Q 5) A turbine, operating under steady-flow conditions, receives (4500 kg) of steam per hour. The steam enters the turbine at a velocity of (2800 m'min), an elevation of (5.5 m) and a specific enthalpy of (2800 kJ/kg). It leaves the turbine at a velocity of (5600 m/min), an elevation of (1.5 m) and a specific enthalpy of (2300 kJkg). Heat losses from the turbine to the surroundings amout to (16000 kJ/h). Determine the power output of the turbine

Q 5) A turbine, operating under steady-flow conditions, receives (4500 kg) of steam per hour. The steam enters the turbine at a velocity of (2800 m'min), an elevation of (5.5 m) and a specific enthalpy of (2800 kJ/kg). It leaves the turbine at a velocity of (5600 m/min), an elevation of (1.5 m) and a specific enthalpy of (2300 kJkg). Heat losses from the turbine to the surroundings amout to (16000 kJ/h). Determine the power output of the turbine

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 10RQ: The seasonal energy efficiency ratio (SEER) includes the energy used in the _____and _____cycles.

See similar textbooks

Similar questions

4) A boiler generates 600 kg of steam per hour. The enthalpy of feed water s 168 kj/kg and the enthalpy of steam is 2772 kj/kg. Neglecting PE KE cal the rate at which the heat is transferred.
28. A centrifugal air compressor compresses 200 cfm from 12 psia to 90 psia. The initial specifie volume is 12.6 and final specific volume is 3.25 If the inlet suction lirfe is 4" I.D. and the discharge line is 2.5" I.D. Determine ft-lb (a.) The change in flow energy between the boundaries in- min Ib (b.) the mass flow rate in and min (c.) the change in velocity in fps.
28. A centrifugal air compressor compresses 200 cfm from 12 psia to 90 psia. The initial specific volume is 126 and final specific volume is 3.25 If the inlet suction lirte is 4" LD. and the discharge line is 2.5 LD. Determine [a) The change in flow energy hetween the boundaries in (b.) the mass flow rate in- and (c) the change in velocity in Ips
Pls. Answer thank you! A cooling tower has an efficiency of 65%. Water enters the tower at 55°C. The wet bulb temperature of surrounding air is 27°C. What is the temperature of water leaving the tower?
Pls. answer thank you! A steam turbine of 6 MW capacity has a Willan's line equation of ms = 5.52 + 3.200 kg/hr. Determine the steam consumption at 63% load, kg/hr.
Pls answer thank you! Steam enters the turbine at the rate of 2.5 kg/s with enthalpy of 3200 kj/kg and exhaust enthalpy of 1100 kj/kg . Steam is extracted from the turbine at the rate of 1 kg/s for heating purposes with enthalpy of 2750 kj/kg. What is the turbine work in KW.
8. A turbine passes 67.5 kg/h of steam at 200 km/h at 8 MPa and leaves at 0.5 MPa as wet steam with a speed of 90 km/h and a specific volume of 0.189 m3/kg. d. What must be the steam input conditions (T,H) to turn on a device that consumes 30 kW? and. What is the mass and volumetric flow rate of the water at the outlet? F. What is the input and output area?
A steady stream of steam passes through an adiabatic turbine. It enters at 10 MPa, 450 °C and 80 m/s and at the exit it is 500 KPa, 40% quality and 30 m/s. The mass flow of the steam is 12 kg/s. a) With the power that comes out of the system, 252 100 W bulbs can be lit. Calculate the efficiency of the system. b) What is the area of the duct at the entrance? c) What is the volumetric flow at the outlet? d) What is the temperature of the steam at the outlet?
f. A water-jacketed compressor receives 140 L/s air at 100 kPa and 21 deg C and discharges the air at 140 deg C. Cooling water entering at 16 deg C and leaving at 21 deg C is circulated at the rate of 0.18 L/s. Determine the power required for the driving motor for this compressor, assuming the friction losses with rotating parts account to 5% of the total power required. a. 10 kW b. 15 kW c. 20 kW d. 25 kW
3. A water-tube boiler having a heating surface of 325.23 m² evaporates 6349.21 kg of water in an hour from a feed temperature of 66 °C. Boiler pressure is at 1.04 MPaa and the steam quality at the boiler outlet is 99 %. What percent of its rated Bo. Hp was the boiler developing?
High pressure steam З МРа 1 Power Out Turbine Medium/low pressure steam To process 100 КРа 200°C 500 КРа 2 Condenser 3 Figure Q3. Table Q3. Mass flowrate of steam Last ID. Number Mass flowrate of steam (kg/s) 0,1 5 2, 3 4, 5 7 6, 7 8. 8, 9 9.
Define and derive an expression for stage efficiency in case of a steam turbine.