QUESTION 3 An inductor and a 330 ohm resistor are connected in series with a function generator. The current is 89.8mA RMS 5kHz. The reactive power is 3.04 var. Find the value of the inductance. O 12mH O 24mH O 6mH O 18mH

Q: Given: R = 2 kn D1:Si, re = 2 n, rR = 220 kn E= 10V R2 = 1.2 kn R3 = 6.8 kn D2: Si, rg = 5 0, = 560 ...

A:

Q: Compare the output voltages of half- wave rectifier, center-tapped full-wave rectifier and bridge re...

A:

Q: Doe Do Dor Do Vị V3 Figure 2: Simulating delays with inverters. Let each inverter have delay A, then...

A: Given the logic circuit as shown below: We need to construct this circuit using the MUX circuit. We...

Q: Calculate the inverse Fourier transform of the function, At) if F(@)= 200(jw+1) ja(jw+10)(2jw+4)

A:

Q: 42 () 2 H 16e'u(1)| 6 H 48(1)

A:

Q: What is the formula for temperature coefficient of resistance

A: Temperature coefficient of resistance(TCR) TCR is defined as the calculation of a relative change of...

Q: The switch opens at time t = 2 s. Before the switch opens, the system has reached steady state. Find...

A: Brief description: Note :  Please note that according to the guidelines of the company we supposed t...

Q: A wire of resistivity 2.8 x 10^-8 ohm. m and length 20-m must dissipate electrical energy at a rate ...

A: An object's resistance is determined by its shape and the material it is made of. The cylindrical re...

Q: Q5/A-Write the equation for the following abbreviation with diagram and truth table? X=(A OB)(COD)

A:

Q: A three-phase, four wire, ABC system with an a line voltage of 200 Volt, has three impedances of 25 ...

A:

Q: Apply DeMorgan's Theorem to the expression: [(A + B')(C + D')]'

A: In this question, The given expression [(A + B')(C + D')]' Solve the given expression Apply DeMorgan...

Q: Q9. Determine the voltmeter reading in Figure 2, if the 4.7 kN (R3) resistor is open. What is the re...

A: We will replace the voltmeters with the symbols for voltmeter. So, the simplified circuit will look ...

Q: 6. Find Vi and show that P, = Pabsorbed for the circuit below. %3D generated V1 1k +

A: Given circuit as,

Q: what unit is used to describe power in both AC and DC electricity?

A:

Q: A 24-V secondary of a transformer is connected to a half-wave rectifier and a 50 ohms load device.  ...

A: In this question,  A 24-V secondary of a transformer is connected to a half-wave rectifier and a 50 ...

Q: Calculate the value of Xc for the circuit. Please show

A: In this question we will find capacitive reactance from given voltage and current...

Q: Can somebody explain why the inductors are open circuit and the capacitor is short circuited. Given...

A: This question belongs to circuit theory. It is about behaviour of inductor and capacitor when voltag...

Q: A substation is supplying four towns whose peak loads are 10 MW, 5 MW, 8 MW, and 7 MW. The diversity...

A:

Q: An Armstrong modulator is used to generate FM which is suitable for FM broadcasting. You are given i...

A: GIVEN: Carrier frequency        fc1=27MHz              frequency deviation ∆f1=17KHz              fr...

Q: blow-dryer and a vacuum cleaner each operate with a voltage of 120 V. The current rating of the blow...

A:

Q: The magnetic structure shown below can be considered to have infinite permeability. (a) Find the sel...

A: Given, the permeability of core is infinity. So, the reluctance offered by the core is zero.    

Q: he dot product

A: Dot product- A.B=ABcosθ......(1)   Cross product- A×B=ABsinθ .........(2)  

Q: Q2/ Calculate the effective resistance of the following combination of resistances (Req) and the vol...

A: Effective Resistance Effective resistance in series is equal to the sum of the resistance. The recip...

Q: EA Tab j-Xab a bc b Ec -j- Xca Ea=220+j0 V, Eb=-110-j190.5 V, Ec=-110+j190.5 V. Rab-100 Ohms, Rbc=50...

A:

Q: sketch the waveform and show the

A:

Q: The voltages V1, V2, V3, and v4 are the node voltages corresponding to nodes 1, 2, 3, and 4 in the b...

A: In general, in a N node circuit, one of the nodes is chosen as reference or datum node, then it is p...

Q: Consider the following digital logic circuit: OR AND NOT AND R Give the Boolean expression that corr...

A:

Q: The load current in a system is 100 A. The short-circuit current for the smallest fault is 1000 A. A...

A: Given, Load current = 100 A Smallest fault current = 1000 A Relay current, IR=5 A

Q: What is the most common way to vary the output frequency of a crystal oscillator?

A: We can very the output frequency of a crystal oscillator by adding a capacitor across the crystal . ...

Q: 5. Use the circuit below to solve this problem. a) Find vo. b) Find vx. c) Find the power delivered ...

A:

Q: Design a synchronous counter using J-K flip-flop that can be used for an elevator system of a 7*th t...

A: The counter design has 7 stages so we need three JK flipflop to design the counter. The transition t...

Q: (a) Based on the relationship between the line and phase value of currents and voltage, show that th...

A:

Q: Q4- reffering to the circuit in figure 4 , if vs(t) : 12 cos 250t v , determine : Q4. Referring to t...

A: Since you have asked multiple questions in a single request, we will be answering only the first thr...

Q: (b) Figure Q3(b) shows a magnetic circuit with two different material. with a mean cross- sectional ...

A:

Q: Vs f = 150 Hz C 0.1 μF

A:

Q: (d) In a balanced three-phase wye-wye (Y-Y) system, V;< = 200210° Vrms. The load impedance per phase...

A:

Q: QUESTION 6 A motor with 15mH of inductance and an unknown internal resistance is connected to a 50V ...

A:

Q: Question Three! For the electrical network shown in Figure Q3. Find vo(t) for t>0. را م t = 0 3 H vo...

A: Transient analysis of an energy storage electrical circuit is very important.The energy storage circ...

Q: A 40 micro-farad capacitor is connected in series with a 40 ohm resistor. If the voltage is 220-V, w...

A:

Q: How an n type semiconductor can be made from an intrinsic semiconductor?

A:

Q: Calculate the hole and electron densities in a N-type germanium semiconductor at room temperature. T...

A: Given , conductivity σ = 500 S/cm μn =3800cm2/Vsμp = 1800 cm2/Vsni = 2.5x1013 /cm3 Now for the conce...

Q: 120 * 8F what is the T?' b. what is the voitage capactor apter 10 sec? c. How many a. time constants...

A:

Q: (c) For the circuit shown in Figure Q1(c), (i) Write the loop/mesh equations for loop i, loop iz and...

A:

Q: Q6. Calculate the output voltage. 120 kn 2.4 kn 120 μν

A:

Q: 0.8F t = 0 lit) 0.2F 8Ω 4i, 0.5F 20 V

A:

Q: Solve for Vc2. Assume Vbe13DVbe2%3 0.7 V * 2.5 V B1 = 100 Q1 10 kn B2 = 50 ww Q2 Vcz 1 kn ww

A:

Q: Q2 UTM UTM show that the active power input to a three-phase balance load is v3VIcose, where V and /...

A:

Q: 2ov Si4つ 1o. Determine V and I, for the netework shown. Ge 2.2KNZ 4V

A:

Q: The transformation ratio for the below transformer is 5:1. Assume 240Vrms is applied to the transfor...

A:

Q: (b) Figure QI(b) shows an AC circuit. Given the voltage, V, across the impedance Z, is 111.803 4 - 4...

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.