Part 2 - Solving: Observers stationed at two sections A-A and B-B, 200 m apart on a highway,record the arrival times of four vehicles as shown in the table.%3VehicleSection A-ASection B-BTo + 7.6 secTo + 10.4 secTo + 15.1 sec ITo + 23.4 secIf the total time of observation at A-A was 20 seconds, determine: (a) the time mean speed inATo + 4.2 secTo + 8.7 secTo + 13.7 seCBCKPH, (b) the space mean speed in KPH, (c) the flow at section A-A in veh/hr, (d) time headway inseconds, and (c) traffic density in veh/km. 5 points each.

The given table showen below, Vechile Section A-A Section B-B A To To+7.6 sec B To +4.25 To +…

Part 2 - Solving: Observers stationed at two sections A-A and B-B, 200 m apart on a highway, record the arrival times of four vehicles as shown in the table. Vehicle Section A-A Section B-B To + 7.6 sec To + 10.4 seC A To To+ 4,2 sec To + 8.7 sec To + 13.7 seC If the total time of observation at A-A was 20 seconds, determine: (a) the time mean speed in KPH, (b) the space mean speed in KPH, (c) the flow at section A-A in veh/hr, (d) time headway in To + 15.1 sec I To + 23.4 seC C seconds and (c) traffic density in veh/km 5 points each

Part 2 - Solving: Observers stationed at two sections A-A and B-B, 200 m apart on a highway, record the arrival times of four vehicles as shown in the table. Vehicle Section A-A Section B-B To + 7.6 sec To + 10.4 seC A To To+ 4,2 sec To + 8.7 sec To + 13.7 seC If the total time of observation at A-A was 20 seconds, determine: (a) the time mean speed in KPH, (b) the space mean speed in KPH, (c) the flow at section A-A in veh/hr, (d) time headway in To + 15.1 sec I To + 23.4 seC C seconds and (c) traffic density in veh/km 5 points each

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter9: Capacity And Level Of Service For Highway Segments

Section: Chapter Questions

Problem 17P

See similar textbooks

Similar questions

3. A bus route having seven schedule stops has the following number of passengers alighting and boarding the bus: Stop Alighting Boarding 1 0 20 2 3 5 3 5 7 4 6 3 Rectangular Snip 5 8 4 6 7 2 7 12 0 Passengers board and alight through the front door. Alighting time/passenger = 1.8 sec and boarding time/passenger = 3 sec. Compute the dwell time at each stop and the total dwell time. (Assume the clearance time = 5 sec).
count period. n, 5, A 24-hour count using a road tube at a rural highway location produces a count of I1,250 actuations. A repre- sentative sample count to classify vehicles resulted in the data shown here: en Data for Problem 2 Number of Axles Per Vehicle Number Observed 157 55 50 33 8. ---«n 1EK 8 TRAFFIC DATA C Based on this sample classification count, how many vehicles were observed during the 24-hour study? 2344 6
plz, solve this problem, it is not graded question. Transportation Engineering-1 During a 70 sec period, a detector is occupied by vehicles for the following times: 0.31, 0.39, 0.41, 0.35, and 0.53 sec. Estimate the values of flow (q), density (k) and speed (v). Assume that the loop detector is 10 ft and that that the average length of the vehicle is 20 ft.
Q3: Given the ordinate of 2 hr. UH. Drive the ordinate of 8-hr. U.H? T(hr.) 2-h UH 300 720 800 540 10 300 12 170 14 100 16 50 18 10 20 22
The table shows the details for a license plate car parking survey. The average bay turnover is approximately ……………….. . a. 2.8 b. 2.3 c. 3.8 d. 4.3
Bias (a) (b) (c) FIGURE 1.20 Exactness of measurements: (a) precise but not accurate, (b) accurate but not precise, and (c) precise and accurate. (Federal Highway Administration)
5. In the volume study of KAAF University street, the following data was collected. Because of a shortage in manpower, data was collected for 12 minute periods in each 30 minutes as shown in the table below. Time No. of vehicles 3:30 - 3:42 3:45 - 3:57 100 4:00 - 4:12 106 4:15 - 4:27 4:30 - 4:42 115 4:45 - 4:57 5:00 - 5:12 120 5:15 - 5:27 5:30 - 5:42 142 5:45 - 5:57 6:00 - 6:12 135 6:15 - 6:27 |6:30 - 6:42 120 6:45 - 6:57 7:00 - 7:12 105 (a) Complete the table of the data collection (b) Find the peak hour (c) Determine the peak hour volume (d) Calculate the peak hour factor (PHF)
4-5 An engineer wishing to determine whether there is a statistically significant difference between the average speed of passenger cars and that of large trucks on a section of highway, collected the data shown below. Determine whether the engineer can con- clude that the average speed of large trucks is the same as that for passenger cars. Average Speed (mi/h) Standard deviation of speed ± mi/h Sample size Trucks 62 5.5 275 Passenger Cars 59 6.3 175
a) In on-site time study of mechanically loaded, stationary-container system (SCS), the time it takes to empty all locations in a collection route is 240 minutes. The average driving time between containers location is 0.92 hours. If there are 8 containers, calculate: i. Time to pick up and load,p ii. The average between collection-point driving time per collection point,d₁
When taping using a 5-m steel tape, Barry Allen measured that the length of a road is 70.12m. He then verified it using a 10-m tape and got a reading of 70.06m for the same road. Determine the following:1. The relative precision of Barry Allen's taping activity2. If Barry Allen has a pace factor of 0.82m, what would be the most probable number of pace Barry Allen would have with the same road.
Using Enumeration Method - list all paths and total duration. Activity Predecessor Normal time Normal cost Crash time Crash cost Max Crash Time Slope A - 12 $200 9 $350 B A 8 $300 8 $300 C A 9 $250 7 $450 D B 6 $400 5 $600 E B,C 5 $150 4 $225 F C 10 $500 9 $650 G D,E,F 8 $400 6 $900
2. Figure shows the captured aerial photography showing the locations and speeds of 4 vehicles travelling between section x & y. An observer located at X observes the four(4) vehicles passing pt X during a period of 15 sec. Calculate the following: a) Space Mean Speed b) Time Mean Speed c) Average Spacing d) Headway 60 kph 40 kph 45 kph 55 kph Direction D B A of flow 300m