In the figure &1 = 4.33 V, 82 = 0.962 V, R1 = 6.32 Q, R2 = 2.16 Q, R3 = 4.83 Q, and both batteries are ideal. What is the rate at which energy is dissipated in (a) R1, (b) R2, and (c) R3? What is the power of (d) battery 1 and (e) battery 2? (a) Number i 0.951 Units W (b) Number i 0.0411 Units (c) Number i 1.336 Units (d) Number 1.68 Units W (e) Number i 0.133 Units Save for Later Attempts: 1 of 3 used Submit Answer

In the figure &1 = 4.33 V, 82 = 0.962 V, R1 = 6.32 Q, R2 = 2.16 Q, R3 = 4.83 Q, and both batteries are ideal. What is the rate at which energy is dissipated in (a) R1, (b) R2, and (c) R3? What is the power of (d) battery 1 and (e) battery 2? (a) Number i 0.951 Units W (b) Number i 0.0411 Units (c) Number i 1.336 Units (d) Number 1.68 Units W (e) Number i 0.133 Units Save for Later Attempts: 1 of 3 used Submit Answer

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1. The no-load terminal voltage of a battery is 30 V. The terminal voltage drops to 22 V when supplying a current of 5 A. Determine the emf and the internal resistance of this battery. Ans. r= 1.6 ohm 2. Two identical zinc carbon batteries are available. When connected in series, they supply 0.5 A to a 4 ohm resistor. When connected in parallel, they supply 0.4 A to a 5 ohm resistor. Determine the emf and internal resistance of each battery. Ans. 2.667 V and 3.333 ohm 3. When supplying a current of 5 A, the terminal voltage of a battery is 15 V. The battery is then recharged at a rate of 3 A and the terminal voltage is found to be 21 V. Determine the emf and the Internal resistance of the battery. Ans. 18.75 V and 0.75 ohm 4. A battery with an emf of 12 V and an internal resistance of 0.8 ohm is to be recharged through a 20 V source. (a) show by means of a diagram the connection of the circuit elements. (b) What is the current in the circuit? (c) The recharging current is to be…
Q2 (a) Figure Q2(a) shows a clipper circuit made with a germanium diode. Given the voltage input, Vin = 20 Vp-p, VDc = 5 V, Rs = 10 N and R1=1 kN. (i) Sketch the full cycle of input voltage, Vin(e) in sinusoidal waveform. (ii) Determine the output voltage values for all input values. Show all the calculations and support your answers with the aid of diagram. (iii) Sketch the overall output waveform, VoUT (1).- R. + Vin Si Ge R VOUT Vpc Figure Q2(a)
Q2 (a) Figure Q2(a) shows a clipper circuit made with a gemanium diode. Given the voltage input, Vin = 20 Vp-p, VDc = 5 V, Rs = 10N and RL=1 kN. (i) Sketch the full cycle of input voltage, Vin(t) in sinusoidal waveform. (ii) Determine the output voltage values for all input values. Show all the calculations and support your answers with the aid of diagram. R. Vin Si Ge R VOUT Vpc Figure Q2(a)
Based on electric circuit shown in Figure 2. Determine whether the LED 1 and LED 2 is “ON" or "OFF" for V1 = 2V and V1 = 3.5V if for both LEDS are silicon LED. Explain the answer given. V1 OUT R1 OPAMP 100kN V2 LED 1 LED 2 4Vdc R2 500kn Figure 2: Op-Amp circuit with LED
The input voltage in the following circuit is Vs = 33.62 V rms and the frequency is 50 Hz. The value of R;=R2= 33.62 k2. What would be the maximum voltage that the voltmeter would measure (in Volts) if the diode has a forward voltage drop of 0.9 V. Vs (+ R1 0.5uF R2 0.5uF
An ideal battery of terminal voltage 22 volts charges two practical batteries connected in parallel to each other. The parallel connection of the said practical batteries is connected across the ideal battery. The two practical batteries have the following specifications: 10 volts, 0.2 ohm; 8 volts, 0.5 ohm. Determine the total power dissipated by the internal resistances of the practical batteries.
An ideal battery of terminal voltage 22 volts charges two practical batteries connected in parallel to each other. The parallel connection of the said practical batteries is connected across the ideal battery. The two practical batteries have the following specifications: 10 volts, 0.2 ohm; 8 volts, 0.5 ohm. Determine the total current being delivered by the source.
Shown below is a diode circuit. If the input signal Vs = 42 Vp-p and the DC voltage Vdc = 8 V, what is the output voltage (in volts) of the circuit during the positive alteration? No need to show your solution. Just write your numeric answer on the space provided. Round off your answer to 2 decimal places. C1 Si D1 Vo Vs 1.0kn Vdc
At 298 K, the nominal Zener voltage is found to be equal to 10 V. Given that the value of the temperature coefficient is 0.072 (%/K), what is the nominal Zener Voltage at 398 K?
A resistor R = 5 ohms and a condenser C = 0.02 F are connected in series with a battery E = 100 V. If at t = 0 the charge on the condenser is 5 coulomb, find the current I(t). Ans.: I = - 30e – 10t amp
Number 9 Please show your detailed solution. Number 9 Please show you detailed solution. A 50-ohm resistor is in series with a 40-?F capacitor across a constant potential source of 180 volts. Determine frequency that will give current of 3.13 amp. A. 250 Hz C. 160 Hz B. 200 Hz D. 140 Hz
2) In the circuit given in the figure, R = 6k2, Zener diode breakdown voltage VZ = 3.6V and www mm w wwm w Zener diode power value is given as 6.5mW. wwm the maximum diode current that can flow through the www w m m w mw ww m w ww md w m circuit, Calculate the maximum voltage value that can be applied w w mww m w w m www m w mentn Vz=3.6 v A to the circuit without damaging the diode. wm w w ww m ww