mogenous bar A having a mass of 18 kg is 2 m long and is inclined at 60 degrees with the horizontal plane. The mass M of 7 kg is connected by the rope to the bar. The rope leaving the bar is horizontal. The coefficient of friction between the rope and the drum B is 0.20. What is the minimum coefficient of friction between the bar and the plane for equilibrium? Give solution. (Ans. coefficient of friction = 0.284)

Q: Q.5/ The uniform crate shown has a mass of 20kg. if a force P = 80N is applied to the crate,…

A:

Q: Q5: The uniform box shown in next figure, has a mass of 30 Kg. If a force T = 70 N is applied to the…

A: Given Data The mass of the block is: m=30 kg The force applied on the block is: T=70 N The angle of…

Q: 20 cm Qs: The homogeneous Mock weights 250 N. Determine the value of P for which the block 30 m in…

A: Given Weigh of the block = 250 N Coefficient of friction = 0.3 Applied load = 10 N To find Magnitude…

Q: The center of gravity of the 50kg spool is at G. A cable would around the hub of the spool is…

A: Given data as per question Mass of spool =50 kg weight of block =30 kg coefficient of static…

Q: :A roll of paper has a uniform weight of 2kN and is suspended from the wire hanger so that it rests…

A: Given data as per question Weight of roller =2 KN Coefficient of static friction =0.3 Angle =300 FBD…

Q: |Can the system in Figure (4) be in static equilibrium in the position shown? The uniform bar AB…

A:

Q: In the figure shown, the homogenous block weighs 300lb and the coefficient of friction is 0.40. If h…

A:

Q: 20 cm Q5: The homogeneous block weights 250 N. Determine the value of P for which the block 30 cm in…

A: Given Weigh of the block = 250 N Coefficient of friction = 0.3 Applied load = 10 N To find Magnitude…

Q: Q3) The three flat blocks are positioned on the 30° incline as shown, and a force P parallel to the…

A:

Q: Q5: The uniform box shown in next figure, has a mass of 30 Kg. If a force T = 70 N is applied to the…

A:

Q: Q 20/The uniform slender bar of length l is placed in the opening of width d at the 30° angle shown.…

A:

Q: The thin rod has a weight W = 49.05 N applied at its center of gravity and rests against the rough…

A:

Q: Q4: The uniform box shown in next figure, has a mass of 40 Kg. If the two forces T = 60 N and F =30…

A:

Q: Q7). The uniform 10-kg ladder in Fig(Q7) rests against the smooth wall at B, and the end A rests on…

A:

Q: The uniform crate shown below has a mass of 20 kg. If a force P = 80 N is applied to the crate,…

A:

Q: Can the system in Figure .(4) be in static equilibrium in the position shown? The uniform bar AB (…

A: Consider the free body diagram of the rod.

Q: The uniform box shown in next figure, has a mass of 40 Kg. If the two forces T = 60 N and F=30 N are…

A: Given Data: Mass of the box, m=40 kg Coefficient of static friction, u=0.24

Q: Q3: The coefficient of static friction [10 M] 300 mm -700 mm between the drum and brake bar is Us =…

A:

Q: The uniform cylindrical drum weighs 250 lbs and is supported by a frictionless roller at A and the…

A: Given data as per question Drum weight =250 lbs Static coefficient of friction =0.3 kinetic…

Q: 20 cm Q5: The homogeneous block weights 250 N. Determine the value of P for which the block in…

A: Givenweight of the block w=250Nthe coefficient of friction μ=0.3

Q: Q5: The uniform box shown in next figure, has a mass of 30 Kg. If a force T 70 N is applied to the…

A: Given M=30 kg μ =0.24

Q: Calculate the minimum coefficient of static friction for each contact location to prevent the pole…

A: Free body diagram for the given figure; Given Data Mass of the pole, m=135 kg Length of the pole,…

Q: A pair of wedges is used to lift a crate as shown in The crate weighs 4000 lb, the wedge angle e is…

A: Given: The weight of the crate is W = 4000 lb. The wedge angle is θ = 18o. The applied load on…

Q: The tongs are used to lift the 150-kg crate, whose center of mass is at G. Determine the least…

A:

Q: The brake pads at C and D are pressed against the cylinder by the spring BF. The coefficient of…

A: Consider the free body diagram of the member AB.

Q: Q5: The uniform box shown in next figure, has a mass of 30 Kg. If a force T 70 N is applied to the…

A:

Q: The uniform box shown in next figure, has a mass of 40 Kg. If the two forces T = 60 N and F =30 N…

A:

Q: The block brake is used to stop the wheel from rotating when the wheel is subjected to a couple…

A:

Q: The homogenous 360 kg block rests against the vertical wall, for which the coefficiewnt of friction…

A:

Q: The uniform pole of length L and mass M is placed against the supporting shown in Fig.3. If the…

A: Given: The length of the pole is l. The mass of the rod is M. The coefficient of friction on both…

Q: 5. Calculate the magnitude of the horizontal force P, acting as shown, that will cause motion to…

A:

Q: The uniform box shown in next figure, has a mass of 30 Kg. If a force T 70 N is applied to the…

A: In the Given below picture, data regarding problem is mentioned  To check  Whether box remains in…

Q: The uniform crate shown in Fig. 8-7a has a mass of 20 kg. If a force P = 80 N is applied to the…

A:

Q: [3]. Two weightless slender rods are connected at Cby pin and attached to the blocks A and B of mass…

A:

Q: The uniform 10-kg ladder in Fig. 8-9a rests against the smooth wall at B, and the end A rests on the…

A: Draw the FBD for the given question and write the given values from the question.

Q: rope

A: using expression T2/T1 = e^μθ we have calculated  μ = 0.2159   free body diagram

Q: etion 6 The crate has a weight of 490 lb and a center of gravity at G rests on the floor for which…

A:

Q: The 50 N homogeneous bar AB is suspended from a rope that runs over a small peg at C. The bar is…

A:

Q: : The uniform box shown in next figure, has a mass of 30 Kg. If a force T 70 N is applied to the…

A: Given: The external force on the box is T=70 N. The mass of the box is M=30 kg. The inclination of…

Q: 30 kg 50 kg Hg = 0.30- P 40 kg Hg = 0.40- 30 Maximum Value of P in Hg = 0.45 Newtons The three flat…

A: To determine the maximum value which P may have before any slipping takes place.

Q: The uniform box shown in next figure, has a mass of 40 Kg. If the two forces T = 60 N and F =30 N…

A:

Q: The uniform crate shown in Fig. 8-7a has a mass of 20 kg. If a force P = 80 N is applied to the…

A:

Q: 6/71 The weight of the drum D and its cable is 10o lb, and the coefficient of friction u for the…

A:

Q: 20 cm Q5: The homogeneous block weights 250 N. Determine the value of P for which the block 30 сm in…

A:

Q: Q4: The uniform box shown in next figure, has a mass of 40 Kg. If the two forces T = 60 N and F =30…

A:

Q: If the beam AD is loaded as shown, determine the horizontal force P which must be applied to the…

A: Given data as per question The coefficients of static friction at the wedge's top=0.30 The…

Q: Determine the smallest coefficient of static friction at both A and B needed to hold the uniform…

A: for the given arrangement  coefficient of friction at A and B be μ weight of the rod (m) = 100 lb…

Q: 4) Beam AB is subjected to a uniform load of 100 N/m and is supported at B by a post BC shown below.…

A: Given: The uniform load of the beam AB is, w=100 N/m Length of the beam AB is, L=6 m Length of the…

Q: (deg)- 28.707 Ina road construction along the Caite expressway, a wedge of weight (Wi -552 Nj is…

A: Given Data The weight of the wedge is: w1=552 N The weight of the culvert pipe is: w2=1268 N The…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.