Question 3 For the network 129.120.0.0/16. How many 129.120.0.0/24 subnets exist? (numeric response) 1. How many bits are in the subnet portion? (numeric response) 2. Subnet number range is from: to: (only provide the third subnet octate) 3. How may bits are in the host portion? (numeric response) 4. Host address range is from: to: (only provide the fourth host octate)

Question 3 For the network 129.120.0.0/16. How many 129.120.0.0/24 subnets exist? (numeric response) 1. How many bits are in the subnet portion? (numeric response) 2. Subnet number range is from: to: (only provide the third subnet octate) 3. How may bits are in the host portion? (numeric response) 4. Host address range is from: to: (only provide the fourth host octate)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Given that the base address is FoH. 1. Create a new asm project “Lab2_Q1.asm". Assume that port A of 8255A PPI is connected to 8085. Write assembly code to send the value of FFH to FoH. Enter a delay of 2 ms for each transmission.
The following data are transmitted in a serial communication system (P is the parity bit). What parity is being used in each case? a. ABCDEFGHP = 010000101 b. ABCDEFGHP = 011000101 c. ABCDP = 01101 d. ABCDEP = 101011 e. ABCDEP = 111011
1.how does an additional 2 bits affect the SQNR ?
. The following is configured on a router Router(config)# interface g0/0.10 Router(config-subif)# encapsulation dot1Q 20 Router(config-subif)# ip address 192.168.30.1 255.255.255.0 A packet is sent from the router out the subinterface to a trunk port on a switch. The switch will treat the packet as if it is on what VLAN? . The following is configured on a router Router(config)# interface g0/0.10 Router(config-subif)# encapsulation dot1Q 20 Router(config-subif)# ip address 192.168.30.1 255.255.255.0 A packet is sent from the router out the subinterface to a trunk port on a switch. The switch will treat the packet as if it is on what VLAN? VLAN 20 VLAN 30 VLAN 10 The native VLAN
Q32) The process of code conversion of the output Of PCM encoder into codes that are suitable for the transmission lines is called a. Line coding b. Mixing c. source coding d. Filtering This multiple choice question from DIGITAL COMMUNICATIONS course.just write for me the final answer.
State a bit rate and maximum number of channels in T-1 and T-3 telephone TDM system.
(c) Write a VHDL code to implement the above counter using conditional statement "case". You need not necessarily use a synchronous load mechanism.
For the following sets of codewords, i. Please give the appropriate (n,k,d) designation where n is the number of bits in each codeword, k is the number of message bits transmitted by each codeword and d is the minimum Hamming distance between codewords. ii. Give the code rate iii. How many bit errors can each code correct? Detect? a. {000000, 110110, 110001, 000111} b. {0000, 1111, 0011, 1100} c. {0000, 1111}
6. Calculate the check bits (find the codeword) for the bit-pattern (100101011), usingHamming code error correction method.
A code 1011 need to be send to the receiver. Using, Hamming code find out the code-word and the mechanism to check the corrected data. (Assumptions: Right to Left with Even Parity)
WR* = 1 for an I/O read bus operation. True False
Calculate the bit rate of the base channel of T1 carrier system.