QUESTION 5 Find the unknown quantities for the circuit below using the information provided. E E = IT = RT = R3 = 12 = 13= +₁ RT 12 A 6Ω units units units units units units 11₂ 9Ω R P = 12 W

Q: 4. Two 6600/250-V transformers have the following short-circuit characteristics : Applied voltage…

A:

Q: Given the difference equation where x(k+ 2) + 5x(k + 1) + 4x(k) = e(k) 1, 0, e(k)= x(0) = 0 x(1) =…

A: Given,The difference equation is,xk+2+5xk+1+4xk=ek,Where,ek=1,k=00,otherwise.x0=0.x1=-1.

Q: In a AC voltage waveform: v(t) = 170 cos( 60*2*pi*t +pi/2) volts. Note: the given cosine function…

A: Given Data is  v(t) = 170 cos( 60*2*pi*t +pi/2) volts.   Now To find the  a.) frequency of v(t) in…

Q: 2. A 20 kVA, 2500/250 V, 50Hz, single-phase transformer gave the following test result: Open-circuit…

A: In this question We need to determine the approximately data in high voltage side and low voltage…

Q: 4. If the system shown in Fig.04 is an LTI system, then (a) Find out the expression of and then…

A: Given: A block diagram for an LTI system,    To find: a) Impulse response h(t) and sketch it.  b)…

Q: What are the advantages & Disadvantages of Hydroelectric Power Plant ?

A: Hydroelectric power plant : Hydroelectric power plant is used to produce the electricity from…

Q: Question-2 Consider the following circuit, and given: Tin (s) Iin (s) = 1) ↑ 2s-1 (s + 1)(s² +25)…

A: In this question We need to determine the current Iout(s)  We are solving this problem using the…

Q: Design a voltage divider bias circuit to get the Q point ICQ = 3mA and VCEQ = 7V

A:

Q: A 220 kV, 50 Hz, three-phase transmission line is 60 km long. The resistance per phase is 0.15…

A:

Q: 1. Six generators are operating in parallel supply a total current of 3500 A. Each machine has a…

A: In this question we need to find the load current share by each generator.

Q: 4. In January a facility has a peak demand of 525 kW and used 190,000 kWh. What was the facility's…

A: In this question We need to choose the correct option In this question we need to determine the load…

Q: Consider the vector F= RR. What is the y component of this vector? 01. R cos sin q O2. R sin cos q O…

A:

Q: Question-1 Consider the following circuit, and given: Tout (s) = = Vin(t) Vin(t) = (-2e-t cos(5t) +…

A: In this question We need to output current in the time domain.  We know Inverse Laplace transform of…

Q: c) Determine and sketch the even and odd parts of: x(t) = 4 µ(t-1), where μ() is the unit step…

A: We need to find out the even and odd signal for given signal .

Q: Find the value of VTh- Express your answer in volts to three significant figures using angle…

A: The open circuit voltage can be calculated by using the nodal analysis and the equivalent resistance…

Q: A series RIC circuit consisting of a 25 ohms resistor, 0.8 henry inductor, and a 8.8F capacitor is…

A: In these questions We need to determine the all unknown parameters.  We know Inductive Reactance XL…

Q: the circuit below the initial current in the inductor is zero (t0, the resistance seens by the…

A:

Q: Two Parts: Do for a high-pass filter and low-pass filter, the resistor has a value of 6.8 kΩ and the…

A: In this question we need to find the phase shift of the filter.

Q: Consider the following circuit, and given: Tout (S) = Vin(t) Vin(t)= (-2e-t cos(5t) + 5e-3t…

A: In this question We need to determine the current iout (t) of the given circuit.  We know  Inverse…

Q: Calculate: a) the reactance of the inductor, XL, b) the reactance of the capacitor, XC, c) the…

A: here we have to find the reactance of the inductor and capacitor and impedance of the circuit.

Q: Design an 8 to 1 MUX using a 4 to 1

A:

Q: An 8-pole single induction motor is running at 690 rpm. What is its slip with respect to forward and…

A: Given--= A 8-pole single phase induction motor Number of poles, P=8 Motor speed, Nr=690 rpm To Find-…

Q: Question 4 What is the rms value of current i(t) = Imcos(wt+0;)? O IM√2 O IM√3 O IM slash√2 O IM…

A:

Q: Get the value and show the direction of the current using conventional flow.

