I Analysis at Vc R3 e N, VE VS2-VS1 R₁ Ve 2-4 20 2 V-6 4 Vet 2 3 0 3V₂ + 6V₂-36 + 4 Vet8=0 13 Ve = 28 volt Required Vc. 4 + + + Ve= 288 73 voltage + Vet Vsz R₂ Vct 2 3 Ve= = 2.1538V 2.1538 valt Ans

Q: For the circuit shown in fig. bellow Vcc= 20 v, Vin=2mv, B= 100, Rc-4k ohm, RE=2k ohm, RL=1k ohm,…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Class C commutation technique is forced commutation technique complementary commutation technique

A:

Q: Find the Nyquist rate for the signal: x(t) = 4 sin(10лt) + 3 cos (67лt). Select one: O a. 77 Ob. 134…

A:

Q: Q3) Determine the Thévenin equivalent circuit for the network external to the resistor R= 680.

A:

Q: Consider a delta modulation (DM) system used to transmit a voice signal, which is uniformly sampled…

A:

Q: b. +20 V Si Ge Si +10 V 1.2 kQ 2 kQ 4.7 kQ -2 V

A: a) Circuit is given as:

Q: 4.10) A buck regulator has an input voltage of 12 V and the required output voltage is 5 V. What is…

A: Given, A buck regulator has, Input voltage, Vin=12 V Output voltage, Vout=5 V

Q: PROBLEM 1 In the region of free space that includes the volume 2<x, y, z <3, D = 2z (yz ax + x² ây -…

A:

Q: In a balanced three-phase Y-Y system, the source is an acb sequence of voltages and given Vcn =…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: Consider the following signal: 5 x(n) = 3"+2sin( 1.1 Determine the z-transform X(z) of the signal…

A: Consider the following signal as given below: x(n)=3n+2sin5π6n-π3u(n) 1. We need to determine the…

Q: Q: Draw output voltage waveform for this circuit if ß=50. +10v +5v -1v Vi 2 3 4 t(ms) Vi 50k www…

A: We need to find out the output voltage for given circuit

Q: An AC source has an output rms voltage of 78V at a frequency of 80Hz. If the source is connected…

A:

Q: Specialize the bridge reliability formula to the case where : Ri(t)=et, and find Rbridge(t) AND…

A: Given  Specialize the bridge reliability formula to the case   where : Ri(t)=et, and find Rbridge(t)…

Q: In the region of free space that include the volume 2 < x, y, ,Z<3, D = 2z (yz ax + x² ay - 2xy az )…

A:

Q: the circuit below with Ipon = 6mA,

A:

Q: 3) ||4₂ Vo R4 R5 0.1k 0.5 k V1 = 0.5V V-=-11 Det vo when the wiper arm of potentiometer Is at: c) V-…

A: Potentiometer: This is also known as POT. It is a three terminal device and used for measurement of…

Q: The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH…

A: Brief description : In the above given question they have mentioned a series RLC circuit. The values…

Q: Q/ We need to send data 2 bits at a time at a bit rate of 8 Mbps. The carrier frequency is 10 MHz.…

A:

Q: b. Design a summing amplifier circuit with respect to the output voltage given the following…

A:

Q: Q: Draw output voltage waveform for this circuit if ß=50. +10v +5v Vi -1v--- 1 2 3 4 t(ms) 50k www…

A: We need to find out the output voltage for given circuit

Q: A.  Make a diagram of a series circuit comprising of a switch, a 100V battery, and 3 loads. B.…

A: In series connection the elements should be connected back to back and in parallel connection the…

Q: Determine the dielectric constant of material in which the polarization and electric field values…

A:

Q: Find the Nyquist rate for the signal: x(t) = 4 sin(10лt) + 3 cos (67лt). Select one: O a. 77 Ob. 134…

A:

Q: nd Leq 17 pH Lea ell 72 pH 7 pH ll 4 nH 77 pHE 12 nH 1 nH 14 pH ell ele ell

A:

