In the RL circuit shown below the total series impedance is known to be R =0.8 22 and L = 21.22 mH. The source voltage v(t) = 20,000 sin (377t + a). v(t) R A. Determine the value of a that produces no dc offset. B. Determine the value of a that produces the largest positive dc offset. For the value of a determined in part B find: C. The RMS value of the instantaneous symmetrical current, iac(t) D. The value of K (the asymmetry factor) at 3 cycles. E. The 3 cycle RMS value of the asymmetrical current, i(t)

Q: 3).. 94 select the proper answer for the following: 1) The main processes that have the…

A: We need to select correct option for given statements .

Q: Find vc(t) for t >0 in the following circuit. - ¹/4 u(t) + ¹/2 A (1 2 H 4Ω fiL(1) 1/4 F 892 + vc(t)

A:

Q: An LTI discrete-time system has impulse response h[n] = (2)"u[-n] Find the system response to a unit…

A: Note Z ( anu(n))=11-a z-1Z ( a-nu(-n))=11-a z

Q: 2.43 Apply voltage and current division to determine Vo in the circuit of Fig. P2.43 given that…

A: Given data The output voltage across the resistor of 1 Ω is Vout=0.2 V. We have to find out the…

Q: Consider a linear static circuit consisting of three resistors and two independent voltage sources,…

A: (d). given that a linear circuit with two independent voltage sources and three resistors. R1=R2=R3=…

Q: 3. Signal operations. For the continuous time signal shown below, sketch and label the following…

A: As per guidelines i have to answer only three sub parts please ask remaining again.

Q: (1-a) Explain the operation of the Zener diode in forward and in reverse bias.  (1-b) Analyze the…

A: Zener Diode:

Q: Consider the system defined by where x = Ax + Bu y = Cx A =1₁²₁9₁ B = [¹]₁ a) Test the…

A: Introduction Controllability and observability Controllability is the capacity of a control system…

Q: Q3: for Figure 3.96, find voltage vo, using: a) Nodal analysis b) Mesh analysis

A: The node and mesh equation can be obtained by applying kirchhoff's current and voltage law to the…

Q: A 220V do motor developing 25 hp (18.66 kW) runs at a speed of 1000 rimin. Calculate the torque in…

A: Given: Power Output= 25hp (18.65kW) Speed, N= 1000rpm To Find: Torque=?

Q: Determine i(t) for t >0 in the following circuit if is(t) = 5u(t) A. is (↑ ww 292 8/29 H 1/8 F

A:

Q: Find the impedance Z₁, for maximum average power transfer and the value of the maximum average power…

A: The circuit is given as For maximum power transfer to load, load impedance should be ZL=Zth*

Q: 5. A single phase full converter connected to 230V, 50Hz is feeding a load R=1002 in series with…

A: Given data, single phase full converter , Vrms=230Vm=2302 RL load ,  R=10 Ω Firing angle, α=45∘

Q: B-6-4. Show that the root loci for a control system with K(s² +65 + 10) s² + 2x + 10 G(s)- are arcs…

A:

Q: Find the Thevenin equivalent voltage and resistance for the circuit at terminals a-b. Draw the…

A: We have to find out the thevenin equivalent circuit for given circuit .

Q: a. Find the relationship between Vout and Vin in the Op-Amp below, and draw the diagram of Vout VS.…

A: Given:  a. b. and c.

Q: 6. A wind turbine travels with the speed is 20 m/s and area swept by windmill is 160 m², If air…

A: Given, Speed of wind turbine, V = 20m/s Area swept by windmill, A= 160 m2 Air density, ρ = 1.5 Kg/m3…

Q: SOLVE STEP BY STEP IN DIGITAL FORMAT For the following circuit, graph the output voltage vo(t) when…

A:

Q: t S g Call the solution y₁ (t). b. Observe that the only difference between equations (31) and (32)…

A:

Q: A 460V, 25 hp, 60 Hz, 4 pole, Y-connected wound rotor(R2) has the following impidances in Ω/phase…

A:

Q: 5.74 Find i, in the op amp circuit of Fig. 5.100. 0.9 V 10 ΚΩ Μ 100 ΚΩ Μ 20 ΚΩ 32 ΚΩ 1.6 ΚΩ 0.6 V

A: Given: In this question, the given details are, The given circuit diagram is, To find the value of…

Q: 19. (a) For different settings of the variable resistor (potentiometer) in Figure P1.19, what range…

A:

Q: 2 Cπ 2π α 2 SVm² sin wt² dwt

A:

Q: Figure P.2.7-4 2.7-4 For each of the periodic signals shown in Fig. P2.7-4, find the exponential…

A:

Q: Design the combinational circuit to realization the functions: F1(X,Y,Z) = m(0,1,5,7) F2(X,Y,Z) = Em…

A: Given functions are written below. F1X, Y, Z=∑m0, 1, 5, 7. F2X, Y, Z=∑m0, 2, 4, 5. We need to design…

Q: 29: if a three phase 220KV 50Km long transmission line loaded 10MVA. The conductor used is ACSR with…

A:

Q: What is the reactance (in Ohms) of a 0.12H inductor at 163rad/sec? (Give answer in 2 decimal places.…

A: Here they given L and w and asked to find the reactance.

