In GSM, there are 8 separate time slots that makeup what is known as a “TDMA frame’’. Each GSM time slot lasts for 577 µs (microseconds) and contains more than simply a sample of each individual signal. How many bits for control purposes are in one TDMA frame?

Q: 10. A 47 resistor and a capacitor with a capacitive reactance of 120 are in series across an ac…

A: SOLUTION GIVEN-->           LET                   RESISTOR = R ohm…

Q: PSPICE MULTISIM 4.29 Use the node-voltage method to find the pow- er developed by the 20 V source in…

A: First we will mark reference node then we will assign node voltages as V1 , V2 , V3 and V4 Now we…

Q: Check the linearity of the given systems: a) y(n) = 4x(n - 7) b) y(n) = 4x(6n)

A: Given:- a) yn=4xn-7b) yn=4x6n We have to find the linearity of the given system.

Q: by: -E₂ N hernators are connected in parallel and supply current to a volts. Alternator A has an…

A: Given: The solution of a particular question. To find: How did the expression ( inside the circle )…

Q: Question 4 (a) A PMMC movement with a coil resistance of 250 requires 0.8 mA for full scale…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: (a) Design a half-subtractor circuit with inputs x and y and outputs Diff and B out . The circuit…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: In the circuit shown, Find the value of the resistor R, for I = 40 mA. 510 (2 www Select one: O a…

A:

Q: QUESTION 3 A coil has an ac voltage of 120 V. The current through the coil is 10 -85⁰ A What is the…

A: Given data, AC voltage V=120 V Current flowing through coil i=10∠-850 A

Q: Draw logic diagrams of the circuits that implement the original and simplified expressions in…

A: Logic diagram:- It is a representation of Boolean arithmetic expression which consists of logic…

Q: Electrical oscillations are initiated in a series circuit containing a capacitance C, inductance L,…

A: (a) The amplitude Q=Qmaxe-Rt/2L at time t, with Qmax being the initial amplitude When Q=12Qmax we…

Q: A signal is sampled at 384 000 samples per second. The samples are encoded as 32-bit words a)…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: -Apply the superposition principle to determine the voltage (V) for network of Fig.3. ature of…

A: It is given that:

Q: A 2-wire d.c. distributor cable AB is 3 km long and supplies loads of 100A, 150A,200A and 50A…

A: We have a 2-wire D.C distributor cable with 3 Km long which supplies loads given A from feeding…

Q: For the following circuit find the operating point. What is the stability factor of the circuit?…

A:

Q: An alternating voltage is represented by V = 100 sin (2nt/0.01667). (1) Maximum value of voltage (2)…

A:

Q: A short 230 kV transmission line with a reactance of 18 ph supplies a load at 0.85 pf. lag. For a…

A:

Q: is the hard limiter system is memory-less or memory system? = y = 10, x ≥ 0 x < 0°

A:

Q: 1) Calculate Vo1, & Vo2 for the circuit in Figure 1. Si Vo1 47k02 M +12 vo Figure 1 3.3 M Voz

A: Since you have posted the multiple questions so we are supposed to answer the 1st one

Q: voltage gain. For the circuit shown in Fig. 25.32, find (i) input impedance (ii) differential

A: We have an circuit as shown above and we have been asked to find, Input Impedance Differential…

Q: Explain why the detector signal is negative

A: Detector signal : A detector signal is a device which is used to locate the nearest radio signal on…

Q: 3. Find Vo in the circuit.

A: Given:

Q: 5. Two 50 MVA, 3-phase alternators operate in parallel. The settings of governors are such that the…

A: When load increase then speed decrease and so frequency also decreases. Given , Settings of governor…

Q: An electric supply company having a maximum load of 50 MW generates 18x 10^7 units per annum and the…

A: We have been given data of an electric company supplying electricity which has, Maximum demand = 50…

Q: Problem 3: Obtain the currents i, and is for the circuit shown in Figure 3 using mesh analysis. +1 5…

A: Given: Circuit diagram,

Q: In the network below, find the power associated to the current source, for VI-8 V. V1 + 24 +VI 14 V

A: Given data, V1=8 V Given circuit diagram is,

Q: Ry ASAR ABDUR RASURAREN AZIN ASIA ASIO R₂ 120 R120 R120 Fig. (2) R20 Fig. (3)

A:

Q: Simplify the following Boolean expressions, using three variable K-maps: F(x, y, z)=x′yz+xy′z′+xy′z

A: using given function construct k map and then simplify the function by combining the cells.

