It is required to measure a flow Q with an accuracy of ± 0.01 gpm by using flow sensor that has a transfer function of √ volts. The original measured signal has a frequency of 0.2 Hz, and the sensor output impedance is 10 kn. a- Design and implement a passive filter to attenuate 20 Hz noise to 1 % while having very little effect on the original signal. h

It is required to measure a flow Q with an accuracy of ± 0.01 gpm by using flow sensor that has a transfer function of √ volts. The original measured signal has a frequency of 0.2 Hz, and the sensor output impedance is 10 kn. a- Design and implement a passive filter to attenuate 20 Hz noise to 1 % while having very little effect on the original signal. h

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In Steady-State Operation o f Buck DC-DC Converter Explain how the switching frequency component is eliminated by the output filter network.
Discuss the disadvantages of increasing the order of the filter.
For the filter in the Figure shown: (a) What is the critical frequency? (b) Looking at the critical frequency formula, how would you increase the critical frequency value? (c) What is the voltage gain? (d) Looking at the voltage gain formula, how would you increase the gain?
A sinusoidal signal of 2 kHz frequency is applied at the input of a delta modulator with a step size of 0.1 volt. The sampling rate of the delta modulator is 20000 samples per second. What will be the maximum amplitude of the sinusoidal signal if there is no slope overload distortion?
• Design a classical rectifier to deliver 100W into a resistive load from a 120V, 60HZ mains. ac Quantify the effect for different values of filter capacitance on: >average output voltage >output voltage ripple >Input current shape, harmonic content and THD
B- An rate. analog signal having single frequency as 3 kHz is sampled with 5 kHz S Describe its frequency spectrum. What will be the output if the sampled signals a passed through a low-pass filter having cutoff frequency at 2.5 kHz? signal. are sent in the analog
What are the design consideration for protective filter? Help me with this
Discuss the effect of increasing inductor filter capacitor on the output voltage and current.
What are the advantages of active filters compared to passive?
Discussion add elaboration on the importance of active filter in electronic system & relate it to the current technology trend (min 3 pages)
A signal generator having a source resistance of 50 2 is set to generate a 1 kHz sinewave. Open circuit terminal voltage is 10 V peak-to-peak. Connecting a capacitor. across the terminals reduces the voltage to 8 V peak-to-peak. The value of this capacitor is -HF. (Round off to 2 decimal places).
4. Signal conditioning element basically takes the output of the sensing element and converts it into a form more suitable for further processing, usually in the form of a DC voltage, DC current or variable frequency AC voltage. The output of the sensing element is usually too small to operate an indicator or a recorder. Therefore, it is suitably processed and modified in the signal conditioning element so as to obtain the output in the desired form that is amplify the signal and filtering the unwanted signal. i. Describe the aliasing phenomenon. ii. Suggest a solution to minimize the effect of aliasing.