Problem 2: Given that the voltage standing-wave ratio S = 3 on a 50 O line, that the first voltage minimum occurs at 5 cm from the load, and that the distance between successive minima is 25 cm, find the load impedance and T.

Problem 2: Given that the voltage standing-wave ratio S = 3 on a 50 O line, that the first voltage minimum occurs at 5 cm from the load, and that the distance between successive minima is 25 cm, find the load impedance and T.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.61P

See similar textbooks

Related questions

Q: A 140 Q lossless line is terminated in a load impedance ZL = (280 + j182) Q. If 2 = 72 cm, find a.…

A: Given: Characteristics impedance, Z0=140 Ω Load impedance, ZL=280+j182 Ω Wavelength, λ=72 cm

Q: The voltage waveform on a lossless TL in air is given by: V(z)=150e 8z + -20e*Bz (V). The TL has a…

A: Given: Voltage, Vz=150e-jβz+-20ejβz V Characteristic impedance, Z0=100 Ω Length, L=0.5 λ

Q: A transmission line with 0.4? line length and 50 Ω characteristic impedance is terminated with load…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: A lossless transmission line of impedance Z : 100 + j75. If X=20 cm, find: 502 is terminated with a…

Q: 02: A lossless transmission line of electric length 1= 0.35 A is terminated in a load impedance as…

A: Given that: i=0.35π , Zin = 60+30n Find Bl =2ππ× 0.35π…

Q: Q2) For the lossless T.L shown below, the line is driven with a generator that has E=30Vrms and…

A: As given in the circuit diagram , Zg = 25ΩEg = 30 Vrms Zf = 40 - j 60Ωλ = 2.5 m Zf…

Q: A transmission line has a characteristic impedance of 100 ohm and a resistance of 0.2 ohm/m. If the…

A: A transmission line can be characterized by 4 parameters:1. Resistance per unit length (R)2.…

Q: Problem 2. Calculate the capacitance-to-neutral in F/m and the admittance-to-neutral in S/km for the…

A: When three-phase overhead lines are running, due to high voltage difference it forms a capacitance.…

Q: While studying the performance of medium transmission linos, only resistance and of the line are…

A: Given About the performance of the medium transmission line

Q: A lossless TL with if the voltage a cross a load connected to lossless TL is 20 Vms and reflection…

A: Since your question has multiple sub parts and you have not mentioned any part , we will answer only…

Q: A lossless transmission line is terminated with a 100 Ohms load (RL=100 Ohms). If the standing wave…

Q: A lossless TL with if the voltage a cross a load connected to lossless TL is 20 Vyrms and reflection…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: A transmission line of characteristic impedance 40 ohms and length 6.2λ is terminated by an unknown…

A: Given: Z0=40 ΩΓin=0.45+j0.55 ΩL=6.2λZL=?

Q: calculate the Rn, In or Isc, and current at Zc using Norton's Theorem

A: The given circuit is as shown below,

Q: The 0.1A length line has a characteristic impedance of 502 and is terminated with a load impedance…

A: Given data: load impedence ZL=5+j25 ohm. characteristic impedence Z= 50 ohm With the help of smith…

Q: Phase velocity of voltage wave in a distortion less line having characteristic impedance 0.2 kΩ,…

Q: A lossless transmission line with characteristic impedance 300 Q, length 0.8 2. a purely capacitive…

A: Zc=300ohml=0.8λXc=-j300ohmR1=300ohmR2=300ohmβl=2πλ0.8λ =5.026

Q: If Zo = 50 2, Vo* = 10 V, and the length of the line is 1.252, estimate the reflection coefficient…

A: given Z0= 50 ohm V+0= 10v Length of line = 1.25 Reflection coefficient at the load Cv = v/v =…

Q: Q) A 50 Q lossless transmission line is terminated by a load of impedance Z1. The VSWR on the line…

A: Since minima is forming at the load hence reflection coefficient must be negative.

Q: A transmission line has characteristic impedance of 75 Ω and it is connected to receiver with…

A: According to the question we have to find the value of i. Reflection Coefficient; ii. VSWR

Q: The parallel branches of a 2 – wire transmission line are terminated in 100 Q and 200 Q resistors as…

A: Fig: 2-wire transmission line Although for λ4 input impedance is given by Zin=z02zL

Q: Terminated transmission line. A 502, 10.5-m long air transmission line terminated with a load…

Q: Compute the following parameters inductance, Capacitance, resistance, and conductance, if you have…

Q: 2. The phasor voltage on a terminated transmission line is given by 1 -e-j2nz + +j2nz What is the…

Q: 2-2m. If Vs = 100 volts, find: (use crack diagram) A lossless transmission line having Z-5002,…

A: Given: Z0=50 ΩVS=100 VKr=0.4<45λ=2 Find: 1. Standing wave ratio 2.Voltage standing pattern

Q: If characteristic impedance Z,= 50-j302, propagation constanty= 0.6+ j3.5/m, and the length = 1 m.…

A: Given data, characteristic impedance = 50-j30 ohm propagation constant = 0.6+ j3.5/m length = 1 m Vg…

Q: We have a load with a return loss of 22dB, calculate the reflection coefficient I and the voltage…

Q: A lossless 51-N transmission line is terminated in a load with Z = (42 + j29) N. Use the Smith chart…

A: Given Zo = 51 ohm ZL= 42+j29 ohm

Q: Transmission line of Zo = 75 Q and electrical length (= 0.333A is terminated with a Z = 30-j40 N.…

