Question 2 A network administrator configures the interface Gi7 on R1 with the command ip address 178.18.28.234 255.255.255.0. However, when the administrator issues the command show ip route , the routing table does not show the directly connected network. What is the possible cause of the problem? a) The interface GI7 has not been activated. b) No packets with a destination network of 178.18.28.0 have been sent to R1. | c) The configuration needs to be saved first. d) The subnet mask is incorrect for the IPV4 address.

Question 2 A network administrator configures the interface Gi7 on R1 with the command ip address 178.18.28.234 255.255.255.0. However, when the administrator issues the command show ip route , the routing table does not show the directly connected network. What is the possible cause of the problem? a) The interface GI7 has not been activated. b) No packets with a destination network of 178.18.28.0 have been sent to R1. | c) The configuration needs to be saved first. d) The subnet mask is incorrect for the IPV4 address.

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Task 2: Access Control Lists You will need to work out which interface on which router this needs to be applied to. Each ACL must work and be seen to work. Stop any IP address from 10.0.0.128 to 10.0.0.191 from pinging 123.123.123.123 - yet allow all other addresses Creating an ACL that meets the above 'selected' criteria Proving that a change of IP address, other than those allocated to the PC's also demonstrates the operation of the ACL. Also prove that you are still able to ping to 99.0.0.2 irrespective of device IP address
What is the required parameter to use while redistributing a route into EIGRP? A number of different elements, such as the exit interface and the IP address of the following hop, might have an effect on administrative distance.
An IP datagram must go through router 132.56.11.19. There are no otherrestrictions on the routers to be visited. Draw the IP options with their values.
Please written by computer source Write a Snort rule to detect a connection attempt on the telnet server which has an IP address 192.168.32.129 and generate alerts for packets with content ‘Telnet!’ directed to the server.
1 A user is executing a tracert to a remote device. At what point would a router, which is in the path to the destination device, stop forwarding the packet? a. when the router receives an ICMP Time Exceeded message b. when the RTT value reaches zero c. when the host responds with an ICMP Echo Reply message d. when the value in the TTL field reaches zero e. when the values of both the Echo Request and Echo Reply messages reach zero. the size of segments and the rate at er?
Use the passive-interface router configuration mode command to prevent the transmission of routing messages through a router interface but still allow that network to be advertised to other routers, as shown in for R1. Example R1 (config) # router ospf 0 R1(config-router)# passive-interface GigabitEthernet 0/0 R1(config-router)# end O True O False
IPV4 is a Connection oriented Protocol. * False True Broadcast is the process of sending a packet from one host to a selected group of hosts. * False True The prefix length is the number of bits in the address that gives the Host portion. " False True The metric is used to decide which route appears on the routing table. * True False The throughput value is greater than The Bandwidth Value. * True False O O O O
Write the commands to configure the interface FastEthernet0/0 with IP address 192.168.1.1 and subnet mask 255.255.255.0. Given that initially, the prompt is at user mode that is Router>. Show also the prompts. Giving detailed explanations.
In IEEE 802.11, two-way communication is used to authenticate an open system. In order to authenticate the client, the server must give the station ID (typically the MAC address). Response to the client's previous request is either a successful or failed authentication response from the access point/router. An error may arise if, for example, an AP/router configuration does not include the client's MAC address.In what ways is it advantageous to use this kind of authentication scheme?In what ways does this authentication technique have security vulnerabilities that might be mitigated?
Question 2 a A network administrator configures the interface GI7 on R1 with the command ip address 178.18.28.234 255.255.255.0. However, when the administrator issues the command show ip route, the routing table does not show the directly connected network. What is the possible cause of the problem? a) The interface Gi7 has not been activated. No packets with a destination network of 178.18.28.0 have been sent to R1. Od The configuration needs to be saved first. d) The subnet mask is incorrect for the IPV4 address. Question 3 Write the appropriate command from R1 to set a recursive static route to the network 2634:2::/64 Note (1) Do not abbreviate the command (2) If required, use interface labels as in topology (3) All devices use their device ID as their host ID R1 (config) ipvé route 2634:2:/64 2634:12::2
Metric is used to choose between multiple paths learned via the different protocols True False is the interface that allow you to include an IP subnet in the routing protocol without sending updates out of the interface * O Loopback interface Passive interface Physical Interface Ethernet interface In Equal Cost Multi Path, If you have one particular host that is talking to a web server, its traffic for that flow will be divided between routers. * False True
Host A sends a UDP datagram containing 8880 bytes of user data to host B over an Ethernet LAN. Ethernet frames may carry data up to 1500 bytes (i.e. MTU = 1500 bytes). Size of UDP header is 8 bytes and size of IP header is 20 bytes. There is no option field in IP header. How many total number of IP fragments will be transmitted and what will be the contents of offset field in the last fragment?