Q: A 3-phase 450-V, 6-pole, 60 Hz Y-connected slip ring induction motor is driving at constant torque…

A:

Q: Capacitor capacities are C1=1 μF, C2=3μF, C3=4μF and C4=3μF. Also I calculated: C1 and C2=…

A:

Q: series RLC circuit.

A:

Q: 1) Find the currents I, and I4. 14_02 VA H ww. Ry 10-12 20 2 ww. R₂ 65 mw R5 20 V R₂ 255 2) From No.…

A:

Q: During the half-power frequencies, the current of a series RLC is. 0.5 twice 0.707 1.414 of the…

A: We need to determine the relation between the current of a series RLC circuit at the half-power…

Q: For the multi-stage amplifier below, let V₁1 = 12 mV, ro1 = 12 kOhm and r₁2 = 3 kOhm. Compute V₁2 in…

A:

Q: An FM signal, 2000 sin(27x10t+2sinx10¹) is applied to a 5002 antenna. Determine the carrier…

A: Given, FM signal is  S(t) = 2000 sin(2π×108t + 2 sin(π×104t)) This FM signal is applied to an…

Q: the unity negative feedback controller shown below, in which R(s) = thetades(s) is the desired pitch…

A: The given block diagram is shown below. The controller is a proportional-integral (PI) controller…

Q: Q)Design a Discrete Time Low Pass Filter for a signal. Butterworth Filter. Chebeyshev Filter The…

A: Note: The order of Chebyshev filter is a large number and involves many calculations, so we could…

Q: Determine Vs for the network. RB 470 ΚΩ G B Rc Rs C - 16 V 3,6 ΚΩ S D. E VD B=80 DSS = 8 mA Vp = -4…

A:

Q: Figure Zab be 1 of 1 ZL Part A Find the impedance seen looking into the terminals a,b in the circuit…

A: In this question We need to determine the impedance referred into primary side.  We know Voltage V=…

Q: A fluid system has two sensors, a pressure sensor and a flow sensor.  The pressure sensor has one…

A: Fluid System:

Q: H.W 1 Design produce an output given by Vo= 2V₁-5V₂-5 Sv₂d+ an op-Amp circuit that

A:

Q: Capacitor bank energisation causes current and voltage transient operating states. Thus, the maximum…

A: Given Line to line voltage = VLine =6.6 kV System frequency =fs =50 Hz capacitor kVA rating is =kVA…

Q: 11. Phase-shifting transformers used in the metering of apparent power demand of polyphase circuits…

A:

Q: *2.17 Determine currents I₁ to 14 in the circuit of Fig. P2.17. I 12 2Ω Σ4Ω 16A 13. I ΖΩΣ Figure…

A: The given circuit diagram is shown below,

Q: Sketch a functional block diagram of a dishwasher and briefly make a description of the processes…

A: It asked to draw the functional block diagram of a dishwasher. Also it asked make a description of…

Q: Scos(2nft) V ww 50Ω V1 m 40Ω 50Ω 10Ω | V3 0.22uF| 12Ω 70007 ImH

A:

Q: I need help calculating these frequencies

A:

Q: Find the Fourier transform of the function f(t) = (1, -b < t <b (0, otherwise

A: In this question We need to determine the Fourier transform of the given signal.  We know Fourier…

Q: Consider a transconductance amplifier that has a high-pass filter frequency response. The transfer…

A: Given,DC transconductance, tvs=1.1 mA/VInput resistance, Ri=500 ΩOutput resistance, Ro =110…

Q: Q.7 A fully controlled converter bridge feeds a highly inductive load with ripple free load current.…

A: Given- Triggering angle=30o To Find- Input power factor of the bridge.

Q: A 3-phase, 6-pole, 50-Hz induction motor has a peak torque of 6Nm and a starting torque of 3 Nm when…

A: Note:As per Bartleby guidelines we are supposed to provide solution for first 3 subquestion only. I…

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.