- it used to protect against high voltage surges. Your answer
Q: Q4: Water at the rate of 0.8 kg/s is heated from 35 to 40°C in a 2.5-cm-diameter tube whose surface…
A: Expression for heat transfer through a tube is given by, where A is the area of the tube Tw is the…
Q: 5. A coil having a resistance of 4 92 and an inductance of 1 H is connected in parallel with a…
A:
Q: 5:-Given a balanced Inductor and resistance, (Y), 30, has (L= 530 m H) (R= 2000), (VL= 400v), (F= 60…
A:
Q: write true or false in the following sentences :. 1-Two quadrant operation of de motor can be…
A: Chopper:- It is high speed semiconductor switch. Chopper converts constant DC voltage to variable…
Q: For a given transfer function H(z)= (z+1)/(Z-0.2) the impulse response h(n) is
A:
Q: I need to design a power supply 110v , with an output between 6 and 9v. I did a design and I…
A: According to the question, we need to design a power supply of 110 V, with an output between 6 V - 9…
Q: 9- To remove small protrusions and thin connection from the image as below, you can use : a- Opening…
A: According to the question, we need to discuss the technique to remove small protrusions and thin…
Q: 5. The amount of energy that can be stored in a single system per unit volume is a. Energy volume c.…
A: Note: As per the policy we can solve only question, please re-upload the remaining question as a…
Q: Question: State the principle of reactance tube modulator?
A: It is asked to state the principle of a reactance tube modulator.
Q: For the voltage divider circuit shown, find R2 in 0 when Vs = 6 V and Vd -3 8 V and R1=1,462.902? R1…
A: Given, Vs=6 VVd=3.8 VR1=1462.9 Ω
Q: Design a boost converter to provide an output voltage of 36V from a 24V source. The load is 50W.…
A: The input and the output voltage are known, and the output voltage is given by the expression as…
Q: ) For the circuit shown in figure beside, if V-480Cos400t Volt. Find the: 1. Average power delivered…
A:
Q: 6. Determine V, and Ip for the networks of Fig. 156.
A:
Q: I. Deduce the transfer function, T(s)-₁(s)/V(s) of the following network.
A: The required transfer function can be obtained by using the kirchhoff's current law that is mesh…
Q: Find il and i 2
A: The given circuit should be converted into frequency domain and then apply mesh analysis to find the…
Q: 7. The equivalent of two resistors R1 and R2 in parallel a. R1/R2 b. R1+R2 c. R1 R2/(R1+R2) d.…
A: Given, Two resistors R1 and R2 are connected in parallel.
Q: An ideal transformer is rated at 15 kVA, 60/240 V. What is the transformer ratio (a = ?) a. 4 b.…
A: Given: An ideal transformer is rated at 15 kVA. Ratio of primary voltage to secondary voltage,…
Q: Which instruction is used to transfer 16-bit data from 8086Mp to an I/O device that has port no.=…
A: Answer:- option 3) OUT AX,61H and remaining options are incorrect because of the following…
Q: In a delta modulation system, the voice signal is sampled at a rate of 32 K samples per second.…
A: Given a delta modulation system with, The voice sampled at a rate, fs=32 Ksamplessec=32×103…
Q: For the circuit shown in figure below, find the equivalent resistance and determine all resistort…
A:
Q: mean square (rms), and peak current ratings of the diode. Assume Ip = 500 A of a half sine-wave.…
A:
Q: = Given the open loop transfer function G(s) such that the output settling time T, = 2. R(s)+…
A:
Q: 1. For RC transient circuit, when capacitor voltage equal source voltage? a.93.6ms b. 63.9ms c.…
A:
Q: Digital mammography uses much lower X-ray energies than standard X-ray scans, and is used to obtain…
A: State True or False.. Digital mammography uses much lower X-ray energies then standard X -rays…
Q: Problem 1 The primary resistance of a 440/110-V transformer is 0.5 Q and the secondary resistance is…
A: In this question we will find secondary current for maximum efficiency and efficiency for given…
Q: When the switch is opened at t=0, obtain the 1K ohm resistor voltage for t> 0 in the circuit shown…
A:
Q: Develop the output equation for the modulation scheme for the 2nd discrete level, if the total…
A: According to the question, we need to develop the output equation for the modulation scheme for the…
Q: The order of operations when executing arithmetic operation is: Multiplication Division and mod -…
A: Answer: false
Q: The function of zener diode is to provide a constant output voltage to a load. this process is…
A: Zener diode is special purpose diode it can allow to flow current in reversed direction
Q: Chose the correct answer for the following equation: 16^(1/4)+3^3 - 10 + (3*9)/3^2 - 2^3 140 160 120…
A:
Q: 20. In an inductive series circuit, a voltage of 10V at 25 Hz produces 100 mA while the same voltage…
A: In this question, We need to determine the values of the resistance R and inductance L? We know…
Q: What is the output of following program: X=-3.5 Y= Sgn (-3.5) Print Y O-3.5 03.5 01 0-1
A: In the above given question they have mentioned a standard function which is known as signum…
Q: Solve for V2 if Ra = 24 ohms, Rb = 26 ohms and V = 24 volts. (Give the numeric value only, and use 2…
A: Given circuit, Where, Ra=24 ΩRb=26 ΩV=24 volts
Q: Given G(s) = R(S)+ G(s) Determine the steady state error es for ramp input, r(t) = 5t. Choice e=0:…
A: We need to find out steady state error for given system
Q: Practice Problem 7.1 892 www + 1292 692 V₂ VC Figure 7.7 For Practice Prob. 7.1. Refer to the…
A:
Q: What is the force (in Newtons) applied to a point charge of 2.4 mC placed at a uniform electric…
A: Given, Charge, q=2.4 mC Uniform electric field intensity, E=400 V/m
Q: Q6: A 750 KVA, 11 KV, 4-pole, 3-phases SG has Zs=1.4+j30 ohm per phase. Calculate the synchronizing…
A:
Q: use the superposition theorem to find the R3 R E₂ -lov current in R₂- E₁ 422 I 62 R₂ 352 M 432
A: Given circuit :
Q: 8- The inverter output is a distorted ac signal because of the voltage harmonics,the most difficult…
A: Solution of question (8): It is asked which harmonics are most difficult to filter. We need to…
Q: 7. The equipment in a power station costs Rs. 15,60,000 and has a salvage value of Rs. 60,000 at the…
A: Given: Initial cost of equipment, P = 15,60,000 Salvage value, S = 60,000 Useful life, n = 25 years
Q: Red = ? 6Ω Μ 1 Μ 7 19 6924 2Ω www 2 Μ Β ΙΩ 6Ω 35 Μ 2Ω 3 Μ 9 2Ω ΖΩ
A: Given circuit:
Q: With the help of a circuit diagram show that using germanium diode clipper, how we can achieve an ac…
A: The diode clipper circuit can be designed by using the diode and the bias voltage. The required…
Q: Q.5: Correct any five of the following sentences using suitable scientific phrases. 1. ww > AM 3. A…
A: In this question we will write circuit related questions.....
Q: problem: Find transadmittance of the circuit figure below. I. H(s) = 4₁=1 H 4₂2=1 H Es 000 -oooo LI.…
A: For the above given electrical circuit we need to calculate the value of trans admittance H(s).
Q: Relationship between Laplace transform and z-transform is Z= est O Z= e-STO Z= ensT
A: Answer: Option 1) Z = e^(sT) Because of the following explanation.
Q: This is an abbreviation for the remark statement that is used to explain a step by using a suitable…
A: True
Q: Find i (in Amperes) if V=43V. (Unit is not required. 2Ω {3Ω {6Ω (+1
A: Given circuit: Supply voltage, V = 43 V
Q: If transmission coefficient T= 0.7469 and Intrinsic impedance n₁=2.96, then n₂=? (n=3.14154 and take…
A:
Q: In the circuit shown in the figure below, C₁= 4.9μF, C₂ = 8.1μF, C3= 2.4μF, and a voltage Vab= 86V…
A: Given data, C1=4.9μFC2=8.1μFC3=2.4μFVab=86V
Q: One types of diodes are typically used for power supply applications which always called - Your…
A: In this question we will write about diodes used in power supply applications....
Step by step
Solved in 2 steps with 2 images
- Discuss the arcing phenomenon in a circuit breaker. Please write more answerA snubber circuit has snubber time constant (10 msec), voltage source (10 kV), discharge current of the Thyristor (5 µA) and frequency (50 Hz). Find the rate of voltage changing with time and snubber circuit power losses?PLEASE SHOW YOUR DETAILED SOLUTION. WILL GET A LIKE
- SUBJECT: INDUSTRIAL ELECTRONICS TOPIC: Power Supply Using LM 317 & LM337 NOTE: ANSWER THE FOLLOWING QUESTIONS AND EXPLAIN AND EXPOUND YOUR ANSWER! MAKE SURE THE ANSWER IS CORRECT TO RATE YOU HIGHLY FOR THE ANSWER. ANSWER THE TABLE AND OTHER QUESTIONS. THANK YOU! answer with correct, PLEASE FOLLOW INSTRUCTIONS ANSWER IT IN CORRECT & Explain THANKS Make a (3) titles about this project: A. B. C. Make abstract about this project: ABSTRACT - [ is a self-contained, short, and powerful statement that describes a larger work. Abstracts cannot contain equations, figures, or tables.] Make an introduction about this project that contains the (1) Background of the Project (2) Objective of the Project, (3) Scope and Limitation of the Project INTRODUCTIONState the main constituent elements of electrical cables, as well as the materials from which they may be made. Describe the following designations: H05VV-U 1G4 mm? and LSXAV 3x16 mm?.Do only a)... no detail is small every detial matters so go and be as detailed as possible
- could you solve this task using Delta to Wye Conversion and Wye to Delta Conversion.. i think the final answer would be ( 125 ohms )Electric Powers System for Nonelectrical Professional can you explain the purpose of capactictors, reactrs, and static VAR compensators used in electric power systemsShort circuit is occurred when: Select one: a. The voltage between the two terminals is zero although there may be a nonzero current between the terminals. b. All of the given answers. c. There will be a zero-resistance connection between terminal A and B and therefore the 2 terminals are at the same voltage. d. A pair of terminals connected by a wire (of zero resistance).