Q: The voltage across an inductor with inductance of 18 mH is given by t<0 (V) t≥0 v₁ (t) = {e-st (V)…

A: Given: Voltage across inductor : vLt=0             t&lt;0e-5t V    t⩾0 where L=18 mH  and iL=0 for…

Q: A 400 V, 6 pole d.c. The field and armature winding resistances of a shunt motor are 400 ohm and…

A:

Q: The two wattmeter method is used to measure the power in a three-phase load. The wattmeter readings…

A: Given- Three phase load-Wattmeter readings=400W  &amp; (-35) WTo Find-The total active power Pactive

Q: 1.Consider the block diagram shown in the following figure. Let us simplify (reduce) this block…

A: Given block diagram,

Q: a) A 50 Hz, 4-pole turbogenerator rated 500 MVA, 22 kV has an inertia constant of 7.5 MJ/MVA. Find:…

A: Given- 4-Pole turbogenerator. P=4. G=500 MVA, 22 kV. Inertia constant H=7.5 MJ/MVA. To Find- (i)…

Q: a-) find the total current through the loop b-) Find the current density

A: a) The current in the loop is circulating as There is 3 section in the system.Section Idr→0,…

Q: A silicon diode has a maximum allowable junction temperature of 150°C. Find the maximum allowable…

A: Given data, Maximum allowable temperature Tj=1500 C Temperature at which maximum power dissipation…

Q: Power supply to a 10 pole induction motor is supplied by 4 pole alternator which is driven at 1500…

A: Given- 10 pole induction motor. 4 pole alternator. No. of pole P=4. Speed of alternator Ns=1500 RPM.…

Q: In an induction motor, if the rotor is locked, then the rotor frequency of induction motor will be:…

A: Given: In the induction motor, the rotor is locked.

Q: 3 Ampere current is flowing in a circuit having resistance 40 ohms. Find the woltage applied to the…

A: Given: In a circuit, Current I=3 A. Resistance R=40 Ω.

Q: Solve the output voltage Vo of the given circuit below. ID1 Ge 31.3 V 17.6 V 39.3 V 32 V 31.7 V Si…

A:

Q: The Stokes theorem uses which of the following operation O a. Laplacian O b. Divergence O c.…

A: Stokes theorem: According to stokes theorem, the close line integral of any vector function is equal…

Q: The three capacitors shown are 6µF each. If a 10 V battery is connected across the terminals A and…

A: Given circuit, Capacitance, C=6 μF Supply voltage, V=10 V

Q: Q1/ To Design 20-bit BCD adder can using 5 (4-bit binary adder), 10 F.A and 2 H.A O 2 (8-bit binary…

A:

Q: Show the eight exit paths in an ASM block emanating from the decision boxes that check the eight…

A: Given- Three control variables = x, y and z To proof- There are eight exit paths in an ASM block…

Q: An appliance uses 114 watts and is on 8 hours per day. If electricity costs 18 cents per…

A:

Q: What is RG rating of coaxial cable. Please give me detailed information. Don't copy previously given…

A:

Q: A silicon diode has a maximum allowable junction temperature of 150°C. Find the maximum allowable…

A:

Q: A 200 V, 6 pole, lap connected long shunt compound wound d.c. The resistances of the armature series…

A:

Q: Two transformers of the same type, using the same grade of iron and conductor materials, are…

A: Transformer: Transformer is a static device which is used for the transfer of voltage and current…

Q: What is RG rating of coaxial cable. Please give me detailed information. Don't copy previously given…

A: Introduction -  Coaxial cable - Coaxial cable is a form of copper cable that is particularly…

Q: Two signals mi(t) and m₂(t) both band limited to 5 KHz are to be transmitted simultaneously over a…

A: Given: A modulation circuit diagram with two different signals m1 and m2 and two different carriers.…

Q: PROBLEM 3: DETERMINE THE CURRENTS USING KCL IN THE во сошель, сets . Із SA LOA CRTA | 2 97 Туза 12…

A: We need to find out current for given circuit

Uplink and Downlink Segment

The uplink and the downlink are the terminologies that are used in the satellite communications. The data when sent from the ground to the satellite is called the uplink and data when sent from satellite to ground is called downlink. The uplink and the downlink process goes in parallel and this is also a two way communication.