force acting on the block, F. What is the velocity of the block, V?
For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two fluids—castor oil (0.96) and water. Considering a unit-width of the gate, apply the PRESSURE PRISM CONCEPT (Illustrate and label the pressure diagram/prism) to calculate the magnitude and direction of the following when z = 7m. FIND: A. The hydrostatic force due to linseed oil F1. B. The hydrostatic force due to castor oil F2. C. The hydrostatic force due to water. D. The net hydrostatic force acting on the gate Fnet
The 45 ° V-tube in Fig. contains water and is open atA and closed at C . What uniform rotation rate in r/minabout axis AB will cause the pressure to be equal at pointsB and C ? For this condition, at what point in leg BC will thepressure be a minimum?
Air P 1,2 m wide AB gate is articulated from point A shown in the figure. The heights of the fluids are 6,0 m and 2,0 m for hị and h2, hị respectively. Considering the measured Water |A pressure P = -10 kN/m², find the magnitude Oil h2 of the force *(kN) that will affect point B, in which the force provides the balance in AB B gate (SGoil = 0,75). (SI Unit System) (y= 10KN/m³)
For the tank shown below. The base of tank is semicirele, if the length of tank is (10m) find: 1. Vertical force on the base of tank (point C). 2. Horizontal force at the arc (BC). 3. Force acted on the inclined wall of tank (AB). 40° 40 oil, s:3= 2-1 3m B. 2m
1. A bubble (assuming perfectly spherical) was released from a depth of 120m in the body of water by a fish. Having its temperature constant while it travels from the depth of release to water surface, solve for the following: a. kPaabs when released b. bubble diameter at 60m depth c. bubble diameter at the water surface h2=60m h,=120m SG=1.03
Air Question 5. 1,2 m wide AB gate is articulated from point A shown in the figure. The heights of the fluids are 6,1 m and 2,8 m for hi and h2, hi respectively. Considering the measured Water pressure P = -10 kN/m?, find the magnitude Oil b2 of the force *(kN) that will affect point B, in which the force provides the balance in AB B gate (SGoil = 0,75). Figure 5 (r= 10kN/m?) KANE