Answered: For the transsmision line below find…

For the transsmision line below find the average incident Power p and the average refelcted Power p Assume the frequency of operation is 1 GHz and velocity of propagation is 90% the speed of light.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Pe A 6v battey, delivers loMA ta thvee- resistors in faralkl, R,=1k,Re-2k2,R3=Rx- Calenlates a)…

Q: Four resistors 200Ω, 700Ω 1kΩ and 1.2kΩ connected in parallel. Find the equivalent resistance, the…

A: Given: Four resistors are connected in parallel R1=200 Ω=0.2 kΩR2=700 Ω=0.7 kΩ R4=1 kΩR4=1.2 kΩ…

Q: How high is the rated torque of separately excited shunt wound DC Motor?

Q: A 300-kilovolt-ampere transformer bank consisting of three 100-kilovolt-ampere transformers has a…

Q: Find the Laplace transform of the following functions Initial conditions are 0

A: Given, d2xdt2+4dxdt+5x=1 Initial conditions are zero.

Q: Find the current through the load resistor R in the two-generator source circuit in Figure 3 by…

A: Circuit diagram is given as,

Q: 3. Find the value of R for maximum power transfer. Also, determine the maximum power.

Q: D1.24 Find the complete response for t > 0 of each of the following systems with the indicated input…

Q: Q2 Given: The circuit shown in Figure (Q2). Find: a) T(s) expression b) T(s)| c) (@) = LT(s) Thy %3D…

Q: A 2500kVA, 6600V synchronous turbo alternator is operating at full load and 0.8 pf lagging. This…

Q: (c) Find the closed-loop transfer function, C(s)/R(s) for the system shown in Figure Q3 using block…

Q: Given the magnetic field is 3 units. Find the flux density in air(in 10^-6 order).

Q: Q4: For the class B output stage of Figure (Q3), let Vcc = 6 V and R, = 4 N. If the output is a…

A: Please refer the attached images for the complete answer..

Q: Design a basic wide-band, RC band stop filter with a lower cut-off frequency of 200HZ and a higher…

Q: (c) Find the closed-loop transfer function, C(s)/R(s) for the system shown in Figure Q3 using block…

Q: QJ Find The Powers suppLied by all Sources byusing Lp nadyn 1oov(+ 4A

A: In this question, We need to determine the power supplied by all the sources. We know power P= VI…

Q: find the current, Ix, for the circuit shown. (show all your work) ix 12Ω 30 Ω 5A + 30 V 0.5 ix

A: Given,

Q: An electrical power system with a source of 240230° Vrms, 50 Hz with the loads of lighting, cooking…

Q: btain the closed Loop fransr fnchon CR) yusing Mason'5 fermula for the splom below s G6 Gス G3 Gy…

Q: Create a circuit diagram for the given armature: 4 poles, 26 conductors, double layer,…

A: 4 poles, 26 conductors, double layer, simplex WAVE winding

Q: The B quantity is analogous to component Your answer

A: The solution is given below

Q: Given the system below, find the steady-state error if R(s) Y(s) R(s) s² + 7s + 10

A: We need to find out steady state error .

Q: QUESTION 23 In a low pass RL filter circuit, the inductor is placed O in parallel with the output…

Q: Two 10 H inductors are in parallel and the parallel combination is in series with a third 10 H…

Q: please draw in paper The band stop filter block diagram

Q: XC근) %= (1- Z)² find Invers Z-traus form 2

A: In this question we need to find a Inverse Z transform of the given system.

Q: diagr P1=10dBm G=10dB P2

Q: 5. A timing diagram below shows a D Flip-flop and the input clock. Show the transition of the output…

A: Writing the characteristic table of D-FF. DQnQn+1000010101111 It could be concluded from the…

Q: The armature resistance and synchronous reactance of a 2 kV, 3-phase, wye- connected synchronous…

A: Given: Supply voltage/phase, V=20003 Induced emf/phase, E=25003 Internal phase angle of the motor,…

Q: EXERCISE 2: An air-filled 5- by 2-cm waveguide has Ezs = 20 sin 40nx sin 50ry eBz v/m at 15 GHz. (a)…

Q: Q 4.13: An RL load is controlled by a converter. If load resistance R 0.25 2, inductance L= 20 mH,…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Find the electric field when the magnetic field is given by 2cos t in air.

A: Given data, Magnetic field is given, B=2 cost Tesla

Q: Q.1 Give a short answer for only Six of the following 1. Explain the construction of turbine meter…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: (i) Draw the functional block diagram of the DC motor system. e_(s) (ii) Derive the transfer…

A: We will refer the electromechanical system of dc motor

Q: A d.c. shunt motor is rated 100 hp, 600 V, 1800 r.p.m., and is 88 % efficient when operating at…

A: Given data: Output power of the motor P0=100 hP Po=100 hP =100×745.7 =74570 W Terminal…

Q: 3. Find Thevenin's equivalent circuit for the circuit shown below 8 b. 100 V 12 RL O cs

A: To obtain Thevenin equivalent circuit we have to calculate open circuit voltage and equivalent…

Q: S A resistance R of. 5kr is shunted by a conductance Gof 5oS. The Combinatrin draws a curront of lo…

Q: parallel circuit has an inductive reactance of 30 ohm, a capacitive reactance of 10 ohm, and a 10V,…

Q: 1- Precise the features of the Finite Impulse Filter (FIR) 2- mention the different Design methods…

A: Question 1: Features of FIR filters: 1.FIR filters are always stable because these filters have…

Q: A resistor of 50 ohms and an impedance pf 100 + j50 ohms are connected in parallel across a 220v…

Q: 3 9. if C(s) = s(s²+4s+3) ,the form of response will be c(t) = (Write in A, B,C for residues) 10. o…

Q: Find the closed-loop transfer function, C(s)/R(s) for the system shown in Figure Q3using block…

Q: oblan the Clased Logp fraester fuachon Cd) by using Mason's farmula ky the splam below s

A: The closed loop transfer function can be obtained by using the mason's gain formula. To compute the…

Q: 1. Same figure, solve the loop and branch currents using Maxwell's theorem.