A: (i) The reflection coefficient at the load is given by the expression as shown below: τ0=ZL-Z0ZL+Z0…

Q: Determine the primary constants, R, L, G, and C for a distortion-less line working at 300MHz. Given…

A: Given,Frequency, f=300 MHzCharacteristic impedance, Zo=75 ΩAttenuation constant, α=0.12 Np/mWave…

Q: A rectangular surge of 500 kV 3µs travels along the terminated line by an inductance of 2mH. If the…

A: Given Rectangular voltage magnitude vm=500 kvTime duration t=3 μsSurge impedance Z0=600…

Q: In the lossless transmission line system shown, the switch S is closed at t = 0. a. Find the…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: A lossless transmission line of length 50 cm with L = oper ated at 30 MHz. Find phase constant 10…

A: Given: In the given question they have mentioned a lossless transmission line. Lossless…

Q: line is terminated in -10 volts, use Smith A lossless T.L of 10.25m long with Z-50 2. The…

Q: A lossless transmission with characteristic impedance of Z0 = 1002 and length = 52cm The line was…

Q: The 50 ohm transmission line isterminated with an unknown load. The magnitude of the reflection…

A: Transmission line

Q: Q4: At an operating frequency of 300 MHz, a lossless 50-W air- spaced transmission line 2.5 m in…

Q: Q3 The characteristic resistance of a loss-less transmission line is given by (a) 1/√LC (B)…

A: Q3 The characteristic resistance of a loss-less transmission line is given by (a) 1/√LC (B) √LC…

Q: If the line impedance Z,-502 and the load impedance Z= 115 2, calculate the voltage standing wave…

A: Load impedance Zl = 115 ohm Line impedance Zo = 50 ohm Now we need to calculate the given…

Q: A 219-2 lossless air transmission line is connected to a complex load composed of a 579-Nresistor in…

Q: A distortionless line has Zo- 60 0 a- 20 Np'm, -0.6c, where c is the speed of light in a vacuum. The…

A: Given parameters are:

Q: Q5) (A) If the length of the transmission line is one-quarter wavelength (1=2/4). Derive an…

A: Given We need to derive input impedance of quarter wavelength transmission line. Please find the…

Q: A transmission line of characteristic impedance of Zo=50 ohm with length of A/4 loaded by a load…

A: Given: A transmission line is having Characteristic equation, Z0=50 Ω Length, L=λ4 Load impedance,…

Q: A lossless transmission line (TL) has a characteristic impedance of Zo= 250 N, a load impedance of…

A: According to guidelines, we need to solve only the first three subparts. Given Zo = 250 ohm , ZR=…

Q: Q) For the lossless T.L shown below, the line is driven with a generator that has E-30 V, and…

A: All vaalues are determined using Smith Chart 1) Standing Wave Ratio = 2.1 2)Impedance at sending…

Q: A lossless transmission line (TL) has a characteristic impedance of Zo= 250 N, a load impedance of…

A: Note: As per our calculations, I have solved the first three subparts. Given data: Zo=250…

Q: A lossless TL with if the voltage a cross a load connected to lossless TL is 20 Vyms and reflection…

A: This question has multiple sub- parts,we will solve the first 2 sub-parts. If you want the solution…

Question

Problem 2:
Given that the voltage standing-wave ratio S = 3 on a 50 O line, that the first voltage minimum
occurs at 5 cm from the load, and that the distance between successive minima is 25 cm, find the
load impedance and T.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What impedance vector - j25 represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a resistance.
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
Ro. 8. For unit- slep responses A,4 find the homafor the system. chowa ahe figure , 20 see tlJae) fimetion of
Two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in parallel, and the combination is supplied from a sinusoidal voltage source. The power factor of the combination is ?
Reduce to its simplest form using msop
A) find Ztot in rectangular form B) find Ztot in polar form C) find V1 or VL in polar for. ( use voltage divider rule or ohm law).
A capacitor C is connected in series with a 400 resistor across a supply of frequency 60 Hz. A current of 3 A flows and the circuit impedance is 500. Calculate: (a) the value of capacitance, C, (b) the supply voltage, (c) the phase angle between the supply voltage and current, (d) the p.d. across the resistor, and (e) the p.d. across the capacitor. Draw the Phasor diagram.
Consider the following circuit used to provide power for an induative RL load. The input voltage is V-100V and the load has a 50 impedance value. The thyristor is working at a frequency fs = 2 kHz. The discharge current is to be limited to 40A and the required dv/dt is 40V/us. If the value of Ce is equal to 0.14uF, then the snubber losses are equal to: R. V. Select one: O a 5.4W O b. 7.4W 1.4W Od. 3.4W
Urgent. In the circuit shown in the figure, the RL load is connected to a 20V source when switch K is in position 1; Explain the effect of inductance in the circuit.
The dioces are ideal. write the Fransfer Characteidie equati ons ( &, as a funchiar g &) Plot &o agaiwet &, imdicaling all intrcepts, slopes and Volt ope lerels. Sketch bo f bq =40 sin wt. Indicate al voltage lezels - %3D 1OK lok lov
A DC-DC Chopper Circuit with an RL Load has an output current waveform shown below with a duty cycle of 50% and 1ms period. If it has a resistance of 1ohm and an inductance of 10mH, find the source voltage. 5A 2A ton toff output _current
Ac - 100 VrmsR1 - 1kR2 - 500Rload - 1kCapacitor - 2uF Q1. How much is the capacitor voltage lagging from the AC source