Q2/30 kg/s steam at 3 MPa, 300 °C expand isentropically in a turbine to a pressure of 100 kPa. If the heat transfer from the casing to surrounding air represent 1 percent of overall change of enthalpy of the steam. Calculate the power output of the turbine. Assume exist is 2 meter above the entry and the initial velocity of steam at inlet is 10m/s and exist velocity is 1 m/s.

Q2/30 kg/s steam at 3 MPa, 300 °C expand isentropically in a turbine to a pressure of 100 kPa. If the heat transfer from the casing to surrounding air represent 1 percent of overall change of enthalpy of the steam. Calculate the power output of the turbine. Assume exist is 2 meter above the entry and the initial velocity of steam at inlet is 10m/s and exist velocity is 1 m/s.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The water in the vessel consisting of liquid and vapor in equilibrium at 8.1111 Mpa. Ithas found out that the specific internal energy is 2138.2111 kJ/kg. What are thetemperature, specific enthalpy, specific volume, and specific entropy? Is thecondition of the steam is wet, dry or superheated? Why?
An adiabatic turbine with a continuous flow of water vapor has a pressure of 10 MPa andIt enters at a temperature of 500 ° C, 10 kPa pressure and 90 percent drynessIt comes out with the degree. Kinetic and potential energy changesthe mass required for the turbine to produce 5 MW of powerCalculate the flow rate.
3. A diesel engine powers a boat. The engine's cylinders each have a cut-off ratio (V3/V2) of 2 and the V3 is 4ft3. If 1 cylinder is in the isobaric expansion stroke, find the final temperature if the initial temperature is 540F
Ex1/ air has pressure 100 kN/m and temperature 20°C this air is compressed by adiabatic process at rate 10 kg/s if he pressure ratio is ). If the isentropic efficiency is 0.85 calculate the final temperature and pressure and power consumed by compressor. Sol/
o At the inlet to a certain nozzle, the enthalpy of the gas is 3000 kJ/kg and velocity is negligible. At the discharge end of the nozzle, the enthalpy is 2762 kJ/kg. The nozzle is horizontal and flow through the nozzle is adiabatic find the velocity of gas at the nozzle exit.
The power of a steam turbine in a thermal power plant is 60 MW. Water vapor enters the turbine at 3MPa pressure, 4000C temperature and 50 m / s speed, 10 kPa pressure, 0.9 dry degree and 200 m / s speed leaves the turbine. Considering the turbine as adiabatic; 1-Find the mass flow of steam 2-Find the turbine outlet cross-sectional area, its ratio (A2 / A1) to the inlet cross-sectional area.
steam at 11 MPa has a specific volume of 0.0196 m^3/kg , find the temperature, the enthalpy, and the internal energy.
Water vapor is at 0.5psia and 100. Assume the vapor respond to an ideal gas, use the steam table to find its specific volume, enthalpy and entropy (in SI units).
Optimus Prime carries a tank which contains 1000L of fresh water. A fuel for the autobots containing 2kg/L ofgasoline enters the tank at the rate of 4L/min and the mixture kept uniform by stirring. It was thendistributed to the autobots through a pipe that discharges at 3L/min. Find the amount of gasoline in thetank after 30 minutes
Please find the temperature AND the specific enthalpy of water at the compressor exit!Thank you in advance!
I have been working on this problem for a while but I need to figure out how to get the specific enthalpy when the refridgerant exits the system to find the mass flow rate of when the refridgerant exits the system but I don't know how to do this
1kg air is inside a 0.5m3 tank with pressure of 200 kpa. Find its temperature