Q: The following is given for a series R-L-C circuit:  resistor (R) = 8 Ohms, an inductor (L) = 32 mH…

A:

Q: 91 kQ 18 ΚΩ • 330 ΚΩ VOSQ 1.1 k Vc 0-100 Vo LOSS V=-OV le E o 20 V 100 1.2 kQ

A:

Q: Find the Nyquist rate for the signal: x(t) = 4 sin(10лt) + 3 cos(67лt). Select one: O a. 77 O b. 134…

A: Given data, Signal, xt=4sin10πt+3cos67πt

Q: Per-Unit System 3) If a 250MUA,11/400 KU, Three-Phase power Transformer has Zpu of 0.05 pu on the…

A:

Q: How can you use 2 to 1 Mux to construct 16 to 1 Mux.

A: 16 to 1 MUX using 2 to 1 MUX:

Q: A parallel-series filter like the figure attached is to be designed to pass a wave having a…

A: Capacitance and inductance are the components used for the storage of electrical charge. When…

Q: Given the following voltages: el = - = -100sin(wt-π/3), e2 = 250cos(wt+ π/6), e3 = 150sin(wt+ π/4),…

A: Polar and rectangular form: Polar and rectangular form is a representation of the point in the…

Q: Determine the exact solution of the following differential equation y = 2- y at y(0) =1. So the of…

A:

Q: Consider the system shown. E is a standard 120 V input. If  the three loads are 45 W, 60 W and 75 W…

A: Given data, There are three loads which take 45 W, 60 W and75 W. E  is a standard input voltage…

Q: Q: Draw output voltage waveform for this circuit if B=50. +10v +5v -1v Vi 2 3 4 t(ms) 50k +10v 10k…

A: We will find out the output for given circuit

Q: Find the Im H equivalent Impedance For i БОО НЕ 2mH

A:

Q: Find the total number of watts (P), VARS (Q), VA (S), PF, and the current I. Draw the power…

A:

Q: D THE (a) Logic diagram QDQ(+1) 000 011 100 111 (b) Characteristic table 0

A: Logic gates are divided into seven part . This gate is used in digital electronic, it is based on a…

Q: A capacitor have an area and length of 80mm² and 1.75mm. The energy stored of the capacitor is…

A: We need to find out voltage across capacitor

Q: Draw the Ladder Logic symbols of: B. Normally Closed contact. C. Output or Coil. D. Not Output or…

A:

Q: Q: Draw output voltage waveform for this ircuit if ß-50. +10v +5v -1v Vi 2 3 4 t(ms) Vi 50k +10v…

A: We need to find output voltage for given circuit

Q: A 100- resistor, an uncharged 100-µF capacitor and a switch are connected in series across a 24-V…

A:

Q: 25-x2 dy dx c)

A: The above Integration can be solved by using the properties of Integration by parts.  Solution is…

Q: B. In a series of tests to determine the parameters of an eight pole, three-phase 3300 V, 50 Hz, 500…

A: As per Bartleby policy we can answer only three subparts. Please repost the question again for…

Q: What is the real power delivered by the source (in W)? What is the reactive power delivered by the…

A:

Q: Solve the follwoing questions with complete solution. Question 6 Show that the same work is done in…

A: Solution- Work done for moving a charge to point ( 0,0,0) to ( 1,2,3), We know, F→=-qE→ dl→…

Q: Using Picard's method

A:

Q: Class C commutation technique is forced commutation technique O complementary commutation technique…

A: We are authirized to answer only 1 question at a time since you have not mentioned which question…

Q: A three-phase substation bus supplies a wye and a delta connected constant impedance loads. The…

A: Solution

Q: between Find the equivalent capacitance "a" and "b" for the combination of capacitors. shown: (Note:…

A:

Q: For the system given, find the value of K that would yield a steady-state error of 8%. Explain R(s)…

A:

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).