Given data: Weight of dry soil=40 KN Volume of soil=2.36 m3 Find dry unit weight

Q: Situation. A floor plan of a proposed five storey concrete building is shown. It carries the followi...

A:

Q: a) Compute the depth of compression block   and b) the ultimate moment capacity of the beam shown in...

A: Answer We are given  f'c = 28 Mpa fy = 414 Mpa d = 600 mm As =  5-32 mm As  = 5*π4*322 As = 4021.24 ...

Q: What is the correct representation of the soil?

A: this question is taken from the topic soil classification in soil mechanics: the explanation is give...

Q: The figure below shows a gravity separation vessel at steady state. The separation vessel is cylindr...

A: Given : To find - Determine how long in minutes before the separation vessel will flood.

Q: Without writing shear and moment equations, draw shear and moment diagrams for the beams in the foll...

A:

Q: A hunter fired on a bird lurking on the top of a tree at an angle of 45o with the horizontal but nar...

A:

Q: 2. A municipal solid-waste site for a city must be located at Site A or Site B. After sorting, some ...

A: The calculus helps in understanding the changes between values that are related by a function. It is...

Q: For the standpipe shown, determine the discharge for the following depths. C Cad 0.6. a. 1m b. 1.5 m...

A: Given, cw=corf=0.6b=2 md=1.2 mg=10 m/sec2

Q: Discuss and give some applications for glass-, carbon- and aramid- reinforced polymer composites.

A: Glass Reinforced Polymer Composites: 1. It is used in manufacturing electronic equipment such as TVs...

Q: What is the slope in a fixed support with a settlement of 1 mm? O 0.5 O undefined O 1 How many slope...

A: ASKED: What is the slope in a fixed support with a settlement of 1 mm.   A fixed support is a type o...

Q: pressure on a closed tank reads 68.86 kPa. What is the equivalent height in terms of Oil having a sp...

A: Given data- Pressure (P) = 69.86kpa Specfic gravity of oil(S) = 0.85 Density of oil (p) = 0.85 × 100...

Q: 2 decimal pl

A:

Q: Problem 1 The continuous beam shown in the figure is fixed at both ends A and D, and supported by ro...

A:

Q: 8. The composite bar is stress-free before the axial loads P1 and P2 are applied. Assuming that the ...

A:

Q: Using SDM for the frame shown below, determine the following structural parameters, FEM and support ...

A:

Q: Determine the reaction at point A and the tension in cord AB. (Partial ans. TAB = 7000 lb)

A: it is given that ;

Q: Beam is loaded with uniform dead load of 5KN/m, Uniform live load of 15 KN/m & a series of moving co...

A:

Q: m L/2 L/2 Find the maximum deflection in terms of m,q,L,p Where is the maximum deflection of the bea...

A:

Q: 2.8m- 3m 34 kN 18 kN/m 15 kN/m B D 21 AE 21 4m 3m 5m 3.6m

A:

Q: A rectangular open channel, with a constant discharge of 32m3/s, has a smooth expansion from (1) to ...

A: Given data: Q=32 m3/s Section 1-1 y1=2.4 mb1=3.6 m Section 2-2 y2=0.8 m

Q: A sluice gate, as shown in figure 01, is used to control the upstream water level in a 3 m wide rect...

A: Given data, Width of channel b = 3 m Discharge Q = 15 m3/s  

Q: 20 kN 24 kN/m 16 kN/m 5 m A 3.0 m - - 3.0 m 31

A: An indeterminate frame structure is given and it has been asked to determine moment in member AB. Pl...

Q: PROBLEM:  For the base plate shown in the attached figure: 1) determine if the base plate is adequat...

A: While a foundation is required for a column to distribute the column load over a sufficient area of ...

Q: In an open channel, velocity of flow was found to be 1.23 m/s. If average bed shear stress is 1 N/m2...

A:

Q: Given data : Kinetic energy%3D200 J Mass-10 kg Determine velocity

A:

Q: Show complete solution Compute for the horizontal and vertical components of the structure shown

A:

Q: K 10 ft M 10 ft A,=0 Ba C |E |F 15 ft-15 ft--15 ft--15 ft---15 ft--15 A, 2900 lb 1200 Ib 1500 Ib 180...

A:

Q: For the timber beam shown, draw the shear and moment diagrams and determine the maximum bending stre...

A:

Q: At a reservoir about Delhi the following climatic data were observed. Estimate the mean monthly and ...

A: Given data,

Q: Determine the reaction at point A and the tension in cord AB. (Partial ans. TAB = 7000 lb) %3D 30° B...

A: Given -

Q: Water at 300 K flows, under the influence of gravity, through a vertical packed bed of spheres 2 cm ...

A: We have to determine the value of superficial velocity of the water flowing through the bed as per t...

Q: sianion Bear ing | Length A 26°10' 285.10 104° 35' 1 ar 30' 358018' G10.48 720,48 203.00 69 7.02

A: As per company policy, we have solved first three subparts in the above question Repost the question...

Q: Design a cased column to carry an axial load of 1100 kN. The column is 5 m long and restrained in po...

A:

Q: Shear and Moment Diagram: 600 lb/ft CA 1200 lb · ft 4 ft -4 ft→ 6 ft Point of Zero Shear: QIFICA Val...

A:

Q: A 30 m long tape is held between supports under a tension of 120 N during calibration. If the tape w...

A:

Q: Problem 2 W1 A B C

A:

Q: Explain the physical significance of the above equation and give the type of jump you would expect b...

A: Physical significance of given equation and type of jump between section 2 and 3### Hydraulic jump #...

Q: solve the following using slope deflection method:

A:

Q: 225 P,- 8 P- 10 9.- 18 Ra H 2 (m) 1 (m) 4.50 (m) 1.50 (m)

A:

Q: A single leg mercury manometer (as shown in the figure) is often used to measure differential pressu...

A: Given data,

Q: A culvert has an expected life of 40 years and is designed for a flood magnitude of rank 3 out of th...

A: The answer is found to be  Return period T=14.8 years Risk = 93.91% For explanation please refer the...

Q: A 100 m tape weighing 3 kg was standardized and found to be 0.02 m short at temperature of 10degC an...

A:

Q: Fr aroo us syse'as sta in telrg ate so Span es = E3 Socia t30ebert nditalmfror - 3 Stang of pra 20e ...

A:

Q: A vertical tube 4m long, with one closed, is inserted vertically with the open end down, into a tank...

A:

Q: EA Problem 2: In the following structure determine the internal force in spring. Assume K = 4L E E A...

A: Given data -  

Q: Six vehicles were observed passing a point for every 25 sec. the density of traffic is 30 veh/km. Fi...

A:

Q: 4.73 A 50-kg crate is attached to the trolley-beam system shown. Know- ing that a = 1.5 m, determine...

A: We will take moment at B to be zero

Q: W1 A 幸 10 ft 10 ft Set w1 (k/ft) A (1,2,3,4,5) B (6,7,8,9,0) 3. If the given beam has constant El, s...

A:

Q: through a rectangular channel 8.15m wide, a depth of 1.22m and the velocity is 4.6m. The turbine eff...

A:

Q: Solve for the ff. 1. Cable carries uniform 20 kN/m for entire length. What is the value of a? 2. Ten...

A:

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.