Problem 8( Nitrogen gas at constant pipeline conditions of 200 kPa and 300 K passes slowly through a valve into a well-insulated, frictionless, and initially evacuated piston-cylinder assembly. A pressure of 150 kPa in the cylinder is needed to support the piston due to its own weight and the ambient atmosphere. The volume under the piston is 1 m³ at the end of the process. Find (a) the boundary work done during this process, (b) the final temperature of the nitrogen in the cylinder, and (c) the mass that enters the cylinder during the process. m.h

Problem 8( Nitrogen gas at constant pipeline conditions of 200 kPa and 300 K passes slowly through a valve into a well-insulated, frictionless, and initially evacuated piston-cylinder assembly. A pressure of 150 kPa in the cylinder is needed to support the piston due to its own weight and the ambient atmosphere. The volume under the piston is 1 m³ at the end of the process. Find (a) the boundary work done during this process, (b) the final temperature of the nitrogen in the cylinder, and (c) the mass that enters the cylinder during the process. m.h

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q/ A dry gas reservoir is initially at an average pressure of 5500 psia and temperature of 145F. The gas has a gravity 0.67. What will the average reservoir pressure be when 40% of the original gas(in Scf) has been remained in the reservoir. Assume the volume occupied by the gas in the reservoir remains constant. If the reservoir originally contained 1MM cuft of reservoir gas, how much gas has been produced at a final reservoir pressure of 600 psia.
The compressor tank that holds 80L of air during compression of pressure of 250kpa and the temperature of 30 degrees. The leakage was experienced during the compression process which resulted in a los of 5g of air, therefore the current air in a tank fill 40L at 500kpa. Determine the temperature of the current air in a tank
Q1/ A boiler working at a pressure of 1.4 MPa evaporates 8 kg of water per kg of coal from feed water entering at 40C. The steam at the stop value is 0.95 quality. Determine the equivalent evaporation from and at 100C.
the question below is already answered in the photos that I provided I only want to ask how did it find the answersSaturated steam at a pressure of 25 psia is sprayed into a stream of moist air. The initial condition of the air is 55 dry-bulb temperature and 35 F de-point temperature. The mass rate of air flow is 2000 lb per min. Barometric pressure is 14.696 psia. Determine how much steam must be added in lb per min to produce a saturated air condition, b) the resulting temperature of the saturated air.my question here is:regarding of the solution pls elaborate how did it get w1 and h1 is it given in the psychrometric chart or it has a specific solution to follow
Use steam table, Saturated steam has a pressure of 2.546 Mpa. What are the temperature, specificinternal energy, specific volume, and specific entropy? Is the condition of the steamis wet, dry or superheated? Why?
A large mining company was provided with a 3 m3 of compressed air tank. Air pressure in the tank drops from 700 kpa to 180 kpa while the temperature remains constant at 28°C. What percentage has the mass of air in the tank been reduced? (neat hand written)
In a heat engine, water vapor flows into a turbine and then it enters a condenser for rejecting thermal energy. The system requires maintaining the gauge pressure of the steam at 1400 kPa at the turbine inlet and at a vacuum of 71 cmHg in the condenser. Having that the barometric pressure is measured as 77.2 cmHg, calculate the absolute pressures (in kPa) of the steam at the turbine inlet and in the condenser. (Density of mercury is 13600 kg/m3)
Billy flew from New York to Cincinnati and had a closed container with a closed outlet to drink from. The container has a diameter of (D. = 5 cm) and height of (H. = 27 cm). The container is filled with 72% of water. The container's outlet has a diameter of (D. = 1 cm) and height of (H, = 30 cm). Last moment container was opened was in New York at an atmospheric pressure of 1072 hPA. When Billy landed in Cincinnati the atmospheric pressure was 850. When Billy opened the bottle once again water discharged because of difference in pressure. 1. Calculate instantaneous flow rate at the point when the closed containers outlet was opened. Assume pressure in the closed container is the difference between cities = 222 hPa and air pressure in Cincinnati 0. Figure 1: Do = Icm Ho = 30 cm %3D 27 = H. Cm Hw Dc =5 Cm
If air is heated at constant pressure from 1.7 m3, 27 °C and 97 kPa to 417 °C. It is then cooled at constant volume back to its initial temperature Which is figure depicts the processes? Conipr- A Vg=Uz B. N2
Find an expression for the mass flux in the venturi tube (shown below) as a function of the pressure change.
There is 3.5 L saturated liquid water at 175 kPa pressure in the frictionless moving piston-cylinder system shown in the figure. The heat given to the system is 500 kJ and the electrical work is 1320 kJ. Since half of the water evaporates at constant pressure; a) Write the energy balance equation (First Law), b) Calculate the mass (kg) of water, c) Calculate the required shaft work (kW), d) Show the process in T-v and P-v diagrams, including saturated liquid and saturated vapor curves
Problem 1 R22 saturated at 32°C is throttled to a pressure corresponding to a saturation temperature of 2°C. Determine the extent of flashing of the liquid into vapour.