R1 R3 4 ohms 1 ohm ELECTRONSS HUB 2 ohms В1 28v 7 v=B2 R2 Solve the circuit using Kirchhoff's Rules. Show all relevant work, but you do not need to show the work to solve the system of equations. Just make sure to show the three equations. Be sure to clearly label the currents (I1, 12 , etc.). Once you find all three currents, find the current, voltage drop, and power dissipated through each resistor. Be sure to include units on every answer. R1 R2 R3 V P ||

R1 R3 4 ohms 1 ohm ELECTRONSS HUB 2 ohms В1 28v 7 v=B2 R2 Solve the circuit using Kirchhoff's Rules. Show all relevant work, but you do not need to show the work to solve the system of equations. Just make sure to show the three equations. Be sure to clearly label the currents (I1, 12 , etc.). Once you find all three currents, find the current, voltage drop, and power dissipated through each resistor. Be sure to include units on every answer. R1 R2 R3 V P ||

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Solve the following: in light bulb has a resistance of 150 when lighted. How much current will flow through it when connected acro 220 V, its normal operating voltage? Draw the circuit schematic diseam>Fin 2. Find the potential difference (Em) Polisher connected wi 3. A 12 battery operates a 15 ohms digital scale for 5.2 minutes. a) Find the current flowing b) the charges erred with the given time. 4. What is the resistance of a conductor at 50° C if its resistance at 0°C is 1 ohm and the temperature coefficient of resistance of 9.8 x 10-³/°C 6. Complete the table: 5. A silver wire has a resistance of 2.3 at 0°C and a temperature coefficient of resistance of 3.75 x 10-³/°C. What is final temperature when the final resistance is 3.8 ohms. ? V, Volts Electric Circuit and Ohm's Law 8 volts 20 volts ca elecun it with current flowing at 18 ampere and a floor rice of 12 Q? 10 Volts 36 volts I, Ampere 2.8 mA 40A 130mA R, ohms 156 02 25 ΚΩ 450 ΚΩ
Determine the currents ?1, ?2, and ?3 shown below using Kirchhoff's Laws. Let ε1=10.0 V, ε2= 21.0 V, R1=15Ω, and R2= 23.5 Ω. Pay careful attention to your signs! If you calculate a current to be negative, then include the negative sign in your answer. (a) ?1: A ( ± 0.01 A) (b) ?2: A ( ± 0.01 A) (c) ?3: A ( ± 0.01 A) (d) Is current ?2I2 flowing vertically upward or vertically downward through the wire the above diagram? (Note that this may or may not correspond to the downward arrow that has been drawn.) A. Upward B. Downward
1. Fill in the table for this circuit. Show your work and then check your answer with PHET V R P R1 R2 R3 TOTAL 14 V 780 2 IR R3 3.3 k2 R2 1.5 k2
Imagine building a circuit using a perfect insulator (a device of infinite resistance, which allows no current flow) in place of the carbon resistor a. Would the plot of the data be a straight line? b. If yes, what would the slope of that line be? If no, what shape would the line be?
