Question-2 A) The diffusion coefficient for glucose in water is 6.81x10*10 m²s' at 25 °C. The viscosity of water at 25 °C is 8.937x10“ kg.m's', and the density of glucose is 1.55 g.cm³. Calculate the molar mass of glucose.

Q: time needed for a glycine molecule

A:

Q: Fick’s Law of Diffusion states the rate of diffusion is directly proportional to a. the area…

A: Fick's Law describes the factors that impact diffusion of gas across membranes.   R=DA*∆pd   Where,…

Q: The thickness of the distance between any two marking on a buret is equivalent to about O 0.02 mL O…

A: The question is based on the concept of experimental Chemistry. we have to predict the distance…

Q: Which of the following is correct? Select one: O a. 153 kPa 1.55 x 10* atm O b. 5.99 x 10 in. Hg…

A:

Q: [a] The compound 1-iodododecane is a nonvolatile liquid with a density of 1.20g/mL. The density of…

A: Given:Density of 1-iodododecane=1.20 g/mL.Density of mercury=13.6 g/mL.Height of mercury column=749…

Q: 1. What is the specific gravity of N2 at 80°F and 745 mm Hg compared to air at 80°F and 745 mm Hg?

A:

Q: A certain liquid X has a normal boiling point of 146.10°C and a boiling point elevation constant…

A: Normal boiling point of the liquid, Tb° = 146.10 oC Elevated boiling point of the liquid,  Tb =…

Q: A 527.2g sample of water at 55.7  Celsius is taken to freezing point 0 Celsius. How much energy…

A: Given, the mass of water sample =527.2 graminitial temperature Ti =55.7 °Cfinal temperature Tf =0…

Q: In one experiment, 0.0995M HCl was used to analyze soda ash and the following data were obtained:…

A: A chemical reaction is symbolic representation of the conversion of substances to new substances. In…

Q: What is the boiling point (°C) of water on the top of Mount Everest where the atmospheric pressure…

A:

Q: draw an atomic/molecular level representation of what you think the solvent (H2O) looks like before…

A: Water is a polar molecule, which is liquid at standard temperature and pressure. Water molecules can…

Q: (a) Calculatethe concentration of mercury: (i)in g/L (microgram per liter), and (ii) in mol/L.(b)If…

A: a) Part per billion (ppb) concentration defines the microgram of solute dissolved in 1 L solvent. 1…

Q: 4. Explain THREE factors that influence the rate of diffusion.

A: 1) Extent of the concentration gradient: The greater the difference in concentration, the more rapid…

Q: 2-If you have 600 kJ of heat to spend, and you use it to melt lead, how many % ounce wheel weights…

A: Given: Heat energy required = 600 kJ weight of wheel = 1/4 ounces Initial temperature of wheel = 20…

Q: In a diffusion experiment, NH3 and HCl gases are released simultaneously at the left and right ends…

A: Rate of diffusion (r) :- The distance (l) traveled by the gas per unt time (t) is called rate of…

Q: What is the surface tension of water (i.e. the air--water interface) at a temperature of 25°C? (No,…

A: We need to give the value of surface tension of water (air-water interface) at a temp of 250C, to…

Q: What is the proper order of setting up a pendant drop apparatus using the following? Thank you :)

A:

Q: Define cohesion and adhesion, and how they can predict capillary action.

A: Adhesion can be defined as the sticking tendency of particles of different types of material.…

Q: spread to melt the ice on roads. How many grams of salt per 1000. g of ice is needed to make it…

A: Given: Mass of solvent=1000 g=1.0 kgFreezing point of solution(Tf)=-5 °C To find: Mass of NaCl

Q: What is the boiling point of the automobile radiator fluid prepared by mixing 1.11  L of ethylene…

A: Elevation in boiling point is colligative property that is depend on number of moles of solute but…

Q: Mass of flask + foil + rubberband: 78.637 gMass of flask + foil and rubberband+ unknown condensed…

A: ITEMS USED FOR EXPERIMENT: •Ring stand •Hot plate •125 mL Erlenmeyer flask •400 mL beaker •10 mL…

Q: Q.1/ For Simple Cubic shown in figure below, determine the fraction of the volume filled with hard…

A:

