R134a enters a reversible adiabatic compressor as a saturated vapor at 10 C. The exit of the compressor is 5 bar. The compressor is using 5 kW of power. Neglecting kinetic and potential energy a. Draw the process curve on a T-s diagram. Show the saturation dome and label the inlet and exit states b. Find the enthalpy and entropy at the inlet c. Find the enthalpy at the exit d. Compute the mass flow rate e. Compute the rate of entropy generation

R134a enters a reversible adiabatic compressor as a saturated vapor at 10 C. The exit of the compressor is 5 bar. The compressor is using 5 kW of power. Neglecting kinetic and potential energy a. Draw the process curve on a T-s diagram. Show the saturation dome and label the inlet and exit states b. Find the enthalpy and entropy at the inlet c. Find the enthalpy at the exit d. Compute the mass flow rate e. Compute the rate of entropy generation

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

4. Air at a temperature of 500 0C is compressed at a constant pressure of 1.2MPa from a volume of 2 m3 to a volume of 0.4m3 . If the initial internal energy decrease is 4820 KJ, find a. The work done during the reversible compression b. The heat transferred c. The change of enthalpy d. The average specific heat at constant pressure
Q9: Steam at 110 bar has a specific volume of 0.0196 m3/kg, find the temperature, the enthalpy and the internal energy.
(1) An adiabatic compressor is used to bring saturated water vapor at 1 MPa up to 17.5 MPa, where the actual exit temperature is 650 °C. Let To = 25 °C, po= 100 kPa. %3D %3D (i) (ii) (iii) (iv) Draw the schematic of the problem Determine specific volume, enthalpy, and entropy at the inlet un Determine the specific volume, enthalpy, an entropy at the exit Blfie What is the change of exergy between the exit and the inlet of the compressor (v) (vi) (vii) (viii) What is the 2nd Law efficiency or the exergetic efficiency of the compressor What is the work supplied to the What is the minimum work the compressor requires What is the exergy destroyed in the turbine compressor.
EXERCISES ON PROPERTIES OF STEAM 3). Ten kg of water 45 °C is heated at a constant pressure of 10 bar until it becomes superheated vapour at 300°C. Find the change in volume, enthalpy, internal energy and entropy.
At the start of the compression process in the reciprocating compressor of refrigeration plant the refrigerant is at 1.5 bar, dry saturated. At the end of the compression process, which is according to a reversible polytropic law pv-C., The pressure is 6.5 bar. Using the properties of refrigerant given as table, interpolating where necessary, calculate. • The change of specific entropy during the • The degree of superheat of refrigerant after compression. process.
From a state defined 300 psia, 100 cu. ft and 245 deg. F, Helium undergoes an Isentropic process to 0.5 psig. Find: a. V2 and T2 b. Change in Enthalpy and Internal Energy c. Heat and Change in Entropy.
1. Find enthalpy if 5kg of certain gas go through a reversible non flow that has constantpressure process from initial volume 2.129m3 and pressure of 700 kPa to a state where T2 = 550°C. A certain gas has R= 350J/kg-K and Cv = 0.94 kJ/kg-Ka. 731.9675kJ b. 813.8610kJ c. 878.3610kJ d. 891.2610kJ
4. A) Wet steam at 200 deg C has a specific enthalpy of 2300 kJ/kg (in the 2 phase region). Determine the quality and specific volume and specific entropy of the mixture. B) Calculate change in entropy of an ideal gas that expands freely to twice its volume, assume isothermal reversible process. What is the work done in the process 2
K) that undergo an K-K 13. There are 1.5 Kgof a gas where K = 1.3 and R = 0.38 tsochoric process from pi = 0.552 MPa, t, = 58.5°C top2 = 1.66 MPa. During the process, there added 100 KJ of heat. Compute the heat transferred, change of internal energy and the change of entropy. %3D
16. A perfect gas has a valuen of R = 58.8 ft-lb/lb-R and k = 1.26. IF 20 %3D BTU are added to 5 lb of this gas at constant volume when the initial temperature is 90°F, find the final temperature, change in enthalpy, change in entropy, change in internal energy, and work non flow.
A room is divided by a barrier into two sections. One side of the room (state 1) has a volume of 1000 ft^3 and is initially at 70F, 50 psi and the other side of the barrier (state 2) has 200 lbm of air and is initially at 300F, 14.696 psi. The divider is removed and the air mixes until it reaches equilibrium (state 3). Find the final temperature and pressure of the room. You can assume removing the divider has a negligible effect on the air.
1.Five kilogram of steam is initially at 1MPa and y=40% inside the piston cylinder. There is a 50C superheat introduced in steam isopiestically. Find the change of entropy of the steam.