Solve the following problems. identify the given, the unknown, give the formula to be used, show the solution, and express the final answer into 2 decimal places. You can use a separate sheet of paper in solving the problem. 1. Find the current along a circuit if the voltage is 110 V with a resistance of 22 Ohms. and Given. Unknown: and Unknown: 3. Calculate for the voltage supplied to a load if the current is 2.5 A and the resistance is 10.80 Ohms. and Given: Unknown: Solution: Performance Task Formula: Solution: Final Answer: 2. What is the resistance of a bulb with a current of 0.72 A that is connected to a 110 V supply. Given: Formula: Solution: Final Answer: Formula: Final Answer:
Consider the circuit shown below. The terminal voltage of the battery is V = 18 V [note]. + R1 = 4.00 Ω V = = 18.00 V Hint R3 = 4.00 a. Find the equivalent resistance of the circuit. Req Ω. b. Find the current through each resistor. Give your answer as a comma-separated list in unit of ampere. currents through R₁, R2, and R3 (in ampere, in order): - R₂ = 1.00 c. Find the potential drop across each resistor. Give your answer as a comma-separated list in unit of volt, as an absolute value. potential drops across R₁, R₂, and R3 (in volt, in order): d. Find the power dissipated by each resistor. Give your answer as a comma-separated list in unit of watt. power dissipated by R₁, R2, and R3 (in watt, in order): e. Find the total power supplied by the battery. W. Pbattery =
Part B. Finding the PD Directions: Solve the following problems. Write your answer on a clean sheet of paper. Show your solutions. 1. To carry how much charge between two points having potential difference equal to 220 V, 1760 J of work is done? Ans. 8 C 2. The EMF of a cell falls from 3 volts to 2.8 volts when its terminals are joined to an electrical load of 4 Ohms. Calculate the internal resistance of the cell.
Reclung.c A on ri gle Figure 1 2. The circuit shown above is constructed with two 6.0 V batteries and three resistors with the values shown. The currents 1₁, 12, and 13 in each branch of the circuit are indicated. 2 GEOMETRY AND TRIGONOMETRY Circle A = ²² C = 2πr Cy.inder bh - re Rectangular Solid Vlh Sphere 1. Using Kirchhoff's rules, write, but DO NOT SOLVE, equations that can be used to solve for the current in each resistor. ii. Calculate the current in the 200 9 resistor. iii. Calculate the power dissipated by the 200 2 resistor. V = ar²l S.. Figure 2 The two 6.0 V batteries are replaced with a battery with voltage & and a resistor of resistance 50 2, as shown above. The voltmeter V shows that the voltage across the 200 £2 resistor is 4.4 V. (b) Calculate the current through the 50 2 resistor. (c) Calculate the voltage & of the battery. V=² S = 4; 7² Rig Triangle 2 +6² = c² sin = COS== tan 8 = OJA b C 2m. a b 6.0 V 7,4 & A - area C=circumference h-hei £= le L W = IUL r=fuu.0…
50 Ω ww mit this before the beginning of the lab period. Show all work. 1. In the circuit to the right, label the currents in each branch. Then write three equations using Kirchhoff's rules that can be used to find the currents through each branch. Solve for the current through each resistor and each battery. 115 Ω 35 V Hil 95V 80V 6052 www 350 2. If you have a maximum voltage of 9.6V, determine what resistance should be used in order to get a current of no more than 200 mA. Is this a maximum or minimum resistance?
Part a: what is the equivalent capacitance of the circuit shown above? Give your answer in microfarads. part b: what is the charge on the 4.0 mu*F capacity? Give your answer in microcoulombs par t c:What is the voltage on the 4mu*F capacitor ? Give your answer in Volts part c What is the voltage on the 2.0uF capacitor? Give your answer in Volts part d :
You want to determine the emf & and internal resistance r of a battery you found, as well as the resistance R of a resistor, so you connect a voltmeter and an ammeter (both assumed to be ideal) as shown in the figure on the right. a) What is the resistance of an ideal voltmeter? b) What is the resistance of an ideal ammeter? When the switch is open, the voltmeter shows a reading of V₁ = 12 V and the ammeter shows a reading of I₁ = 0 A. You close the switch and the readings change to V₂ = 9 V and I₂ = 3 A. c) What is the circuit resistance R? d) What are the emf & and internal resistance r of the battery? r E R A
homework ch2.docx Solve these equations to find currentI,. B ww 12 2 ww D Solution:I,= 32.345 A 10 2 isa 4 V 15 2 H H.W. 2.6: For Figure below shows a d.c. two source network; the branch currents I,and I, are as marked in it. Write, using Kirchhoff's laws, two independent simultaneous equations in I, and I,. Solve these to find I, Solution:I, = 0.0705 A 4 ww ww 50 102 +6V