In a carbonic acid buffer system, the total acid concentration is 0.55 M and the pH is 10.0. Calculate the concentration of each carbonate species, H2CO3, HCO3- and CO32-. The relevant Ka’s are K1 = 4.2 x 10-7 and K2 = 4.8 x 10-11.

Q: Polymer blends are Physical .Mix True O False O Condensation polymerization faster than Addition pol...

A: A question based on polymer that is to be accomplished.

Q: At 298.15K Ihe osmotic pressure of the unknown substance was found to be at 2.25x10 Pa. If the conce...

A: Temperature = 298.15 K Osmotic pressure of solution = 2.25 x 104 Pa Concentration of solution = 12.7...

Q: Find the equation and then choose (True or False)

A: This is addition reaction.  First one is chlorination .  Second one is hydrogenation. 

Q: The type of Bonding shows in this figure is Nacl- plo lonic Bond O Covalent Bond O Metallic Bond O o...

A: Ionic bond - A bond which involves the transfer of electron from an atom to another atom is called a...

Q: What will be the pH if 75 ml 1.0 M HCI is added to 100 mL of 1.0 M NaOH?

A:

Q: Provide suitable IUPAC name for each of the following compounds.

A: The naming of organic compounds can be done with help of rules of international union of pure and ap...

Q: Draw the schematic diagram

A: Preparation of para-aminobenzoate also known as benzocaine occurs in two step. Step1: Preparation of...

Q: | To prepare a buffer solution of pH 3.50, the best acid choice is %3D + . Consequently, the buffer ...

A: HCOOH  i.e, Formic acid would have been best choice  pKa=1⋅77×10−4  

Q: In the FCC crystal structure the cube edge length a 3= 2RV2 (4 R)/V3 O 4V3 R 4V5 R

A: Given  FCC crystal structure    FCC means Face centered cubic crystal structure.    

Q: Density of an aqueous solution of nitric acid is 1.43 g/mL. If this solutioin contained 36.0% nitric...

A: Given, Density of an aqueous solution of nitric acid = 1.43 g/mL Mass % of nitric acid = 36.0 % Volu...

Q: The IPUAC name for the following compound is (be sure to indicate stereochemistry, where appropriate...

A:

Q: The combustion of a sample of aluminium produces 0.25 mol of aluminium oxide and releases 419 kJ of ...

A: The reaction given is, Given: Moles of Al2O3 produced = 0.25 mol. And the amount of heat released =...

Q: 5. A sheet of BcC iron 1 mm thick was exposed to a carburizing gas atmosphere on one side and a deca...

A:

Q: How many Non-Polar Bonds are in the following hypothetical molecule: Electronegativity Values X: 1.3...

A: A non-polar bond has no partial positive and negative end whereas a polar bond has partial positive ...

Q: Consider the electrophilic addition of ICI (iodine monochloride) to propene. Which of the two atoms ...

A: The Iodine (I) atom will serve as electrophile because iodine atom is less electronegative than the ...

Q: What are the intermolecular forces present in acetone?

A: Note: As per company policy we are supposed to attempt first question only , please repost other que...

Q: When 11.0 g of CaCl2 dissolves in 45.0 g of water, what is the boiling point of the solution? Kb=0....

A: Elevation in boiling point is colligative property. Colligative properties are those which depend up...

Q: Vapor pressure affects directly the other collective property. What property is this? Choices: boili...

A: Note: You have posted 4 different questions at same time, but as per Bartleby guidelines I can ans o...

Q: Solution I contains water saturated with TI2C204(s), and solution II contains 0.02 M Na2C204 (aq) sa...

A: Answer:  The correct option is one i.e. a of Tl+ in I < a of Tl+ in II

Q: what does having a DBE(double bond equivalent) of 6 indicate when working with spectroscopy graphs?

A: DBE or double bond equivalent or LU or level of unsaturation is the number of unsaturations present ...

Q: 1. Consider the following chemical reaction which is first order with respect to H2 and second order...

A:

Q: How much is the energy required for vacancy formation for Pb at its melting temperature of 620.6°F i...

A:

Q: QUEESTION 7 |- 7a) Calculate the pH when 40.00 mL of 1.000 x 10 M HEF,en is titrated 7a) with 1.150 ...

A:

Q: Calculate Miller's coefficient for the surface that cuts the crystal's coordinates at the Cartesian ...

A: This question is related to crystal/ solid state. First we will plot the intercepts given on each ax...

Q: What is the best choice of reagent(s) to perform the following transformation?

