(i) Apply the cyclic redundancy check (CRC) based error detecting scheme for the message 11001001 is to be transmitted using the CRC generator polynomial x³+1 to protect it from errors. Then what should be transmitted bits and also verify at receiver end the code word is re-form the original data or not. (ii) List out the available error detection methods in DLL.

(i) Apply the cyclic redundancy check (CRC) based error detecting scheme for the message 11001001 is to be transmitted using the CRC generator polynomial x³+1 to protect it from errors. Then what should be transmitted bits and also verify at receiver end the code word is re-form the original data or not. (ii) List out the available error detection methods in DLL.

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 41VE

See similar textbooks

Similar questions

What is the number of padding bits required using SHA-512 if the original message is 6600 bits long?
In the steps of “Append the padding bits” in SHA-512 system (shown in Figure 1), the message is padded so that its length is congruent to 896 mod 1024 or (length ≅ 896 mod 1024). State the value of the following padding field is the message length is: a) 1919 b) 1920 c) 2942
3. (b) A sender needs to send the four data items 0x1236, OXABCC, OX03BC, and OXEEEE. To avoid confusion, Ox is written in the prefix to denote that the data is in Hexadecimal. For example, Ox3456 is 3456 in hexadecimal. Now answer the following: i. Find the checksum at the sender site. ii. Find the checksum at the receiver site if there is no error.
Assume that the following block of 16 bits is to be sent using a checksum of 8 bits. What is the pattern (codeword) sent? The block 0f 16 bits is 10101001 00111001.
QUESTION1 "Rabenstein code was used to send a message with 4 information bits, you receive 100110001 if you can expect at most one bit of corruption, what were the original information bits?" QUESTION 2 Givon the codeword set 111111 000111 110001 101100 011010 Add another codeword to this set that has distance at least 3 to all other codewords.
The parity check matrix is given as shown:Determine the format of the codeword. c = [message | parity bits] c = [parity bits | message] c = [message | parity bits | message] none of the answers
Given dataword 101001111 and divisor is 10111, show generation of cyclic redundancy checking (CRC) codeword at the sender site (using binary division).
The code containing of 8 code words which encrypt the communications zero to 1 1 1 as follows: State the succeeding questions with explanation on the question above: Is it linear? what is its block length, message length, charge and distance? how many mistakes can it detect, and how many situations is it incorrect? ( to reply this question grant the best range of errors that the code can assurance to end up conscious of or correct. for occasion a convenient parity bit can word two errors so we would say this can end up conscious of completely a single error. No calculations of risk are required.
What happens when you divide two instances using the cyclic redundancy check (CRC) decoder?
Suppose the received codeword is 1010011 and the generator polynomial is x3 + x + 1. Using CRC decoder, determine whether or not the received codeword is a valid codeword (i.e., a codeword with no error). Show the details of your work.
4. The Hamming (7,4) encoded sequence 1001000 was received. If the number of transmission errors is less than two, what was the transmitted sequence?
A cyclic redundancy check (CRC) is an error-detecting code commonly used in digital networks and storage devices to detect accidental changes to raw data. Propose your own Roll as data bits (e.g roll 1 to 100) and show how the sender adds the parity bits and write the final code word that will be sent. Value of Key is 1011 (derived from polynomial function). Also show in the receiver side that the correct data is received.