A: The current will flow from higher potential to lower potential and based on that the direction of…

Q: Find the current in the three branches.

A:

Q: 6. A 2,000-kVA transformer (4) is connected in parallel with a 4,000-kVA transformer (B) to supply a…

A:

Q: Make a truth table using the circuit

A: The boolean expression for the given logic circuit can be obtained by finding the individual gate…

Q: Question 2 i-2A What is v1? 100 Σα 30 Ω Μ ΤΕ W 10 Ω 127 6Ω Μ U₂

A: Given data, Circuit is, Current, i=2 A.

Q: How long does it take to fully charge a 1 nanoFarad capacitor through a 10K resistor?

A:

Q: Determine ait vector perpendicular to the both vectors A=4i +5j- 2k and B = -5i + 5k. | 101 = (…

A: We have to find unit vector  U that is  perpendicular to A and B.

Q: Given a circuit with one 9V battery and with its negative terminal connected to ground. The two…

A: The circuit diagram can formed based on the given condition and then the required current can be…

Q: The value for a ZnO varistor is 15 and k₁=9.3 x 10-38, the potential difference and current being…

A: Given data α=15 ki=9.3×10-38 To find out We have to determine the potential across the varistor for…

Q: Determine the dependent voltage Vx where V=7, R1=8, R2=8, and R3=5. V + R1 R2 ww 2Vx R3

A: Note:-Taking unit of resistance as Ohms and that of voltage source as Volts.

Q: A conductor of length 0.5 m is moving with the speed of 8 m/s in a perpendicular magnetic flux…

A:

Q: 9.25 Determine the minimum states of the finite-state machine described by the state table in Figure…

A:

Q: Two transformers A and B are connected in parallel to supply

A: Given Data: Two transformers A and B are connected in parallel The load Impedance is ZLoad=2+j1.5Ω…

Q: 1. Two single-phase transformers A and B of equal voltage ratio are running in parallel and…

A:

Q: 3- A 1 phase, 100 kVA, 11000/2200V, 60Hz transformer has the following parameters. RHV=6.02 RLV =…

A: Given data Rating of the single-phase transformer; 100 KVA, 11000/2200 V, 60 Hz Parameters of the…

Q: (b) In the initial condition, K is closed, and a steady state is reached in the network of below…

A:

Q: The current in the circuit in (Figure 1) is known to be -8000t io = 50e (cos 6000t + 2 sin 6000t) mA…

A:

Q: 1- Write the truth table and draw the logical circuit for the following logical expressions: a. X =…

A: it is asked to write truth table and to draw the logical circuit for given logical expressions

Q: 2. (1) How do you define the skin depth of an electromagnetic wave in a conductor? (2) Compare the…

A:

Q: In regard to using analog signals with PLC's, what is a transmitter? O converts physical variables…

A: Solution 2. In industrial control systems, PLCs are frequently used to communicate with transmitters…

Q: x(1) 3.16. Consider the LTI system of Figure P3.16. (a) Express the system impulse response as a…

A:

Q: A) e4t-e-2t B) 2e4t - 2e-2t C) e4t-e2t D) 2e-4-2e2t

A: Given, Fs=6s2-2s-8ft=?

Q: 10.73. (a) What are the voltages at all the nodes in the difference amplifier in Fig. P10.72 if V₂ =…

A: We need to find out the voltage and current for given operational amplifier circuit.

Q: Suppose r0= OXFOFOFOFO and rl = 0x12345678. Find the value of every register 10-12 after the…

A:

Q: D(1) v(1) 10 V -10 V Figure P7.85 LH N (b) 4₂(1) SRΩ r(s) Notes on entering solution: Enter your…

A:

Q: Design a collector feedback bias circuit to get the Q point ICQ = 1mA and VCEQ = 6V

A: Given,For the collector feedback bias circuit,ICQ = 1mA,and,VCEQ = 6V.

Q: maximum power

A: