Is there anything I can learn from inspecting the bounding box that the Designer established?

Q: 3. Use the method of sections to determine the internal forces in members FE, BE, and BC. The…

A:

Q: 1- Find the final consolidation settlement 2- Having the final consolidation settlement of (20) cm,…

A: This question is from Consolidation in Geotechnical Engineering.

Q: A certain crop needs 3 cumec of water for irrigating 5100 hectares land up to 10 cm depth. Total 12…

A: Discharge Q=3 cumec Area A=5100 ha Water depth=10 cm Number of watering=12 Number of days=10 days…

Q: The following results were obtained from undrained tests on specimens of an over-consolidated clay:…

A:

Q: The difference in the water surface level of two reservoirs which are connected by a siphon is 8 m.…

A: Two reservoirs connected by a siphon- Length of siphon L=600 m, Diameter D=0.3 m, Friction factor…

Q: A trapezoidal channel of bottom width 25 ft and side slope 1:2.5 carries a discharge of 450 cfs with…

A: Open Channel Flow occurs due to the Gravity Force with respect to mass. In this channel the flow…

Q: Why do you have to solve for the other joints? Can't you just do Sum of Forces in Y direction for…

A: It is  needed to find forces in all members and find which meber has maximum tension and which has…

Q: A solid round steel rod with Sy = 350 MPa is 945 mm long and 62 mm in diameter. With a safety factor…

A:

Q: An image of a hilltop is 87.5 mm from the centre of a photograph. The elevation of the hill is 665 m…

A: Given -  Height of image, r = 87.5 mm Elevation of the hill, h = 665 mm Flight altitude, H = 4660 mm…

Q: A raft of size 4 m-square carries a load of 400 kN/m2. Determine the vertical stress increment at a…

A: Given: The size of the square raft is 4 m. The load is 400 kN/m2. The depth is 5 m.

Q: Q1: - Determine the centroidal coordinate of the shaded area shown in the figure below. Assume all…

A: ##CENTROIDAL Coordinates of Shaded Area ####

Q: Heavy fuel oil flows through 3 kilometers of cast iron pipe having a diameter of 250 mm. The…

A: Length of pipe (L) = 3 Km  Diameter of pipe (d) = 250 mm = 0.25m  Flow rate (Q) = 40 liters/sec…

Q: A railroad curve has De = 5°00', I = 27°00', and PI station=37+45.00 ft. Use the chord definition to…

A: Degree of the curve, Dc = 5o Deflection angle, I = 27o PI station = 37+45 ft

Q: Determine the stresses in steel and concrete of the concrete section shown. Assume N32 concrete &…

A: The compressive stress-strain curve of concrete is of particular interest because concrete is…

Q: A trial mix is required for a pavement slab being constructed exposed to freezing and thawing as…

A: Design strength of trial mix = 32 MPa Slump = 75 mm For sand: FM = 2.80 Absorption = 1.5% Nominal…

Q: fill is to be placed over the following soil profile shown below. Determine if the clay is normally…

A:

Q: A bar of 80 mm diameter and 800 mm length is subjected to an axial load of 200 kN. It elongates by…

A: Bar diameter d=80 mm, Length L=800 mm, Axial load P=200 kN, Elongation=0.30 mm, Diameter decreases…

Q: weight plus weight. of: ▪ Tiles 3 cm ▪ mortar 2 cm ▪ sand 7 cm ▪ plaster 2 cm partition 2kN/m² Live…

A: Floor slabs play a major role in structure as it is also connecting members to beams and slabs. It…

Q: A trapezoidal masonry dam is 10 m high and retains water upto the height of 8.5 m. The width at the…

A: Given : 10 m high, top width = 3 m Bottom width is 6 m height of water is 8.5 m Maximum allowable…

Q: Use the method of joints to determine the internal forces in each member of the truss. The structure…

A:

Q: What is the ROTATION at B (to the nearest 0.001 radians)? a = 10 ft b=9ft P=157 k E = 15 x 10³ ksi…

A: A cantilever beam is loaded at free end; a=10 ft=10×12 in=120 inb=9 ft=9×12 in=108 inP=157 k…

Q: r a detention basin is constructed as a trapezoidal channel with bottom width of 3 m and side slopes…

A: Given:- width=3m slope=2 horizontal to 1 vertical n=0.040 elevation=150m slope=0.0080m/m To find:-…

Q: Total observed runoff volume during a 6 hour storm with a uniform intensity of 4cm/ hr is 3 30 x…

A: Runoff volume =30 x 106 m3 6 hour storm, Intensity = 4 cm/hr

Q: company mines 300,000 tons of coal per year in a rural county. The coal is worth ​$73 per ton. The…

A:

Q: Calculate the runoff (cm) from a rainfall of 3 hours. The intensity of the rainfall is 2 cm/hr. The…