Q: 80 F3 What is the difference between passive transport and diffusion? Q F4 A) Passive transport does…

A: The above questions can be answered as follows

Q: Which answer best describes the redistribution of matter or energy when melting takes place? more…

A: The question can be answered by considering one of the important thermodynamic concept such as…

Q: ppm 2. In a certain polluted area, the partial pressure of NO gas was 8 pascal. The mixing ratio of…

A: Hii there, As there are multiple question posted. we are answering first question. If you need…

Q: In our chemistry laboratory class, the formula for surface tension given is y=mg/2(pi) x r x f…

A: Surface Tension is the magnitude of force exerted by the surface perpendicular to the line (of…

Q: Define the term Diffusion?

A: Diffusion is the movement of particles from a region of high concentration to a region of low…

Q: 11.What is the laboratory equipment that is best suited to accurately measure large volume of…

A: Note: According to our guidelines we are supposed to answer only one question. Kindly repost other…

Q: 2. How does the surface tension of water change if following substances will be added: a) propyl…

A: The solution is as follows:

Q: After performing an experiment to know if the ice cubes will sink or float in two separate jars…

A: An experiment was performed to know wheather the ice cubes will sink or float in two separate jars…

Q: 3. Is the dew point of a vapor-gas mixture the same variable as the vapor pressure?

A: The vapor pressure  is the pressure exerted by vapor of a substance on the surface of its condensed…

Q: 1. What would it mean if the melting point had a wide range in temperature rather than a narrow…

A: Hello. Since your question has multiple sub-parts, we will solve the first three subparts for you.…

Q: 7 questions for Properties of Liquids and IMF

A: There are various types of intermolecular forces such as hydrogen bonding, vanderwaal interaction,…

Q: explain standard curves in detail?

A:

Q: 12. Distinguish between filtration and centrifugation.

A: The main difference between strategies is the type of power used and the method of separation used.…

Q: Benzocaine 200 g Polyethylene glycol 400 600 g Polyethylene glycol 3350 ad 1000 g Polyethylene…

A: Bezocaine                         200g Polyethylene glycol 400   600g Polethylene glycol 3350  1000g…

Q: Calculate the normality of sulfuric acid has a density of 1.84 g/cm3 and is 95.0% (w/w) H2SO4. Mwt…

A:

Q: Normality of 20% (w/v) of H2SO4 is

A: Given  Acid       =  H2SO4 (w/v) %  =  20 %  Normality   =?  Molar mass of H2SO4  = ( 2 × 1 ) + 32 +…

Q: The diffusion coefficient of acetone in oxygen is equal to 8.75 10-6 the diffusion coefficient of…

A:

Q: A quantity of ice at 0oC is added to 64.3 grams of water in a glass at 55oC. What temperature will…

A: The ice is melting.  Hence it will need energy  And since the temperature of water is  55oC Hence…

Q: Capillary action is the process of water moving up plants, against gravity. Two different properties…

A:

Q: If 400 cc of 15% (v/v) acetic acid is mixed with 800 cc of 35% (v/v) acetic acid, what are the total…

A:

Q: Procedure: 1. Label the two glasses hot and cold with respect to their temperature to avoid…

A: As the kinetic energy increases the rate of diffusion increases. meanwhile rate of diffusion is…

Q: Which physical property of liquid is measured using stalagmometer?

A: Stalagmometer is based on the principle of drop method . The weight of the drop falling from the…

Q: ind the boiling point of a solution that is made from mixing 6.50 g of vanilin (MW= 153 g/mol) in…

A: Solution is made up of two components which are solute and solvent. Solute is present in the minor…

Q: What is the boiling point of the automobile radiator fluid prepared by mixing 1.00  L of ethylene…

A: Given that : The volume of ethylene glycol (solute)= 1.00 L The density of ethylene glycol = 1.114…

Q: 4. Calculate the height of a column of liquid glycerol (d 1.26 g/cm), in meters, required to exert…

A: The values are given as follows:

Q: Why do meltiing, freezing and boiling point varies and depends on a kind of matter? Not less than 6…

A: Matter can be defined as substance that possess definite mass and volume. Matter can be solid,…

Q: 500 grams of hot water at 90°C or

A: This is a multiple questions. According to Guidelines, we can solve only the first question of…