A: In this question stereo chemistry have not mentioned to the given product. so it should be Br2 CCl4

Q: Calculate the heat evolved when 13.56g of oxygen gas (O2) is used to burn  white phosphorus at stand...

A: 1) Given, P4(s) + 5O2(g) ➝ P4O10(s)   ∆H = -3013 kJ/mol ∆H is in negative (-) which indicate release...

Q: 1. How do solute particles lower the vapor pressure and elevate the boiling point? Choose all that a...

A: Colligative properties: The colligative properties are those properties of solutions that depend on ...

Q: Time Altitude Pressure Temperature Volume Moles 9:00 pm 40 km 9.54 x 10 atm 115,580 L 9:10 pm 20 km ...

A:

Q: There magnetic quantum number determines the .movement of the electrons True False is branched (L.D....

A: 1. The magnetic quantum number of an electron is one of the four quantum numbers that state the posi...

Q: Br •anti HBr, ROOR Br or

A: Free radical  reaction - Free  radical reaction  is any chemical  reaction  involving free radical. 

Q: Introduction Increasing use of industry (in particular, combustion processes) by humans is increasin...

A: Causes of increasing CO2 concentrations in atmosphere 1. a) Deforestation It will likewise build how...

Q: What is the major organic product obtained from the following reaction? 1. Hg(OAc)2 H20 2. NaBH4 OH ...

A:

Q: Thermosetting polymers chemically changed at high .temperatures True O False O Electrons spin around...

A: About thermosetting polymers:

Q: CH3 R. 10. 11. R- 12. Br 15. I B 13. 14. 16. CuIF Br

A:

Q: Given the reaction: 3H2(g) + N2(g) ⇌ 2NH3(g) Calculate the Kp if Kc is 0.105 at 472°C. Use the formu...

A:

Q: Given the reaction: PCl5(g) ⇌ PCl3(g) + Cl2(g) (ΔHº = +87.8 kJ/mol). Which of the following changes ...

A: Le Chatelier's principle: According to the Le Chatelier's principle when a change in concentration t...

Q: Calculate the standard state AG for the following coupled reactions: A> B K'eq= 1.5 X 10S ×+Y= XY K'...

A: The standard Gibbs free energy is significantly related to the equilibrium constant and the relation...

Q: The following compound is treated with excess K2Cr2O7. Provide the name of the product that would fo...

A: K2Cr2O7 is an oxidising agent. It oxidised secondary alcohol into ketone.

Q: 1- The total energy of the electron is usually greater than zero 2- If the electron moves from one o...

A: 1. False ( the total energy of revolving electron is less tha zero  and free electron has zero energ...

Q: Question 1 You were asked to record observations before, during and at the end of the experiment. Be...

A:

Q: In an atom, the charge of the dense fraction is similar to that .of alpha particles True False O Epo...

A:

Q: Day to day and real-life instances are given below. Identify which  of the following is/are example/...

A: First law of thermodynamics It States that energy cannot be destroyed only can be converted from one...

Q: which one has higher buffer capacity o.1 M C6 H8O7 , 0.01 M Na3C6 H5 O7 or 0.01M C6 H8O7, 0.01 0.01 ...

A: Buffer capacity refers to the amount of acid or base that the buffer can neutralize before the pH ch...

Q: Question 3 Which of the following is the strongest base? a. iodide anion, I- b. fluoride anion, F- c...

A: b- fluoride ion is the strongest base because fluoride ion is the samllest among them and negative c...

Q: ative pH before the addition of any HCl. ative pH after 56.0 mL HCl has been added. ative pH after 7...

A: 1) Before HCl , it is base. Hence , pH > 7 (A) is correct option.  2) after adding 56.0 mL it for...

Q: Provide suitable IUPAC name for each of the following compounds

A:

Q: 8) A 100.0 mL sample of 0.20 M HF is titrated with 0.10 M KOH. The Ka of HF is 3.5 x 10-4. Determine...

A:

Q: Reactions Mechanism Major Product Mechanism Minor Product (SN1, SN1, E1, E2) (SN1, SN1, E1, E2) t-BU...

A: E2 and SN2 are the conjugate reaction and there is always a race between E2 and SN2 . In presence of...

Q: Formic acid has Ka = 1.8 x 10-4. Calculate the pH of a solution that is 1.43 M sodium formate, HCOON...

A:

Q: Part A An electron acquires 6 60x10-16 J of kinetic energy when it is accelerated by an electric fie...

A: Kinetic Energy of electron = 6.60 × 10-16 J Charge on electron = 1 Coulomb = 1.60 × 10-19 C