he angle of internal friction of a cohesive soil which was tested using a tri-axial shear apparatus is equal to 26.57 degrees. Failure occurred when the shearing stress is 250 kPa and the normal stress is 480 kPa. Determine the maximum principal stress at failure in kPa, deviator stress at failure in kPa, and cohesion of the soil in kPa. Round off to two decimal places.

he angle of internal friction of a cohesive soil which was tested using a tri-axial shear apparatus is equal to 26.57 degrees. Failure occurred when the shearing stress is 250 kPa and the normal stress is 480 kPa. Determine the maximum principal stress at failure in kPa, deviator stress at failure in kPa, and cohesion of the soil in kPa. Round off to two decimal places.

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter6: Vertical Stress Increase In Soil

Section: Chapter Questions

Problem 6.12P: Refer to Problem 6.1. Using Eqs. (6.3) and (6.29), estimate the average stress increase (Δσav) below...

See similar textbooks

Similar questions

the angle of internal frictional of a cohesive soil which was tested using tria-axial shear apparatus is equal to 26.57. failure occurred when the shearing stress is 250 kPa and the normal stress is 480 kPa. a. determine the maximum principal stress at failure, in kPa. round off to two decimal b. deternmine the cohesion of the soil in kPa. round off to two decimal c. determine the deviator stress at failure in kPa.round off to two decimal
A soil specimen is subjected to a tri – axial test. The soil specimen is cohesionless. If the shear stress that causes failure is 300 kPa. and the normal stress at failure is only 500 kPa 5. Determine the angle of shearing resistance in degrees 6. Determine the angle that the failure plane measured from the major principal plane. 7. Determine the total axial stress in kPa at which failure is expected to occur.
The angle of internal friction of a cohesive soil which was tested using a tri-axial shear apparatus is equal to 26.57°. Failure occurred when the shearing stress is 250 kPa and the normal stress is 480 kPa. Determine the maximum principal stress at failure, in kPa. Round off to two decimal places. (ANS: 884.55)
At failure, the major and minor principal stresses on a triaxial test are 200 kPa and 110 kPa respectively. If the porewater pressure at failure is 25 kPa... Q: What is the sine of the angle of shearing resistance of the soil? Round off your answer to two decimal places.
2. A series of consolidated, undrained triaxial tests were carried out on specimens of a saturated clay under no backpressure. The test data at failure are summarized: Confining Pressure (kPa) Deviator Stress (kPa) Pore Water Pressure (kPa) 150 192 80 300 341 154 450 504 222 a. Draw the Mohr circles and find the cohesion and friction angles in terms of effective stresses. b. Compute Skempton’s A-parameter at failure for all three specimens. c. Is the soil normally consolidated or overconsolidated? Why? d. Another specimen of the same clay that was consolidated under a cell pressure of 250 kPa was subjected to a consolidated, drained triaxial test. What would be the deviator stress at failure?
Situation 9 - The angle of internal friction of a cohesive soil which was tested using a tri-axial shear apparatus is equal to 26.57°. Failure occurred when the shearing stress is 250 kPa and the normal stress is 480 kPa. Determine the maximum principal stress at failure, in kPa. Round off to two decimal places.
1.A dry sand is known to have an angle of internal friction of 29. A triaxial test is planned, where the confining pressure will be 41 kPa. What is the maximum axial stress, in kPa, (major principal stress) that can be applied? Calculate the value to 1 decimal place. Do not provide units in your answer. 2.A clay soil is subjected to a triaxial test under unconsolidated-undrained conditions. At failure, the major and minor principal stresses are 8401 psf and 4875 psf, respectively. What is the shear strength of this soil if the confining pressure is doubled? Provide your answer in psf with no decimals.
A triaxial test conducted on cohesionless soil gives the following results: Deviator stress at failure = 410kPa The angle of shearing resistance = 32 degrees Determine the following: a. Confining pressure in kPa b. Shear stress at failure plane in kPa c. Angle that the failure plane makes with the principal plane (degrees)
A direct shear test, when conducted on a remolded sample of sand, gave the following observations at the time of failure: Normal load = 288 N; shear load = 173 N. The cross-sectional area of the sample = 36 cm2. Determine the minor principal stress in kPa. Pls include fbd.
a triaxial test was conducted on a cohesionless soil. at failure plane, the normal stress is 400 kpa and the shearing stress is 300 kpa. 50. what is the nearest value to the angle of internal friction of the soil?
The following data were obtained from a triaxial test on a cohesive soil: Maximum shearing stress at failure plane = 65kPa Angle of friction = 28 deg Cohesion = 31kPa Determine the plunger stress in kPa. Determine the minimum confining pressure, in kPa
SITUATION 5: A sand sample is subjected to direct shear testing at it's (in - situ) water content. Two tests are performed. For one of the tests, the sample shears at a stress of 400 kPa when the normal stress is 600 kPa. From these data, 15. Determine the value of the apparent cohesion. c. 230 kPa d. 221 kPa а. 100 kPa b. 179 КРа 16. Determine the corresponding angle of internal friction. a. 22.65 degrees b. 26.57 degrees c. 32.54 degrees d. 18.43 degrees