Q: Haw I Consider the sytam shown bebu. ablase the closed Loo ransler functin C6)/AS) す +1

Q: P1] Two resistors must beselectedso that the cumont in one is Four times the cuncent in the othera…

Q: calculate the load current.

A: Voltmeter- Measuring device used to measure voltage. It is connected across (parallel) the element…

Q: Which formula is used to calculate the RMS voltage os a sine wave? O 0.707 x peak 0.637 x peak O…

Q: Polarizability is defined as the

Q: ANSWER THE FOLLOWING Find the transfer function X2(s) / F(s)

Concept explainers

Antenna Array

An antenna array is a group of antennas joined together and arranged in a regular pattern to form a single antenna capable of producing radiation patterns that individual antennas cannot. As the antennas are constructed as an array, sufficient spacing and phase must be given.

Question

QUESTIUN
For the transsmision line below find the average incident Power pi and the average refelcted Power p Assume the frequency of operation is 1 GHz and velocity of propagation is 90% the speed of light.
ave
Transmission line
ZL = 100 +j50
Vi = 5 Cos(wt)
Zo =50 ohm
50m
Load
2W; Pve
=0.5W
O pi =226m W; P' =37mW
Op
=453mW; P' =113mW
O p' =265mW; P' =53mW
ave

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

3) Solve the cutoff frequency for the first mode and second mode of WR975 Wave guide TABLE 7.1 Some Standard Rectangular Waveguides Waveguide de signation a (in) b (in) t (in) fe, (GHz) Frequency range (GHz) WR975 9.750 4.875 0.125 0.605 0.75-1.12 WR650 6.500 3.250 0.080 0.908 1.12–1.70 WR430 4.300 2.150 0.080 1.375 1.70-2.60 WR284 2.840 1.340 0.080 2.08 2.60-3.95 WR187 1.872 0.872 0.064 3.16 3.95-5.85 WR137 1.372 0.622 0.064 4.29 5.85-8.20 WR90 0.900 0.450 0.050 6.56 8.2–12.4 WR62 0.622 0.311 0.040 9.49 12.4–18
Problem 5. We are transmitting our 12/4 APSK waveform with outer ring voltage 5 Volts and inner ring voltage = 2 Volts. The constellation ring ratio in dB is? a) 6.25 b) 7.959 c) 9.875 d) 9.945 e) 19.891
3. Generate a square wave of 0.5Hz with a duty of 50% on pin P1.0 as XTAL = 12 MHz. U1 12DXINT PODADO P0.1/AD1 PO 2/AD2 18 XTAL2 PO.3/AD3 P0.4/AD4 34 PO.S/ADS PO.6/AD6 9 32 RST PO.7/AD7 P2.0IAS 21 P2.1/49 P22/A10 PSEN ALE P2 3/A11 P2.4/A12 P2.5/A13 P2.6/A14 25 26 EA 20 P2.7/A15 10 P1.0 2 P1.1 P12 P1.3 P3.ORXD P3 1/TXD11 P32TS 12 P3.3ANT113 P1.4 P1.5 P34/7014 P15/T1 P3.6WR 15 16 17 P1.6 P1.7 P3.7/RD 50651 4 4 I R1 0.01 R2 0.01k D2 LED-BIBY D1 ■ LED-BIBY 30 31 -2.1
b) If quantity A is PATAT with TC of 2mV/C, and quantity B is CTAT with TC of -1mVrC, then determine the following quantities if they are PTAT or CTAT 1. 1/A 2. 1/B 3. A+ 5°B
Find the core diameter for a SMF in the 2nd window if ncore=1.48 & ncladd=1.478 ?
what are the modes of waveguide from where does they origionate?
This question from micorowave system course.
IN rectangular waveguide, we know that in TM mode field, Ez (longitudinal field) is out f phase by 90 degree, why is it?
What does the TE mean? Why does one have a 10 as subscript and the other mn? What is a broad and short dimension and a rectangular waveguide?
A 2 V signal is incident to the interface from a 75 Ohm region propagating to a 50 Ohm impedance region. What is the reflection coefficient? What is value of the incident, reflected and transmitted wave? What voltage would you measure on either side of the interface right after the signal goes through the interface.
A 3V sinusoidal signal with frequency 100 Hz amplitude is applied to channel A of an oscilloscope. A sinusoidal signal with the same frequency but opposite phase and amplitude of 1.5V is applied to channel B. What will be the equation of the Lissajous curve when the oscilloscope is switched to XY mode while the channels are at the same Volt/div setting?
For, z=0.1 and Wn= 5: Peak amplitude = 1.53 Settling time * 7.6 seconds true O False