please write details about Display LCD 16x2

Q: Describe the three modes of operation of an IC PPL. Explain how PLL can be used for FM demodulation.

A: The three modes of operation of an IC Phase locked loop (PLL) are, i) free running ii) Capture iii)…

Q: PL 102 Gate Control

A:

Q: | What is the advantage of atomic force microscope (AFM) compared to scanning tunneling microscope…

A: a. The advantages of the atomic force microscope(AFM) as compared to the scanning tunneling…

Q: dentify the addressing mode for each of the following 8085 instructions:

A: 1. MOV M,C : Register Indirect addressing mode It moves the content register into the memory…

Q: 5 What is the conversion time for a 12-bit ADC with a clock frequency of 1 MHz?

A: The solution can be achieved as follows.

Q: Q1/Binary to octal conversion (2D9)16 =( )2

A: To convert Base A to Base B, First convert it to the corresponding Decimal value by multiplication…

Q: Discuss the pin diagram of any logic gate? Explain how the NAND gate can be used to derive the other…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: Determine the signal to quantization noise ratio for a 6 bit PCM.

A: Quantization Noise: The sampled signal with quantization error is the decoder output in a PCM…

Q: 102 PL Gate Control

A:

Q: Use the following figure to answer the following question: In this circuit (inverter), the…

A: When the firing angle of the rectifier is less than 30o, the expression for the output voltage for…

Q: Determine the control word for the following configuration of the ports of Intel 8255 for Mode 1…

A: Control word: The figure below illustrates the control word format of 8255:

Q: Q3: In the adjacent figure, what is the DC load voltage and what is the DC load current? How much…

A: Given, R=1.5ΩTransformer ratio=12:1

Q: Draw I-V characterisitic curves of a typical nMOSFET clearly showing the aforement

A: INTRODUCTION MOSFET(metal oxide semiconductor field effect transistor) is also known as insulated…

Q: Using Flash ADC method to convert the analoge voltage signal to digital (3-bit) ,where Vi=5V and…

A:

Q: need to do introduction for this title below: Title: DEVELOPMENT OF WIRELESS FAST CHARGING CHARGER…

A: Title: DEVELOPMENT OF WIRELESS FAST CHARGING CHARGER FOR CELL PHONE BY USING RECTIFIER

Q: A 5-bit flash converter has a reference voltage of 16 V. What is the center code voltage for a…

A: The solution is given below

Q: Q1. Chows the correct answer. 1. Maximum operating frequency of PIC microcontroller is 8 MHZ 12 MHZ…

A: 1)20Mhz  2)EEPROM 3)20Mhz 4)40

Q: For an efficient communication in PCM system, the number of samples per second must be at most be…

A: Pulse Code Modulation (PCM) is a system used to represent sampled analog signals in digital form

Q: Q1. Chows the correct answer. 1. Maximum operating frequency of PIC microcontroller is 8 MHZ • 12…

A: PIC 16F877A microcontroller is based on flash memory technology and it can be written and erase…

Q: 1-An ADC with word length of 24 bits. If the input analogue signal range is 3.7 V, what is the…

A:

Q: Discuss the features C8051F8xx series microcontroller. Draw the block diagram of the same and…

A: Microcontroller: The microcontroller is a compact IC (integrated circuit) that is designed to…

Q: Draw 8259A interfacing connections with 8086 at the address 0744H.

A: The 8259A interfacing connection with 8086 at address 0744h is shown below:

Q: Explain ARM Cortex M4 controller (STM32F407) and compare ARM Cortex processors, e.g. M0,M1,M2,M3,M4…

A: ARM Cortex M4 controller (STM32F407) can be defined based on certain characteristics, these are…

Q: Describe TWO (2) advantages of DIGITAL over to ANALOG in data storage field.

A:

Q: 1. Silicon dioxide can sustain 10 MV/cm electric field. Calculate oxide thickness range for CMOS ICs…

A:

Q: The Type K thermocouple has a sensitivity of about 41 ????/℃, i.e. for each degree difference in the…

A: The solution can be achieved as follows.

Q: For a PCM system with the following parameters: Maximum analog input frequency = 4 kHz Maximum…

A: Given data, Maximum analog input frequency fmax=4 kHz Maximum decoded voltage Vmax=±2.55 V Minimum…

Q: Which of the following is responsible for transforming an electrical signal to a physical output in…

A: The thing which is responsible for transforming an electrical signal to a physical output in the…

Q: Draw a 3-bit flash converter with Vref= 12 ?. a.Determine the full-scale range. b.Determine the…

A: The solution can be achieved as follows.

Q: For the given Vin (input voltage), calculate Dout (digital output) in decimal and binary, given the…

A:

Q: What are the advantages of using a digital system over an analog one

A: Disadvantages of Analog System- More effect on system by unwanted signal (noise) as it works on…

Q: Consider a 12 -bit ADC and full scale voltage measurement range of – 12V to + 12V. Find the…

A:

Q: 1. What is Diode?

A: NOTE: “Since you have asked multiple question, we will solve the first question for you. If you want…

Q: Enlist the main features of 8051 microcontroller. Also explain the general block diagram of…

A: Enlist the main features of 8051 microcontroller. Also explain the general block diagram of…

Q: Q:what is the addressing mode for the following instruction: MOV .(C910), A direct mode Relative…

A:

Q: An ideal ADC has a resolution of 6 bits and a conversion voltage range between -2 V and 4 V. What is…

A: Given:- No. of bits, N = 6     Voltage Range = -2V to 4V

Q: Determine the CMY equivalent of the 2048th RGB colour.

A:

Q: A device that increases input AC power. O a. Inverter O b. Amplifier Oc. Attenuator O d. Rectifier

A:

Q: Draw and explain PMMC Instrument .

A:

Q: How can I implement 4035 ic as a parallel input and serial output?

A: For implementation of 4035 IC as a parallel inputs we have to use pin number 9, 10, 11, 12 or Pin…

Q: 1. What is the threshold voltage, VTH and minimum current that will turn ON the LEDS? CC LAB MANLIAI…

A: From the above data, we can observe that before voltage 2.1 V and current 5.79mA , device was turn…

Q: Assume that you have an 8-bit ADC with Vref = 5 Volts. If the input voltage is 3.5 Volts, what is…

A:

Q: Draw the V-I characteristics of SCR,MOSFET,IGBT

A:

Q: 8-The waveform of output voltage of half-controlled three phase bridge rectifier in each cycle…

A: Rectifiers are used to convert the AC signal to DC signal.it can be controlled as well as…

Q: Q/For a Binery Erasure Channel ( BEC ), the input probability for 0/35 and Pe of the channel is 0.15…

A:

Q: Draw the basic block diagram of FIFO.

A: ROM stand for Read only memory. It is non volatile memory . ROM has read operation only no write…

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.