If a vertical 6-ft-high motor-control panel with several control devices is properly arranged, it will have A. relays located so that they may be easily adjusted. B. heavy copper connections which carry full motor current as long as possible C. resistors lined up at the bottom. D. meters located across the top.

If a vertical 6-ft-high motor-control panel with several control devices is properly arranged, it will have A. relays located so that they may be easily adjusted. B. heavy copper connections which carry full motor current as long as possible C. resistors lined up at the bottom. D. meters located across the top.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter3: Magnetic Starters

Section: Chapter Questions

Problem 20SQ

See similar textbooks

Similar questions

How is the protective relay work?
what is protective relays?
What size conductor would be required to supply three motors connected to a 440-volt, 3-phase branch circuit? Motor #1 is a 50-horsepower, code B induction motor; motor #2 is a 40-horsepower, code H induction motor; and motor #3 is a 50-horsepower, code J induction motor
list the probable causes if the armature does not release after the magnetic starter is de-energized?
20.a. A capacitive sensor is used to detect the presence of _______ objects.A. ferrousB. nonmovingC. nonconductiveD. magnetic20.b. A three-phase motor can be made to run backwards byA. connecting a resistor in series with the armature.B. reversing the control voltage connections.C. reversing three of its power leads.D. reversing two of its power leads.
What are typical uses for control relays
Technician A says when testing the voltage output, if the charging voltage is too high, the cause could be an open field wire from the regulator. Technician B says a loose or glazed drive belt could be the cause of too high charging voltage. Who is correct? A only B only Both A and B Neither A or B Technician A says that poor connection at the generator output wire can cause charging systems problems. Technician B says that many charging system circuits contain a circuit protection device. Who is correct? A only B only Both A and B Neither A or B
Which of the following components would not be connected in series with the contactorcoil A. Compressor internal overload switchB. Low pressure safety switchC. High pressure safety switchD. High discharge temperature safety switch
6.a. Arcing in manual starters is eliminated by the use ofA. overload relays.B. nonconductive contacts.C. blowout coils.D. spring-loaded handles.6.b. Chattering of AC contactors is prevented byA. blowout coils.B. air gaps.C. secondary windings.D. shading poles.
While discussing armature testing: Technician A says to test for shorts, place the ohmmeter leads on a commutator segment and armature shaft. Technician B says that continuity should exist between the commutator and the armature shaft. Who is correct?
B: Relay is consist two circuits, what they are? And determine whether the next relay is normally open or normally closed. 3
Why stationary armature type alternator is widely used ? Option 1: 2 slip rings used, more efficient cooling, less insulation Option 2: None of these. Option 3: 3 slip rings, insulation cost is high,no winding damages Option 4: 2 slip rings used, high insulation , no damages to windings.