A: Intensity of rainfall = 2 cm/hr. Duration = 3 hours Evaporation = 8 mm = 0.8 cm. Infiltration loss =…

Q: Water is flowing steadily in a 0.4-m-wide rectangular open channel at a rate of 0.2 m³/s. If the…

A: Data Given: Width of a channel (B) = 0.4m Water flow rate (Q) = 0.2m3/s Flow depth (y) = 0.15m To…

Q: Determine the constant force F which must be applied to the cord to cause the 30-lb block A to have…

A:

Q: 23: Design a reinforced concrete rectangular beam shown in figure below, that must carry a service…

A: Factored Ultimate Moment is given by Mu = Wu*L28 Wu = 1.2*service dead load + 1.6*service live load…

Q: Draw Shear force, bending moment and axial force diagram. 16 крупи KN 40 m 8" 0 M T KN 20

A: The given frame is statically determinate frame and can be analyzed using the equations of…

Q: A body of length 3 m is moving normal to the direction of its motion moving through the water having…

A: Length of the body L = 3 m, Drag coefficient CD=0.6, Reynold's number  Re=9×106 Drag Force =…

Q: A section of a two-lane rural highway is to be realigned and replaced by a four-lane highway with a…

A: AADT=750 ESAL Construct time=5 years Design life=20 years Growth rate=2% Mi=1 Effective CBR=9…

Q: An asphalt concrete mix has a density of 2370 kg/m3 at an asphlalt content of 5.8%. The asphalt…

A: Density of asphalt concrete mix is 2370 kg/m3  Asphalt content of 5.8% The asphalt absorption is…

Q: 7. Draw the shear and moment diagrams for the loaded beam. And find the maximum moment and maximum…

A:

Q: with enough dilution water to fill a 300 mL BOD bottle. The bottle has an initial DO of 8.5 mg/L. At…

A:

Q: What is the pressuremeter test? Explain the procedure in brief with figures. How are its results…

A: Context: Pressuremeter test

Q: Sieve Size 3/4 in. (19 mm) 3/8 in. (9.5 mm) No. 4 (4.25 mm) No. 10 (2 mm) No. 40 (0.425 mm) No. 200…

A: Given, To determine, the suitable ratio for blending aggregates A and B to obtain an acceptable…

Q: Qus - A masonry dam is founded on pervious sand. A factor of safety of 4 is required against…

A:

Q: dry density for a soil sample having specific gravity of 2.7 and optimum moisture content of 16% (a)…

A: Specific gravity = 2.7 Optimum moisture content = 16 % This is a problem of Soil mechanics where we…

Q: 1) Using the Moment Distribution Method determine the support moments and reactions for the…

A: The beam is given as To find:- Support reactions Shear force and bending moment diagram Concept:-…

Q: 1. Use the method of sections to determine the internal forces in members BC, GC, and GF. The…

A:

Q: For the timber column shown in the two figures below, E 12 GPa and the allowable stress for…

A: Allowable compression stress in parallel = 9 MPa Young's Modulus, E = 12 GPa Depth of the column = 2…

Q: shearing stress in the pin at B and the axi t C are limited to 4040 psi and 5050 psi, r

A: The mechanics deals with the application of forces and reaction forces that are developed in the…

Q: Shown above is a table of coordinates of four points, in feet What is the area of the figure…

A: Point Co-ordinate X Co-ordinate Y alpha 10000 10000 bravo 12561 12561 charlie 9503 12561…

Q: CHAPTER 2 ASSIGNMENT: Use the NSCP 2010 for the following problem sets using the framing plan shown:…

A: As per the policy, the first three subparts are solved. post the remaining subparts as a separate…

Q: Question -If a particular pavement fails with 98 number of repetitions of 4500 kg load and the same…

A: 98 number of repetitions of 4500 kg load and Same pavement fails with W number of repetitions of…

Q: The staves or vertical members of the wooden tank are held together using semicircular hoops having…

A: The thickness of steel hoops = 0.5 inch Depth of steel hoops = 2 inch Internal Gauge Pressure = 2psi…

Q: The masonry dam shown in the figure is subjected to water pressure at upstream side. It is built on…

A: Find: Minimum width at the base to develop no tension

Q: A closely-coiled helical spring of round steel wire 5 mm in diameter having 12 complete coils of 50…

A: Diameter of the closely-coiled helical spring d=5 mm, Number of coils n=12, Mean diameter D=50 mm,…

Q: In construction ,inside the wall assemblies , resilient channels are sometimes installed for…

A: Resilient channels are used in construction to help reduce noise transmission between rooms. It is…

Q: A trial mix is required for a pavement slab being constructed exposed to freezing and thawing as…

A: Mix-design of the concrete: Mix-design of concrete involves the preparation of the mix for the…